Digital Watchdog DWC-PV20FMW Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Digital Watchdog DWC-PV20FMW (2 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
DWC-PV20FMW
Flush mount for multi-sensor vari-focal cameras
Quick Start Guide
Tel: +1 (866) 446-3595 / (813) 888-9555
Technical Support Hours: 9:00AM – 8:00PM EST, Monday through Friday
digital-watchdog.com
NOTE: Download all your support materials and tools in one place
1. Go to: http://www.digital-watchdog.com/resources
2. Search your product by entering the part number in the search bar. Results ‘Search by Product’
for applicable part numbers will populate automatically based on the part number you enter.
3. Click ‘Search’. All supported materials, including manuals
and quick start guide (QSGs) will appear in the results.
WHAT’S IN THE BOX
Camera Mounting Screws 2 Quick Setup Guide 1
Safety Wire 2 Mounting Template 1
Eye Bolt 2
Quick Start Guide
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
1 Before the installation, remove the magnetic cover from
the flush mount.
2 Using the mounting template mark and drill the
necessary holes in the mounting surface.
3 Place the eye bolt in the center of the flush mount base.
Connect the rst safety wire between the eye bolt and
the mounting surface.
4
Adjust the 3-point in-ceiling wing using a screwdriver. Twist the screws to tighten and
expand until theush mount is secured to the mounting surface.
5
Ax the safety wire at the bottom of theush mount’s base. Connect the other side of
the safety wire to the base of the camera.
6
To mount the camera to the mounting accessory, remove
the dome from the camera base using the wrench included
with the camera.
NOTE: Do not touch the lenses when handling the camera modules.
7
Pass wires through the flush mount base and make all necessary connections.
8
Secure the camera to the flush mount. Align the Tlines on the side of the camera with
the lock and unlock icons on theush mount as seen in the image below. Rotate the
camera clockwise to lock it into position. Use the two included screws to secure the
camera to the flush mount.
9
Adjust the camera modulesposition and angle and place the dome cover on the
camera. Secure the dome cover to the camera base using the screws included with
the camera. See the camera’s QSG for more information. Complete the installation by
reattaching the magnetic cover over the camera dome.
Quick Start Guide
INSTALLATION
Rev: 08/21
3-point ceiling
wings
Camera module
Camera dome cover
Flush mount
Flush mount base


Produktspezifikationen

Marke: Digital Watchdog
Kategorie: Nicht kategorisiert
Modell: DWC-PV20FMW

Brauchst du Hilfe?

Wenn Sie Hilfe mit Digital Watchdog DWC-PV20FMW benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Digital Watchdog

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-