Hager EE870 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Hager EE870 (4 Seiten) in der Kategorie Bewegungsmelder. Dieser Bedienungsanleitung war fĂŒr 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
+ 90°/- 30°
+/-80°
Description
Detection zone
Installation
Setting
Shutters
1
2
Connection by PIN system
(4 plug-in pins)
α = 220/360°
The optimal height of installation is 2.5 m.
The detection field must remain free.
2,5 m
LED A LED B
Accessories for corner  xing
8 m 16 m Ø 6 m
16 m
4 m
Plate for wall îœș xing
Swivelling detection head
Vertical adjustment
Setting potentiometers
Fixed time
(length of time
of lighting)
Luminosity Sensitivity
(modification
of the range)
Caution!
This device is to be installed only by a professional
electrician îœș tter according to local applicable
installation standards.
Do not plug in or unplug this product when it is live.
DETECTOR 220/360°
EE870 White
EE871 Charcoal
ACCESSORY FOR
CORNER FIXING
EE855 White
EE856 Charcoal
6E7582.C1
6E7582.C
EE87.
izMotion detectors comfort 220/360°
For use in Australia and New Zealand
Operating precautions
In order to obtain optimal detection conditions, it is recommended that the following advice:
- the detection is sensitive to solar radiation and bad weather. Detection performance is optimal up to
35 °C and above 40 °C.
- It is preferable to maintain Ă  distance of 1 m. between a light source and the detector.
When mounting on a box, make sure that you do not distort the wall plate through excessive tightening
of the screws.
Montage
Surface-mounting or ceiling-mounted :
- îœșx the wall plate using the screws provided
- connect the wall plate terminal block (see cabling plans in annex)
- fully insert the detector on the wall plate
- tighten the screws to ensure the product is sealed.
For corner îœșxing, the wall plate is to be îœșxed between the accessory and the detector.
Cable entry (breakable partitions) are possible:
- by the back (box mounting) or by the bottom.
LN S'
60 mm
N
L
S'
Ateha raceways
ref. ATA 12200
or ATA 63000
Wiring and connections (provide installation with xed wiring)
Action Settings Potentiometer
Use Auto settings
(factory) or set by
the remote control
to switch the light
automatically for a
given time.
Auto Settings
Put the Lux potentiometer on
“auto test”.
The settings are predefined:
Lux = o
(operating at night only)
time = 3 min,
sensitivity = max.
Remote control settings
(Manual Settings inhibited).
Automatically switch
on the light for a
defined time.
Installer settings
Control a timer, a bell
etc.
Impuls V
Auto settings are usable with
time = 1s. (cannot be changed)
Test and validate the
detection zone.
Test mode
Move the potentiometer to 2
“auto test”. On this position, the
remote control can be used.
Adjust the sensitivity. Allows setting the range
to avoid disturbance.
“Normal” operation (on/off)
The lighting is activated whenever the level of
luminosity deîœșned by the potentiometer 2 is
judged to be insufîœșcient and a movement is
detected.
After detection, the light stays on for the length
of time predeîœșned by the potentiometer 1.
The îœșxed timing is reset after each detection.
Please note: when the potentiometer is on “auto
test”, the settings are predeîœșned.
Control by timer
An impulse is generated every 10 s whenever the
level of luminosity is judged to be insufîœșcient and
a movement is detected when the potentiometer
1 is on .V
This pulse mode is not suitable for connections to
power devices (except at low power loads).
Using the remote control (option,
ref. EE806)
The detector receives instructions from the remote
control when the Lux potentiometer is on the “auto
test” position.
If the potentiometer is put on another value, the
local setting resumes.
The LED B of the detector lights up to confirm the
signal with the remote control.
It flashes quickly for 2 s when an instruction is
received and 5 s for a reset.
When an instruction is not authorised, the LED
lights up for 1 s.
The available settings are:
- fixed time
- level of luminosity
- sensitivity
- on / off
- holidays (simulation of presence)
- activation of the detection A.
Testing and validating
the detection zone
Put the potentiometer on Test mode and if 2
necessary, use the shutters to define the detection
zone.
The Test mode is available for 3 min. Every
movement detected switches on the light for 1s.
After 3 min without detection of movement, the
product returns to normal operation.
Limiting the detection zone
You can limit the detection zone by using the
shutters provided or by tilting the head.
Product presentation
and operating principles
This detector allows automatic control of a
light source for a deîœșned length of time when a
movement is detected in the surveillance zone.
The LED A indicates a movement. It is inhibited by
default except in Test mode.
Settings and Test
The detectors have 2 modes of operation:
Fixed time and Control by timer.
Power supply
The detector switches the light on for 40 s.
After 40 s, it activates the Normal mode.
6E7582.C2
6E7582.C3
+ 90°/- 30°
+/-80°
Beschrijving
Detectiezone
Installatie
Instelling
Afdekplaten
1
2
Aansluiting d.m.v. PEN-systeem
(4 insteekbare pennen)
α = 220/360°
De optimale montagehoogte bedraagt 2,5 m.
Het detectieveld moet vrij zijn.
2,5 m
LED A LED B
Toebehoren voor hoekmontage
8 m 16 m Ø 6 m
16 m
4 m
6E7582.C
EE87.
ziBewegingsmelders comfort
220/360°
Wandmontageplaat
Draaibare detectiekop
Verticale instelling
Instelpotentiometers
Lichtsterkte Gevoeligheid
(wijziging van het
bereik)
Tijdvertraging
(verlichtingsduur)
Opgelet!
Het toestel mag alleen door een elektroinstallateur
worden geĂŻnstalleerd volgens de installatienormen
die van toepassing zijn in het land.
De contactpennen van het product niet vast- of
loskoppelen wanneer het onder spanning staat.
220/360°-
BEWEGINGSMELDER
EE870 Wit
EE871 Zwart
TOEBEHOREN VOOR
HOEKMONTAGE
EE855 Wit
EE856 Zwart


Produktspezifikationen

Marke: Hager
Kategorie: Bewegungsmelder
Modell: EE870

Brauchst du Hilfe?

Wenn Sie Hilfe mit Hager EE870 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Bewegungsmelder Hager

Bedienungsanleitung Bewegungsmelder

Neueste Bedienungsanleitung fĂŒr -Kategorien-