Hitec NEON_SS_FM Bedienungsanleitung
Hitec
Funksteuerung
NEON_SS_FM
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Hitec NEON_SS_FM (8 Seiten) in der Kategorie Funksteuerung. Dieser Bedienungsanleitung war für 30 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/8
www.hitecrcd.com
NEON-SS FM
INSTRUCTION MANUAL
FM
2
1Introduction
Congratulations, you now own one of the most unique and revolutionary radio control systems in the world.
The Neon 3 was created for the beginner and seasoned R/C enthusiast to grow with your needs and skill level.
The basic Neon can be upgraded with a variety of features like;
- A 4th channel three position switch - Dual Rates on channels 1 and 2
- ATV's on channel 1, 2 and 3 - A trainer port and switch package
Any way you choose to customize your Neon, you are sure to be satisfied with the performance on this unique system.
Table of contents
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
1. Introduction
2. Features and Specifications
Transmitter
Options
3. System Components
Receiver
Servo (Standard version, Micro version)
Accessories, all systems
4. Set-up and Operation
Transmitter
Reading the LED Battery Indicators
Recharging Nicad batteries
Installing Transmitter Batteries
To install or change the batteries in your NEON
Transmitter antenna
Elevon/V-tail mix
Servo Reversing
Gimbal stick length adjustment
Gimble stick tension adjustment
Throttle Function
5. Installation of Receiver and Servos
Turning on your system
Servo trim settings
Range check
Checking servo operation
6. NEON Transmitter Option Installation Directions
Trainer Port and Switch Installation
ATV Board Installation
Dual Rate Switch Installation
4th Channel Three Position Switch Accessory Installation
Transmitter
- Single Stick 3 channel, (upgradeable to
4 channel) FM proportional system
- Dual axis precision gimbal
- Adjustable gimbal stick length
- Adjustable gimbal stick tension
- 3 LED battery status indicators
- Charging jack for optional internal Nicad battery
- Servo reversing for all channels
- Elevon or V-tail mixing function
- Proportional 3rd. channel slide switch
- Channel 1 and 2 trim levers
Options
- Channel 4 three position switch, part # 54301
- Channel 1,2 and 3 ATV function, part # 54302
- Trainer plug and switch, part # 54303
- Channel 1 and 2 Dual Rate function part # 54304
(Must use optional part# 54304, ATV function in
addition to this option)
2Features and Specifications
- Speed : .11(4.8V) /.10sec(6.0V)
- Torque : 2.6(kg/cm) / 36oz at 4.8V
3.0(kg/cm) / 41oz at 6.0V
-Size : 30x12x30(mm)/1.2x0.47x1.2(inch)
- Weight : .58oz/16.6g
3
3 System Components
Receiver
Currently there are two popular receivers used in the Neon 3 packages.
Deluxe Version includes : Electron 6 channel Dual Conversion 6 channel FM receiver
Micro version includes : HFS-04MG 4 channel Single Conversion 4 channel FM receiver
Servo
Currently there are two popular servos choices offered in the Neon 3 packages.
Deluxe Version includes : (2) HS-81 micro servos
Micro version includes :(2) HS-55 sub-micro servos
Accessories
One CG-25 or CG-22A overnight wall charger, part # 43025 or # 43022
One Switch harness, part # 54403
One AAA receiver battery box, part # 54402
4Set-up and Operation
Transmitter
Opening the case
The case of your Neon is unique because it does not have
the traditional screws holding it together.
Instead, we have created a "pull apart" case to facilitate
access to the inside components.
To open your case, unscrew the antenna and remove it,
slide the tabs located at the bottom corners off and gently pull
the bezel at the base of the antenna up, and then remove the
crystal (See Image). Now, separate the two case half's while
being careful of the internal wiring harness to the throttle switch,
unplug the wires leading to the throttle switch, and you can
now access the internal components to add optional feature
packages, reverse your servos, or change the battery out.
-Size:45.5x22.5x15.0(mm)/1.79x0.88x0.59(inch)
- Weight : 17g(0.6oz) without X-tal
- Size: 25 x 37.5 x 16 (mm) / 0.98 x 1.47 x 0.62 (inch)
- Weight : 15.9g (.55oz)
- Speed : .17(4.8V) /.14sec(6.0V)
- Torque : 1.1(kg/cm) / 15oz at 4.8V
1.3(kg/cm) /18oz at 6.0V
-Size : 23x12x24(mm)/0.90x0.45x0.94(inch)
- Weight : .28oz/8.0g
OPEN
OPEN
Produktspezifikationen
| Marke: | Hitec |
| Kategorie: | Funksteuerung |
| Modell: | NEON_SS_FM |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Hitec NEON_SS_FM benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Funksteuerung Hitec
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
3 Mai 2023
Bedienungsanleitung Funksteuerung
- Funksteuerung Reely
- Funksteuerung Absima
- Funksteuerung Saturn
- Funksteuerung Futaba
- Funksteuerung Graupner
- Funksteuerung JRpropo
- Funksteuerung Multiplex
- Funksteuerung Robbe
- Funksteuerung Robbe Futaba
- Funksteuerung Rush
- Funksteuerung Sanwa
- Funksteuerung Airtronics
Neueste Bedienungsanleitung für -Kategorien-
14 Oktober 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
26 August 2024
25 August 2024
25 August 2024
25 August 2024