Elkay LKEC2031LS Bedienungsanleitung

Elkay Kran LKEC2031LS

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Elkay LKEC2031LS (4 Seiten) in der Kategorie Kran. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
You choose the flow rate!
This faucet ships with an
eco-friendly 1.5GPM flow regulator
installed.
If you desire higher flow rate, a
2.2GPM flow regulator has also
been included in the box.
Switching the flow regulator is
simple! See the "Flow Regulator
Replacement" section for details.
Sealant Tape
Groove joint pliers
SAVE FOR CONSUMER
(2) 1/2 Supply Linesin
Wrench Screwdriver Plumber's Putty
OPTIONAL 2.2GPM FLOW
REGULATOR
INSTALLATION / OWNER'S MANUAL
Model # LKEC2031
Single Handle Kitchen Faucet
Important!
From underneath the sink,align block â‘ 
and tabs on quick connects.Push quick â‘¡
connect housing firmly upward and snap
onto receiving block. Pull down
moderately to ensure connection has
been made. If it is necessary to remove
quick connect, squeeze tabs on hose
between index finger and thumb, then pull
down to disconnect. After connecting the
hose, install the weight at the lowest â‘¢
point of the hose.
Place faucet through the hole in top of
sink. From underside, assemble rubber
washer metal washer and nut â‘ , â‘¡ â‘¢
onto long shank and tighten nut . â‘£ â‘¢
Firmly tighten the nut to metal washer â‘¢
â‘¡. Do not overtighten.
Shut off water supplies.Clean sink surface.
Place washer and flange on the sink .â‘¡ â‘  â‘¢
If you do not use flange,please use
escutcheon and gasket to replace ④ ⑤
flange and washer.
Important: after installation is completed,
turn on hot and cold water supplies. Pull
the hose assembly out of the spout and
remove the spray head by unscrewing it
from the hose counterclockwise. Be sure
to hold the end of the hose down into the
sink and turn the faucet on to the warm
position where it mixes hot and cold
water. Flush water lines for one minute.
Check for leaks. Re-tighten any
connections if necessary, but do not
overtighten. Reinstall spray head by hand
tightening it back onto the spray hose.
Make connections to water lines with 3/8"
female compression supply hoses.
If additonal length is needed,attach incuded
1/2" MIP thread adaptors to the supplyâ‘¡
hoses .Use 1/2" I.P.S. faucet connections â‘ 
③ ⑤ or use coupling nuts
with 3/8" O.D.ball-nose riser to make â‘£
connections to the water lines. Do not
overtighten.
34
5
1
2
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
4
5
3
2
1
Ø 1 3/8''
Ø35mm
1
3
2
4
3
2
1
STEPS:
FOR CARE AND MAINTENANCE:
·The water in certain areas of the world can be very caustic -
standing water around the product can cause damage. Be
sure to remove standing water with a dry, soft cloth as soon
as possible.
·For polished brass finishes, as often as once a week, you
can apply a paste wax or special, non-abrasive, brass
coating (DO NOT APPLY POLISH).
·Before applying a protective coating, gently brush the entire
fixture using a soft tooth brush. This will remove any dirt or
deposit build-up.
·These simple steps will add temporary protective coating to
your faucet and extend the life of the finish.
Failure to follow care and cleaning will void your warranty.
For additional information, please visit elkayusa.com .
Congratulations on your purchase of an Elkay product.
Although your product is extremely durable, attention should
be given to the care, cleaning and maintenance of this
product. Cleaning agents and abrasives may cause damage,
which may result in oxidation and discoloration.
By following these simple guidelines for proper care and
cleaning, it will give you years of enjoyment:
TO CLEAN: Simply wipe gently with a damp cloth and blot dry
with a soft towel. A common rule of thumb is: when you dry off,
dry off your product.
· Avoid build-up of soap, toothpaste or mineral deposits, as
these tend to have an adverse effect on the appearance of
the product.
· NEVER use cleaning products of any kind on this product -
especially those containing ammonia, bleach or alcohol - or
those with any form of abrasive.
CARE AND CLEANING INSTRUCTIONS
Loosen sleeve by turning it counter-clockwise and lift out â‘ 
the cartridge .Position the cartridge back to the faucet body â‘¡
and retighten the cartridge nut. Reinstall the handle.
The faucet ships with a 1.5GPM aerator installed. An
optional 2.2 GPM aerator is also included in the box.
To switch the flow rate of the faucet:
1. Disassemble the quick connect assembly by
separating the connector and quick connect . â‘  â‘¡
2. Replace 1.5 GPM connector(green) with the 2.2GPM
connector.
3. Reinstall quick connect assembly.
11
2
1
2
Shut off water supply! .With valves in "closed" position,
unscrew fastener and remove handle (5) from valve stem â‘¥
â‘¡ â‘¢. Loosen the screw from valve stem . Loosen the cap â‘¡
â‘£ from the sleeve .â‘ 
FLOW REGULATOR REPLACEMENT
6
CARTRIDGE REPLACEMENT
3 4 521
1 2


Produktspezifikationen

Marke: Elkay
Kategorie: Kran
Modell: LKEC2031LS

Brauchst du Hilfe?

Wenn Sie Hilfe mit Elkay LKEC2031LS benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kran Elkay

Bedienungsanleitung Kran

Neueste Bedienungsanleitung für -Kategorien-