Supermicro SuperServer 6018R-TDTP Bedienungsanleitung
Supermicro
Server
SuperServer 6018R-TDTP
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Supermicro SuperServer 6018R-TDTP (1 Seiten) in der Kategorie Server. Dieser Bedienungsanleitung war für 3 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/1
http://www.supermicro.com MNL-1713-QRG
Board Layout
SuperServer 6018R-TDTP Quick Reference Guide
Rear View
Power Button
Reset Button
Power LED
Device Activity LED
LAN1 LED & LAN2 LED
Information LED
Hard Drive Signal
Hard Drive Fail
Description
No.
CPU Installation
Beep Codes
Front View & Interface
Heatsink Installation
1. Place the heatsink on top of the installed CPU.
2. Align the four screws to the socket.
3. Holding the heatsink in place, screw down as shown
(cross pattern, in order: A, C, B, D).
4. Note: Only use 6-8 lb/f of torque; otherwise, hand-tighten
each screw to avoid damaging the CPU
Memory
Caution
HDD 0 HDD 1 HDD 2 HDD 3
78
1
2
3
4
5
6
7
8
SAFETY INFORMATION
IMPORTANT: See installation instructions and safety warning
before connecting system to power supply.
http://www.supermicro.com/about/policies/safety_information.cfm
WARNING:
To reduce risk of electric shock/damage to equipment,
disconnect power from server by disconnecting all power
cords from electrical outlets.
If any CPU socket empty, install protective plastic CPU cap
CAUTION:
Always be sure all power supplies for this system have
the same power output. If mixed power supplies are
installed, the system will not operate.
For more information go to :
http://www.supermicro.com/support
!
!
!
Description
No.
sSocket Key
CPU Keys
DescriptionNo.
123456
Beep Code/LED Message Description
1 beep Refresh Ready to boot
5 short beeps + 1 long beep Memory error No memory detected in the system
5 beeps No Con-In
or No Con-
Out devices
Con-In includes USB or PS/2 keyboard,
PCI or Serial Console Redirection, IPMI KVM or SOL.
Con-Out includes Video Controller, PCI or Serial
Console Redirection, IPMI SOL.
1 beep per device Refresh 1 beep or each USB device detected
1
2
3
4
5
6
7
8
9
FHHL PCI-E Expansion Slot (CPU1)
UID
VGA Port
10Gb SFP+ LAN Port 2
10Gb SFP+ LAN Port 1
USB 2.0 Ports
COM1 Port
Dedicated LAN for IPMI
Power Supply Module
Top iew of DDR4 Slo V t
Release Tab Release Tab
Note: Notch should align
with the receptive ke y
point on the slot.
Notch Notch
Front ie V w
Pro o a their Co o M escess rs nd rresponding Mem ry odul
CPU# Corresponding DIMM Modules
CPU 1 P1-DIMMA1 P1-DIMMB1 P1-DIMMC1 P1-DIMMD1
CPU 2 P2-DIMME1 P2-DIMMF1 P2-DIMMG1 P2-DIMMH1
Pro or a o M e for ti l P o ncecess nd Mem ry odul Popul ionat Op ma erf rma
Number of
CPUs+DIMMs (For memory to work properly, please follow the instructions below.)
1 CPU &
2 DIMMs
CPU1
P1-DIMMA1/P1-DIMMB1
1 CPU &
4 DIMMs
CPU1
P1-DIMMA1/P1-DIMMB1, P1-DIMMC1/P1-DIMMD1
2 CPUs &
4 DIMMs
CPU1 + CPU2
P1-DIMMA1/P1-DIMMB1, P2-DIMME1/P2-DIMMF1
2 CPUs &
6 DIMMs
CPU1 + CPU2
P1-DIMMA1/P1-DIMMB1/P1-DIMMC1/P1-DIMMD1, P2-DIMME1/P2-DIMMF1
2 CPUs &
8 DIMMs
CPU1 + CPU2
P1-DIMMA1/P1-DIMMB1/P1-DIMMC1/P1-DIMMD1, P2-DIMME1/P2-DIMMF1/P2-
DIMMG1/P2-DIMMH1
Screw #B
Screw #D
Screw #A
Screw #C
1
2
3
4
5
6
7
8
9
10
11
12
CPU1 Slot6 PCI-E 3.0 x8
P2-DIMMG1 slot
P2-DIMMH1 slot
CPU2
P2-DIMME1 slot
P2-DIMMF1 slot
P1-DIMMA1 slot
P1-DIMMB1 slot
CPU1 (Install CPU1 First)
P1-DIMMD1 slot
P1-DIMMC1 slot
I-SATA 0~5: SATA 3.0 Ports supported by Intel PCH (I-SATA 0~5)
139 6 48 27 5
CLOSE 1st
OPEN 1st
JBAT1
X10DRD-LTP
I-SATA5
I-SATA4I-SATA0
I-SATA1 I-SATA3
I-SATA2
JSTBY1
JL1
FAN3
FAN7
FAN8
FAN5
FAN6
I-SGPIO2
I-SGPIO1
JTPM1
JPWR1
JPWR3
JF1
JPI2C1
JPL1
JI2C2
JWD1JI2C1JPG1
LED3
LEDM1
LED1
LED4
LED5
LED6
JUIDB1
SP1
J1_SFP1
J1_SFP2
P2-DIMMG1
P2-DIMMH1
P1-DIMMC1
P1-DIMMB1
P1-DIMMD1
P1-DIMMA1
PMI_LAN
COM1
COM2
USB4/5
CPU1
CPU1 SLOT6 PCI-E 3.0 X8
VGA
USB2/3 USB0/1
USB6
JPWR2
FAN2
FAN1
FAN4
P2-DIMMF1
P2-DIMME1
JPB1
CPU2
PCH
BMC
AST2400
BIOS
(CPU1 required
)
CLOSE 1st
OPEN 1st
JIPMB1
SFP2
LAN2 LAN1
3
5
10 9 7
12
1
6
2
8
4
11
Rev. 1.0a
Populating RDIMM/LRDIMM DDR4 Memory Modules
Type
Ranks
Per DIMM
and Data
Width
DIMM Capacity
(GB)
Speed (MT/s); Voltage (V); Slots per Channel (SPC) and
DIMMs per Channel (DPC)
1 Slot per Channel
1 DPC
E5-2600 V3 E5-2600 V4
4 GB 8 GB 1.2 V 1.2 V
RDIMM SRx4 8 GB 16 GB 2133 2400
RDIMM SRx8 4 GB 8 GB 2133 2400
RDIMM DRx8 8 GB 16 GB 2133 2400
RDIMM DRx4 16 GB 32 GB 2133 2400
LRDIMM QRx4 32 GB 64 GB 2133 2400
LRDIMM 3DS 8Rx4 64 GB 128 GB 2133 2400
Produktspezifikationen
| Marke: | Supermicro |
| Kategorie: | Server |
| Modell: | SuperServer 6018R-TDTP |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Supermicro SuperServer 6018R-TDTP benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Server Supermicro
6 September 2024
6 September 2024
6 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
4 September 2024
29 August 2024
Bedienungsanleitung Server
- Server Acer
- Server Asus
- Server Gigabyte
- Server HP
- Server Medion
- Server Sony
- Server ZyXEL
- Server Buffalo
- Server Allnet
- Server Linksys
- Server Netgear
- Server Fantec
- Server Technics
- Server Abus
- Server Megasat
- Server Toshiba
- Server Lindy
- Server Dell
- Server Lenovo
- Server Tripp Lite
- Server TRENDnet
- Server Western Digital
- Server AVerMedia
- Server Veritas
- Server Black Box
- Server SilverStone
- Server NEC
- Server Monacor
- Server Seagate
- Server Fujitsu
- Server Maxdata
- Server Revox
- Server Totolink
- Server Conceptronic
- Server D-Link
- Server QNAP
- Server Digitus
- Server LevelOne
- Server APC
- Server Cisco
- Server Freecom
- Server Synology
- Server Kramer
- Server Intellinet
- Server Eaton
- Server Hikvision
- Server FLIR
- Server ELAC
- Server Planet
- Server Asustor
- Server Blackmagic Design
- Server Dane Elec
- Server Digi
- Server Dual Bay
- Server EMC
- Server GeoVision
- Server Ibm
- Server In Win
- Server Iomega
- Server LaCie
- Server Provision ISR
- Server Quantum
- Server Sun
- Server AMX
- Server ACTi
- Server Vimar
- Server Siig
- Server Intel
- Server Moxa
- Server StarTech.com
- Server Smart-AVI
- Server Mobotix
- Server Sonnet
- Server SEH
- Server Gefen
- Server Avocent
- Server Atlantis Land
- Server Hanwha
- Server ATen
- Server KanexPro
- Server Axis
- Server Advantech
- Server HGST
- Server Kiloview
- Server B&B Electronics
- Server Extron
- Server Atlona
- Server Rocstor
- Server Raidsonic
- Server G-Technology
- Server Infortrend
- Server Areca
- Server Silex
- Server Promise Technology
- Server Matrox
- Server Origin Storage
- Server Ernitec
- Server EXSYS
- Server Raritan
- Server C2G
- Server Chenbro Micom
- Server Lantronix
- Server IStarUSA
- Server Valcom
- Server TAIDEN
- Server MvixUSA
- Server Opengear
- Server Mr. Signal
- Server NETSCOUT
Neueste Bedienungsanleitung für -Kategorien-
13 Oktober 2024
12 Oktober 2024
12 Oktober 2024
11 Oktober 2024
11 Oktober 2024
10 Oktober 2024
6 Oktober 2024
4 Oktober 2024
3 Oktober 2024
3 Oktober 2024