Supermicro SuperServer 5039MS-H12TRF Bedienungsanleitung
Supermicro
Server
SuperServer 5039MS-H12TRF
Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Supermicro SuperServer 5039MS-H12TRF (9 Seiten) in der Kategorie Server. Dieser Bedienungsanleitung war fĂĽr 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/9
Information for Lot 9 of d )ErP (Eco esign
This addendum addresses E European Union (EU) codesign requirements for servers and storage
products addendum product. All and ratings within this data are in reference only Supermicro to the (s) in
the manual. The below information conforms ommission to requirements laid down Cin Annex II of the
R . egulation 2019/424
3(1)(a): e See Section 1.1 of th system manual for the product type.
3(1)(b): See the title page and preface of the system manual for the trademark and
manufacturer’s address.
3(1)(c): (s). See the title page of the system manual for product model number
3(1)(d): . See the serial number on the physical system to determine the year of manufacture
3(1)(e-j): PSU E actor V ) (F fficiency and Power F alue (Table rom 80 Plus report)
PSU Model #: PWS 2K04F 1R- -
Watts:
2000
PSU E fficiency
P Fower actor
% of R Lated oad
% % % %10 20 50 100
50 %
Single -Output (AC DC)
94. %06
95. %75
96.30 %
93. %84
96.30
E P System (EUT) fficiency in I Sdle tate ower (Table)
Representative
Configurations
Measured Idle State
Power (W)
Calculated Idle Power
Allowance (W)
High nd -E Performance
C onfiguration
242.3
431.82
Typical Configuration
N/A
N/A
Low erformance -E Pnd
C onfiguration
232.8
420.98
System E P(EUT) fficiency in A Sctive tate ower (Table)
Representative
Configurations
Active tate S
E Score fficiency
(Effserver)
Minimum A Sctive tate
Efficiency for Multi- node
S erver
High nd -E Performance
C onfiguration
16.7
Typical Configuration
N/A 12
Low erformance -E Pnd
C onfiguration
16.4
3(1)( is k): The operating condition class A2.
Dry bulb temp °C
Humidity -range (non condensing)
Operating
condition
class
Allowable
range
Recom
mended
range
Allowable range
Dew Point (DP)
Relative Humidity
(RH)
Recommended
range
Max dew
point (°C)
Maximum
rate of
change
(°C/hr)
A1
15 32-
18 27-
–
12 and°C DP
8 %
RH to
17 °C DP and
80 % RH
–
9 °C DP to
15 °C
DP and
60 % RH
17
5/20
A2
10 35-
18 27-
–
12 DP °C and 8 %
RH to
21 DP °C and
80 % RH
Same as A1
21
5/20
A3
5-40
18 27-
–
12 DP °C and 8 %
RH to
24 DP °C and
85 % RH
Same as A1
24
5/20
A4
5-45
18 27-
–
12 DP °C and 8 %
RH to
24 DP °C and
90 % RH
Same as A1
24
5/20
3(1)(l): The idle state power at the higher boundary temperature of the operating conditions
class is 242.3 W.
3(1)( is 16.7m): The active state efficiency and performance .
3(1)(n): There are two methods by which a user can securely delete data from this system. The
user performing secure data deletion should be an IT professional.
The first is with a Unified Extensible Firmware Interface (UEFI) shell utility. This utility
works on X10/X11/H11/H12/M11 motherboard series with onboard SATA/NVMe devices.
Any user may access and download this utility through following link:
https://www.supermicro.com/about/policies/disclaimer.cfm?url=/wftp/utility/Lot9_Secure
_Data_Deletion_Utility/
Download the shell utility package and extract it to a USB flash drive, then plug the drive
into the server for which secure data deletion is necessary. Then turn the system on.
Navigate to the BIOS setup menu, then place the server system into the UEFI shell
environment. Follow the instructions in the README file to invoke the utility and
complete the deletion.
The second method is through the secure data deletion tool provided by the original
manufacturer of the hard drive. This should be used in a scenario where the shell utility
is not applicable. Each manufacturer should have the tool available on their website. If
needed, please look on the hard drive label for the name of the manufacturer and model
information.
3(1)(o): List of recommended combinations of blade servers with chassis: N/A.
3(1)(p): - - . List of all current SKUs within this product family: SYS 5039MS H12TRF
3(3)(a): There is no use of cobalt in batteries in this product.
The indicative weight range of eodymium in the HDD is if manufactured by Western n 0.0
Digital, and is 25 grams if manufactured by Seagate.between 5-
3(3)(b): Please see the disassembly instructions on the next page.
Illustrated System Disassembly Instructions
Please note:
All the illustrations in the below disassembly instructions are for demonstration only.
Components shown here may not match exactly with the components in your system.
CAUTION: Always power off the system and unplug the power cord(s) first
before disassembling the system!
1. Data Storage Devices
Type and number of fastenings:
. Four (4) Phillips screws per hard drive
Tools required:
Screwdriver with PH2 bit.
Procedure:
Press and hold down the release tab on the front of the node and pull the node from
the system. Remove the screws shown in the pictures below from the bottom of the tray.
OR
One (1) 3.5” and Two (2) 2.5” HDD Two (2) 3.5” and Four (4) 2.5” HDD
Produktspezifikationen
| Marke: | Supermicro |
| Kategorie: | Server |
| Modell: | SuperServer 5039MS-H12TRF |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Supermicro SuperServer 5039MS-H12TRF benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Server Supermicro
6 September 2024
6 September 2024
6 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
5 September 2024
4 September 2024
29 August 2024
Bedienungsanleitung Server
- Server Acer
- Server Asus
- Server Gigabyte
- Server HP
- Server Medion
- Server Sony
- Server ZyXEL
- Server Buffalo
- Server Allnet
- Server Linksys
- Server Netgear
- Server Fantec
- Server Technics
- Server Abus
- Server Megasat
- Server Toshiba
- Server Lindy
- Server Dell
- Server Lenovo
- Server Tripp Lite
- Server TRENDnet
- Server Western Digital
- Server AVerMedia
- Server Veritas
- Server Black Box
- Server SilverStone
- Server NEC
- Server Monacor
- Server Seagate
- Server Fujitsu
- Server Maxdata
- Server Revox
- Server Totolink
- Server Conceptronic
- Server D-Link
- Server QNAP
- Server Digitus
- Server LevelOne
- Server APC
- Server Cisco
- Server Freecom
- Server Synology
- Server Kramer
- Server Intellinet
- Server Eaton
- Server Hikvision
- Server FLIR
- Server ELAC
- Server Planet
- Server Asustor
- Server Blackmagic Design
- Server Dane Elec
- Server Digi
- Server Dual Bay
- Server EMC
- Server GeoVision
- Server Ibm
- Server In Win
- Server Iomega
- Server LaCie
- Server Provision ISR
- Server Quantum
- Server Sun
- Server AMX
- Server ACTi
- Server Vimar
- Server Siig
- Server Intel
- Server Moxa
- Server StarTech.com
- Server Smart-AVI
- Server Mobotix
- Server Sonnet
- Server SEH
- Server Gefen
- Server Avocent
- Server Atlantis Land
- Server Hanwha
- Server ATen
- Server KanexPro
- Server Axis
- Server Advantech
- Server HGST
- Server Kiloview
- Server B&B Electronics
- Server Extron
- Server Atlona
- Server Rocstor
- Server Raidsonic
- Server G-Technology
- Server Infortrend
- Server Areca
- Server Silex
- Server Promise Technology
- Server Matrox
- Server Origin Storage
- Server Ernitec
- Server EXSYS
- Server Raritan
- Server C2G
- Server Chenbro Micom
- Server Lantronix
- Server IStarUSA
- Server Valcom
- Server TAIDEN
- Server MvixUSA
- Server Opengear
- Server Mr. Signal
- Server NETSCOUT
Neueste Bedienungsanleitung fĂĽr -Kategorien-
13 Oktober 2024
12 Oktober 2024
12 Oktober 2024
11 Oktober 2024
11 Oktober 2024
10 Oktober 2024
6 Oktober 2024
4 Oktober 2024
3 Oktober 2024
3 Oktober 2024