Sani-Lav 524F Bedienungsanleitung
Sani-Lav
SpĂŒlbecken
524F
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂŒr Sani-Lav 524F (6 Seiten) in der Kategorie SpĂŒlbecken. Dieser Bedienungsanleitung war fĂŒr 28 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/6
F L O O R M O U N T S I N K 1
Operating Manual for Floor Mount Stainless Steel Sink
Models 524F and 524F-0.5
of Domestic and Foreign Parts
Columbia does not recommend use with harsh chemicals.
Product Compliance
NSF/ANSI 2 Food Equipment, NSF/ANSI 61, Section 9, ASME A112.18.1/CSA B125.1
2
F L O O R M O U N T S I N K
COLUMBIA SPECIFICATIONS
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
Installation Instructions
Step 1
1. 1. Attach upper and lower leg support brackets to legs with hardware (provided).
2. Place wash station sink on the leg assembly. Secure legs to bowl with hardware provided.
3. Place wash station sink at the desired location.
4. Mark the floor where the mounting holes are at the base of the legs. See illustration A.
5. Drill holes as required for mounting hardware. Hardware not included.
Step 2
1. Install Faucet to the sink using faucet mounting kit provided. We recommend using pipe thread
sealant instead of Teflon tape.
2. Install strainer assembly to the drain hole.
3. Connect hot and cold water supply lines (not included) to the back of faucets.
Step 3
1. Position wash station sinks to pre-drilled holes and secure sink to the floor.
2. Connect waste line or drain pipe to the strainer assembly. Not included.
3. Connect water supply lines (Hot and Cold) to the water source. Not included.
4. Remove aerator from the spout and flush the water system.
5. Replace aerator to the spout.
6. Check for leaks and tighten connections if necessary.
Step 4
1. Seal gap between bowl and leg assembly as shown in illustration B.
2. When mounting against wall, it is recommended sealing the top of the backsplash to wall as
shown on illustration C.
Parts List
(1) Floor mount sink
(1) Leg assembly set
(6) Nuts, bolts and washers for leg assembly
(4) Washers and nuts for connection sink to leg assembly set
(1) 8â on center faucet
(1) Faucet mounting kit
(1) Strainer assembly with basket
Trouble Shooting Guide
Problem Possible Cause To Diagnose Remedy
Water drips from
the spout or from
under the lever.
1. Seat washer is worn
2. Seat is worn
3. O-rings are worn
Shut cold water source off. See if
water still leaks from the spout. If
leaks continues repair hot side if
not repair cold side.
Recommend
installing hot
or cold faucet
repair kit.
Go to for more information on replacement parts and installation videos.columbiasinks.com
WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds),
Lead, and Phthalates (DEHP) which are known to the State of California to cause cancer and birth defects
or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
NOTE: Lead content originates from Brass components in valves and faucets and is certiîed under
NSF/ANSI 372 as containing less than 0.25% lead in wetted surfaces.
Notice for California Consumers
Tools Required
Tape measure
Adjustable wrench
Drill motor and drill bits
Pipe wrench
Level
Safety glasses
Screw drivers: phillips and standard
Pencil
Socket wrench
Illustration A
Illustration B
Illustration C
3
F L O O R M O U N T S I N K
COLUMBIA SPECIFICATIONS
800.626.2117 columbiasinks.com info@columbiasinks.com
©2021 Columbia Products
Hole ConïŹgurations
9â (228.6mm)
Front Side
16.75â(424.4mm)
27â (685.8mm)
10.5â (266.7mm)
45Âș
23â (584.2mm)
11.5â
(292.1mm)
11.5â
(292.1mm)
20.5â
(520.7mm)
17â
(431.8mm)
1.5â (38mm)
2â (51mm)
Top
20â (508mm) 20.5â (520.7mm)
2â (51mm)
1.5â (38mm)
.875â (22mm)
dia. holes (2)
6â (152.4mm)
10.5â
(266.7mm)
1.5â (38mm)
7.5â (191mm)
7.5â
(190.5mm)
7.5â
(190.5mm)
8â
(203.2mm)
3.25â (88.55mm)
2â drain hole
.5â R
(12.7mm)
.5â R (12.7mm)
Back Splash
Supply Line Detail
1/2â Male NPT
Hot
from Wall
Cold
from Wall
Floor Mounting Detail
1.5â Leg
Thickness
.75â From
Edge of Leg
to First Hole
.5â dia. Floor
Mounting Holes
9â on Center
Produktspezifikationen
| Marke: | Sani-Lav |
| Kategorie: | SpĂŒlbecken |
| Modell: | 524F |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Sani-Lav 524F benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung SpĂŒlbecken Sani-Lav
21 August 2024
6 Mai 2024
1 Mai 2024
1 April 2024
13 MĂ€rz 2024
11 MĂ€rz 2024
5 MĂ€rz 2024
18 Februar 2024
6 Februar 2024
28 Januar 2024
Bedienungsanleitung SpĂŒlbecken
- SpĂŒlbecken Concept
- SpĂŒlbecken Teka
- SpĂŒlbecken Smeg
- SpĂŒlbecken Caple
- SpĂŒlbecken Kernau
- SpĂŒlbecken Saro
- SpĂŒlbecken Foster
- SpĂŒlbecken Leisure
- SpĂŒlbecken Gustavsberg
- SpĂŒlbecken CDA
- SpĂŒlbecken Schock
- SpĂŒlbecken Rangemaster
- SpĂŒlbecken BLANCO
- SpĂŒlbecken Elkay
- SpĂŒlbecken Deante
- SpĂŒlbecken Roca
- SpĂŒlbecken Artusi
- SpĂŒlbecken Advance Tabco
- SpĂŒlbecken Cookology
- SpĂŒlbecken Tot Mate
- SpĂŒlbecken Eagle Group
- SpĂŒlbecken Kuchinox
- SpĂŒlbecken Oliveri
Neueste Bedienungsanleitung fĂŒr -Kategorien-
18 August 2024
17 August 2024
10 August 2024
21 Juni 2024
21 Juni 2024
21 Juni 2024
13 Juni 2024
13 Juni 2024
13 Juni 2024
13 Juni 2024