Projecta SC015 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Projecta SC015 (8 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/8
SOLAR CONTROLLER
P/No’s. SC008, SC015
12 VOLT
4 STAGE CHARGING
2
WARNINGS – IMPORTANT PLEASE READ
This charger is designed for indoor and outdoor use and is weather proof
Do not disassemble the controller. Take to a qualified person if the unit requires repairing
Lead acid batteries can be dangerous. Ensure no sparks or flames are present when working
near batteries
Eye protection should always be used. Never short circuit the battery
Given sufficient light solar panels always generate energy even when they are disconnected
Accidental ‘shorting’ of the terminals or wiring can result in sparks causing personal injury or a fire
hazard. We recommend that you cover up the panel(s) with some sort of soft cloth so you can block
all incoming light during the installation. This will ensure that no damage is caused to the Solar
Panel or Battery if the wires are accidentally short circuited
Always install a battery fuse on each circuit including the solar controller
Do not reverse connect the wires to the solar panel or battery
MOUNTING THE DEVICE
The Solar Controller is mounted as below
The quickest and easiest way to mount the unit is to use the three plastic spacers and self tapping
screws supplied and mount the unit to a flat surface.
Fig 1.
3
FEATURES
4 Stage charging ensures the battery is charged to the optimum level
Advanced MCU control pulse width modulated (PWM) technology, high efficiency operation
Programmable for Gel, AGM, Conventional lead-acid (WET) and Calcium Batteries
Built in regulator to prevent your battery from being overcharged. Overcharging occurs when the
charge voltage is unregulated. This can result in premature battery failure
In built regulator prevents your battery from being under charged, in the solar energy field, battery
undercharge often occurs, especially on some conventional Lead Acid or Calcium batteries; the unit
provides an automatic equalization feature for deeply drained conventional Lead Acid battery or
Calcium battery, as well as provides a cycling automatic equalizing feature every 28 days
SC008 & SC015 can be connected to the battery permanently to keep the battery fully charged by
using a process called “floating”. This means the controller will stop charging when the battery is
full and will automatically start charging the battery as required. This process will also reduce water
loss and help prevent the battery from ‘drying out
Protects your battery from discharge at night. Under low light or no light conditions the solar panel
voltage could be less than the battery voltage. The unit contains a special circuit which prevents
current flowing back from the battery and into the solar panel
Coloured LED’s to easily indicate the charging status and battery conditions and system faulty
Provides external battery temperature sensor (Optional)
Multi charging protections against reverse polarity, short circuit, over temperature, over voltage, etc.
Conformal-coating circuit boards and plated terminals protect the unit in hostile environments
Waterproof IP65
For use with 12 Volt Solar Panel only. Suitable for solar panels up to 96 Watts
(SC008) and 180 Watts (SC015)
NO BATTERY
BATT REVERSED
SOFT START
CHARGING
FLOAT CHARGE
LOW LIGHT
12 Volt
8 AMP
SOLAR CHARGE CONTROLLER
FAULT CHARGING FULL
P/No. SC008
Fig 2.


Produktspezifikationen

Marke: Projecta
Kategorie: Nicht kategorisiert
Modell: SC015

Brauchst du Hilfe?

Wenn Sie Hilfe mit Projecta SC015 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Projecta

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-