Metra 99-5802 Bedienungsanleitung

Metra Kfz-Bausatz 99-5802

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Metra 99-5802 (2 Seiten) in der Kategorie Kfz-Bausatz. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
1
FORD Expedition 1997-00 / F-150 1997-00
2
Cut and remove the Mounting Bracket
("A"). Skip to the Installation Instructions for
ALL VEHICLES on Page #2.
1 2
Disconnect the negative battery terminal to
prevent an accidental short circuit. Place
your index fingers on the inner edges of the
a/c vents (shown above) and push inward.
Grasp the exposed lip of each vent opening
and pull out on the radio trim bezel. Remove
the dash trim bezel. (The airbag wiring does
NOT need to be disconnected). Using
Metra's 86-5618, pull the factory head unit
from the dash and disconnect the wiring.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Using Metra's
86-5618, pull the factory head unit from the dash
and disconnect the wiring.
1
FORD Crown Victoria 1995-00 / Econoline 1997-00
Explorer 1995-00 / F-250 1999-00 / F-350 1999-00
F-550 1999-00 / Ranger 1995-00 / Windstar 1999-00
LINCOLN Continental 1995-97 / MAZDA B-Series Pickup 1995-00
MERCURY Grand Marquis 1995-00 / Mountaineer 1997-00
Cut and remove the Mounting Bracket
("A") and the bottom mounting legs
("B") from the Radio Housing. Skip to
the Installation Intructions for ALL
VEHICLES on Page #2.
2
3
4
ALL VEHICLES
"B"
CROWN VICTORIA, GRAND MARQUIS: Skip to step #5.
CONTINENTAL, ECONOLINE, F-150, MOUNTAINEER: Skip to step #4.
B-SERIES PICKUP, EXPEDITION, EXPLORER, F-150, F-250, F-350, F-550, RANGER,
WINDSTAR: Metra recommends installing the kit with the pocket at the However, to top.
install the kit with the pocket at the locate the slots on tabs bottom, "A". Using the slots as a
guide, cut and remove the portions of the tabs. shaded (see Fig. A)
B - S E R I E S P I C K U P, CO N T I N E N T A L ,
ECONOLINE, EXPEDITION, EXPLORER,
F-150, F-250, F-350, F-550, MOUNTAINEER,
RANGER, WINDSTAR: Secure the Mounting
Bracket to the back of the with Radio Housing
(2) 3/8" Phillips Pan-head Screws supplied.
(see Fig. A). Slide the DIN cage into the Radio Housing and secure by bending the metal
locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B).
Slide the onto the Mounting Bracket and mount the Support to the back of the Rear Support
head unit using the hardware included with the unit. (see Fig. C). Skip to step #6.
Fig. A
Fig. B
Fig. C
"A"
"A"
Fig. A
"A"
"A"
KIT COMPONENTS
unting Bracket
(2) 3/8" Phillips
Pan-head Screws
Rear Support
KIT FEATURES
Rear support
provisions
CD jewel case
pocket
APPLICATIONS
CAR PAGE
FORD
Crown Victoria 1995-00................................................1
Econoline 1997-00.......................................................1
Expedition 1997-00..................................................... 1
Explorer 1995-00........................................................ 1
F-150 1997-00............................................................ 1
F-250 1999-00............................................................ 1
F-350 1999-00............................................................ 1
F-550 1999-00............................................................ 1
Ranger 1995-00.......................................................... 1
Windstar 1999-00........................................................1
LINCOLN
Continental 1995-97.................................................... 1
MAZDA
B-Series Pickup 1995-00.............................................. 1
MERCURY
Grand Marquis 1995-00...............................................1
Mountaineer 1997-00.................................................. 1
TOOLS REQUIRED
Cutting tool
Phillips screwdriver
86-5618 - Head unit
removal keys
99-5802
INSTALLATION
INSTRUCTIONS
3
6
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
EXPEDITION, F-150: Re-connect the battery terminal and test the unit for proper operation.
Remove the top (2) Phillips screws securing the climate control cluster to the sub-dash. Slide
the head unit/kit assembly into the dash cavity and mount the bottom legs of the kit to the same
holes in the climate control cluster with the (2) Phillips screws previously removed. (see Fig. A)
B-SERIES PICKUP, CONTINENTAL, CROWN VICTORIA, ECONOLINE, EXPLORER,
F-250, F-350, F-550, GRAND MARQUIS, MOUNTAINEER, RANGER, WINDSTAR: Re-
connect the battery terminal and test the unit for proper operation. Snap the head unit/kit
assembly into the sub-dash. (see Fig. B)
5
7
Radio Housing
Adjustable wrench
Fig. A
Fig. B
CROWN VICTORIA, GRAND MARQUIS: Slide
the DIN cage into the and secure Radio Housing
by bending the metal locking tabs down. Slide
the aftermarket head unit into the cage until
secure.
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 030701


Produktspezifikationen

Marke: Metra
Kategorie: Kfz-Bausatz
Modell: 99-5802

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra 99-5802 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kfz-Bausatz Metra

Bedienungsanleitung Kfz-Bausatz

Neueste Bedienungsanleitung für -Kategorien-