Joy-it SEN-VIB01 Bedienungsanleitung

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Joy-it SEN-VIB01 (7 Seiten) in der Kategorie niet gecategoriseerd. Dieser Bedienungsanleitung war für 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/7
SEN VIB01-
Analog piezoelectric vibration sensor
1. GENERAL INFORMATION
Dear customer,
thank you very much for choosing our product.
In the following, we will introduce you to what to observe while starting
up and using this product.
Should you encounter any unexpected problems during use, please do
not hesitate to contact us.
2. INTRODUCTION
Vibrations that aî ‚ect the sensor generate a voltage signal due to the
piezoelectric eî ‚ect depending on the strength of the vibration.
Therefore, you do not need a supply voltage for the sensor, but only the
voltage at the signal pin of the sensor has to be measured by using an
analog digital converter.-
Arduino SEN VIB01 -
GND G
- NC
A0 S
3. USE WITH THE ARDUINO
3.1 Wiring
3.2 Code example
We provide a code example for you to test your sensor. Before uploading,
make sure that the correct and are set in your Arduino IDE Board Port
under .Tools
The sensor generates a voltage from the vibration applied to it.
The following code will give you the current output voltage of the sensor.
The higher the applied vibration, the higher the output voltage.
void setup() {
// put your setup code here, to run once:
Serial.begin( );115200
}
void loop() {
// put your main code here, to run repeatedly:
sensorValue = analogRead(A0);int
voltage = sensorValue * ( );float 5.0 / 1023.0
Serial.println(voltage);
}

Produktspezifikationen

Marke: Joy-it
Kategorie: niet gecategoriseerd
Modell: SEN-VIB01

Brauchst du Hilfe?

Wenn Sie Hilfe mit Joy-it SEN-VIB01 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung niet gecategoriseerd Joy-it

Bedienungsanleitung niet gecategoriseerd

Neueste Bedienungsanleitung für -Kategorien-