Da-Lite Motorized Scenic Roller Bedienungsanleitung
Da-Lite
ProjektionsflÀche
Motorized Scenic Roller
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂŒr Da-Lite Motorized Scenic Roller (8 Seiten) in der Kategorie ProjektionsflĂ€che. Dieser Bedienungsanleitung war fĂŒr 18 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/8
INSTRUCTION BOOK FOR
Motorized Scenic
Roller Screen
2
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk of îire, electric shock, or
injury to persons.
WARNING: Before obtaining access to terminals, all
supply circuits must be disconnected.
ATTENTION! Avant dâaccĂ©der au bloc dâalimentation,
veuillez couper lâalimentation Ă©lectrique.
6. An appropriate disconnect device shall be provided as part
of the building installation.
7. Failure to provide adequate structural strength for this
component can result in serious personal injury or damage
to equipment! It is the installerâs responsibility to make sure
the structure to which this component is attached can
support the weight of all equipment. Reinforce the structure
as required before installing the component.
8. Use this projection screen only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
Save These Instructions
Original Instructions
Disclaimer
Milestone and its aîîiliated corporations and subsidiaries
(collectively "Milestone"), intend to make this manual accurate
and complete. However, Milestone makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of this subject to change
without notice or obligation of any kind. Milestone makes no
representation of warranty, expressed or implied, regarding the
information contained herein. Milestone assumes no
responsibility for accuracy, completeness or suîîiciency of the
information contained in this document.
Da-LiteÂź is a registered trademark of Milestone AV Technologies.
All rights reserved.
3
Before proceeding with the installation please read the installation and operating instructions thoroughly. Make sure
to recheck measurements of screen and hanger locations before installation. Area must be clear for screen to operate.
With all lid sections removed from shipping container, remove the screws holding the frame to the shipping container
(2 per cross brace). The screen can now be carefully lifted out of the container.
Method A
The frame can be mounted to ceiling with 5/16" diameter
threaded rods. Level frame from front to back and left to right.
Mount from all cross braces (Figure 1).
Method B
Hang from a pipe (îly the screen). Level frame from front to
back and left to right. Mount from all cross braces (Figure. 2).
NOTE: Motor pulley must clear pipe. Chains must clear
motor tubes.
Screen motors have been internally wired at Da-Lite. Wiring
designated âexternalâ is completed by installer conforming to
local and national codes. Refer to wiring diagram on next page.
Check for satisfactory condition by operating the screen. Be
prepared to stop screen. Standard Duty Cycle:
1 MIN. 30 SEC. ON / 45 MIN. OFF.
CAUTION! Excessive continuous operation may cause
overheating and motors will shut oîf.
Let motors cool 10 to 15 minutes and continue test.
ATTENTION! Le fonctionnement continu et excessif peut
provoquer une surchauîfe et l'arrĂȘt du moteur. Laissez le
moteur refroidir pendant 10 Ă 15 minutes et poursuivez le
test.
Check the cables to make sure they are winding on the motor
and roller pulleys properly.
1. With screen in complete unrolled position, examine the
screen surface carefully. If fabric does not hang îlat, loosen
the nuts on the eyebolts of the black clamps. Adjust the
wingnuts to pull or relax the fabric as needed. Several clamp
heights may be adjusted depending on the severity of the
hang. After adjustment, tighten the nuts against the
underside of the frame. Caution stage hands and others to
check area before lowering screen. Do not bump screen with
ladders, scenery, etc.
Installation
Electrical Installation Screen Adjustment
Figure 1 Figure 2
Suggested Method Of Installation
Method A â Secure To Ceiling
Suggested Method Of Installation
Method B â âFlying Pipeâ
Ceiling
Secure To Suit
Front
îâîî" Threaded Rod
(Not Furnished)
Safety Switch Trigger
Back
Cross
Brace
Secure To
Suit
Cable
15"
Ceiling Pipe To Suit
Front
Chain To Suit
(Not Furnished)
Eye Bolts For Leveling
(Not Furnished)
Safety Switch
Trigger
Back
Cross
Brace
Produktspezifikationen
| Marke: | Da-Lite |
| Kategorie: | ProjektionsflÀche |
| Modell: | Motorized Scenic Roller |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Da-Lite Motorized Scenic Roller benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung ProjektionsflÀche Da-Lite
2 Oktober 2024
27 September 2024
11 September 2024
5 September 2024
2 September 2024
1 September 2024
31 August 2024
17 August 2024
10 August 2024
10 August 2024
Bedienungsanleitung ProjektionsflÀche
- ProjektionsflÀche Pyle
- ProjektionsflÀche Optoma
- ProjektionsflÀche Kodak
- ProjektionsflÀche NEC
- ProjektionsflÀche Celexon
- ProjektionsflÀche Elite
- ProjektionsflÀche AV:link
- ProjektionsflÀche Draper
- ProjektionsflÀche Oregon Scientific
- ProjektionsflÀche Duronic
- ProjektionsflÀche GPX
- ProjektionsflÀche Luxburg
- ProjektionsflÀche EluneVision
- ProjektionsflÀche Stewart
- ProjektionsflÀche Elite Screens
- ProjektionsflÀche Lumene
- ProjektionsflÀche Avers
- ProjektionsflÀche Elite ProAV
- ProjektionsflÀche KHOMO GEAR
- ProjektionsflÀche EPV
Neueste Bedienungsanleitung fĂŒr -Kategorien-
12 Oktober 2024
29 September 2024
20 September 2024
7 September 2024
6 September 2024
6 September 2024
5 September 2024
4 September 2024
4 September 2024
Celexon Ultramobile Plus Professional 194 x 146 Bedienungsanleitung
3 September 2024