Da-Lite Lancaster 85450 Bedienungsanleitung

Da-Lite Nicht kategorisiert Lancaster 85450

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Da-Lite Lancaster 85450 (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
Instruction Book for
LECTERN
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: 574-267-8101
800-622-3737
Fax: 574-267-7804
Toll Free Fax: 877-325-4832
www.da-lite.com
e-mail: info@da-lite.com
The Da-Lite Difference.
Plug microphone into shock mount on reading surface.
Turn main power switch located under reading surface
on. Rotate "MAIN MIC", "TREBLE" and "BASS" controls
fully counterclockwise to minimum volume position. Turn
speaker switch located on dash panel to position. "on"
While speaking into the microphone, slowly increase
"MAIN MIC" volume by turning knob clockwise. Adjust
1
POWER
Connect power supply to 110/120 VAC 3-wire outlet
(220/240 VAC models to 220/240 VAC source).
READING LIGHT
Depress light switch to activate light. ADJUST VISOR AS
NECESSARY. Use GE 25T8DC 110v appliance lamp or
equivalent when relamping all 110/120 sound and non-
sound lecterns; GE 1176 12v for 220v lecterns.
DIGITAL CLOCK/COUNT DOWN TIMER
Select desired mode; adjust time with SET switch. Unit
will remain operational as long as the main power supply
is on. Power interruptions will cause the clock to NOTE:
flash until reset.
ALL MODELS
OPTIONAL HEIGHT ADJUSTMENT
Models with optional reading surface adjustment are
controlled by the switch marked HEIGHT and provide up
to 8 - 9 inches of elevation. To raise or lower, depress
HEIGHT switch.
SOUND MODELS
until feedback begins, then decrease volume to stable
condition or lower to desired volume level. Adjust bass
and treble controls to desired tonal quality. Turn
SPEAKER SWITCH to position when done using the "off"
sound system.
AUXILIARY MICROPHONE (XLR JACK)
The auxiliary mic input is located under the reading sur-
face and is used for a second mic or wireless micro-
phone input. The volume control is located on the dash
panel. The aux. mic input is balanced low impedance
(600 ) and is phantom powered so condenser type mi-Ω
crophone can be used.
AUXILIARY LINE INPUT (1/4" PHONE JACK)
The auxiliary input is used for playback of tape player,
musical instrument, VCR, or an audio feed from another
sound system. The volume control is located on dash
panel.
AUXILIARY LINE OUTPUT (1
/4" PHONE JACK)
The signal output is a composite of all the inputs and can
be fed directly to an audio or video tape recorder. Or, the
line output can be fed to another sound system to com-
bine systems for greater output, or it may be fed to the
input of a hearing impaired system.
EXTERNAL SPEAKER OUTPUTS (1/4" PHONE JACK)
The external speaker outputs can be used to drive exter-
nal speakers in lieu of the internal lectern speaker. When
a plug is inserted into the external speaker jacks, the in-
ternal speaker is disconnected. The powerful (50 watts)
is adequate to drive several speakers provided the total
load impedance is not less than 2 ohms. The output of
the amplifier is self-protecting against overload; how-
ever, low impedance loads (below 2 ) will cause exces-Ω
sive heating reducing amplifier output.
To remove lectern top from projector stand base, discon-
nect power cord and turn the black knob (located under
the middle shelf) counter-clockwise until disengaged. Lift
off lectern top and place in desired location.
Projector stand base features a 110/120 VAC Duplex re-
ceptacle for equipment. Plug line cord into approved
3-wire 110/120 V outlet. To assemble, reverse this proce-
dure.
STACKING MODELS
The Da-Lite sound system is modular in design for ease
of service. The power supply and amplifier are accessed
inside the lectern body. The controls are accessed by re-
moval of dash panel.
If your lectern fails to operate on a known power source,
be sure to check the circuit breaker located on the
Power Supply for a tripped condition. Reset to restore
function. If breaker continues to trip, discontinue use of
product until problem can be diagnosed.
SERVICE
2


Produktspezifikationen

Marke: Da-Lite
Kategorie: Nicht kategorisiert
Modell: Lancaster 85450

Brauchst du Hilfe?

Wenn Sie Hilfe mit Da-Lite Lancaster 85450 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Da-Lite

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-