CRUX SWRTY-61N Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für CRUX SWRTY-61N (3 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020320
SWRTY-61N
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
1 of 3
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Toyota vehicles while funconing with an aermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognion (VR) feature from SWC on select radios.
- Retains OEM Rear View Camera.
- Retains factory USB and auxiliary audio input (aermarket radio must have these features).
- Includes factory USB retenon adapter cable.
- Supports BT-HF/A2DP/AVRCP prole on select aermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- EIA color coded wiring for easy installaon.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRTY-61N MODULE SWRTY-61N HARNESS USB Retenon Cable SWC CABLE
AFTERMARKET
RADIO
SWRTY-61N
MODULE
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Orange
Not Used Blue/ White
SWC for Kenwood/JVC Blue/Yellow
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Vehicle Speed Sense (VSS) Red/Black
Reverse Trigger Red/White
Parking Brake (see special note below) Yellow/Black
Power Antenna Blue
Audio Input
Red/White RCA
(Retains Factory AUX Input
in Select 2007-Up Vehicles)
TO FACTORY
HARNESS
12-Pin Black
Connector
28 PIN
10 PIN
6 PIN
USB-TY01
USB Retention Adaptor
(included in kit)
Blue / Antenna Turn On
ANTENNA ADAPTOR
(Included in Kit)
Blue / Antenna Turn On
NOTE:
The BLUE Antenna Turn-On wire
should ONLY be connected to
one circuit of the aftermarket
radio. Choose the one which has
a wire populated on the factory
connector side.
24 PIN
Yellow RCA
(Retain OE Camera)
Rear View Camera Signal
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
TOYOTA
SWC SETTING
(OFF ON OFF ON)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
To aftermarket
radio SWC port
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0203202 of 3
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
SWRTY-61N
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
DIP SWITCH SETTINGS:
TOYOTA STEERING WHEEL CONTROL DIP SWITCH SETTING:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
RADIO BRAND: DIP: 1 2 3 4
Atoto, Dual, Farenheit, Jensen, Pioneer
Power Acoustik, Soundstream
Blaupunkt, Most o-brand Radios
Alpine
Clarion
Kenwood
JVC
Boss, Old Sony
New Sony
OFF OFF ON ON
OFF OFF ON ON
OFF OFF ON ON
OFF OFF OFF OFF
OFF ON ON OFF
OFF ON ON ON
OFF ON OFF ON
OFF ON OFF OFF
OFF OFF ON OFF
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios,
check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
DIP: 5 6 7 8
Toyota OFF ON OFF ON
SWC MODULE
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
SPECIAL NOTE:
On 2013 Toyota Sequoia and Tundra, the parking brake wire (RED wire) is in posion#1 on the OEM 28-pin connector. Please
insert the YELLOW/BLACK wire on the SWRTY-61N harness into posion#1. For all other models, please insert into posion# 15.
Please check that you are inserng the pin into the correct locaon as it is dicult to remove it again. The locking tab of the pin
should be facing UP when it is inserted into the connector.
For 2013 Sequoia & Tundra
For all other models
Pin#1
Pin#15
SWRTY-61N
28-Pin Connector
(wire view)
NOTE: Insulate the Blue/Yellow wire or the 3.5mm plug if not being used.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
RED to SWC Key 1
WHITE to SWC Key 2
SHIELD to SWC Ground
For aermarket radios that have wires for SWC connecons, cut o the 3.5mm plug on the Crux SWC Cable and connect the
SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.
VEHICLE APPLICATIONS:
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.0203203 of 3
RADI O REPLAC EMEN T
SWC R ETENT IO N
+
R
INTERFACING SOLUTIONS
SWRTY-61N
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
24 TO 16 PIN ADAPTER:
Some vehicles do not have the 24-Pin Video Input connector. Instead, they have a 16-Pin connector that controls the
video input for the camera. Use the oponal adaptor and connect to the T-harness to convert the harness to work with
the 16-Pin connector style.
16-PIN
(male plug)
24-PIN
(male plug)
TO SWC HARNESS TO FACTORY RADIO
RED / PARKING BRAKE
(Use instead of Yellow/Black Wire on Main Harness)
TOYOTA
2013 - 2019 4Runner
2012 - 2018 Avalon
2012 - 2017 Camry
2012 - 2017 Corolla
2013 - 2018 Highlander*
2012 Matrix
2012 - 2017 Prius
2012 - 2018 RAV4
2012 - 2018 Sequoia**
2013 - 2019 Tacoma
2013 - 2019 Tundra**
2012 - 2015 Venza
SCION
2012 - 2016 FRS
2016 iM
2012 - 2013 iQ
2012 - 2016 tC
2012 - 2015 xB
2012 xD
*Note: 2013-2018 Highlander vehicles without OEM Navigaon radio will NOT retain the factory back up camera.
** See Special Note on page 2.


Produktspezifikationen

Marke: CRUX
Kategorie: Nicht kategorisiert
Modell: SWRTY-61N

Brauchst du Hilfe?

Wenn Sie Hilfe mit CRUX SWRTY-61N benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert CRUX

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-