CRUX SOCVW-21 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr CRUX SOCVW-21 (1 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
front left speakers
front right speakers
rear left speakers
rear right speakers
constant
accessory
ground
amp on
MATCH LOOSE WIRES TO AFTERMARKET RADIO
TO FACTORY
HARNESS
AFTERMARKET
RADIO
40-PIN
(female plug)
12-PIN
Black = Ground
Red = Accessory (2A Max)
Yellow = Constant
Orange = Illumination (100mA Max)
Blue/White = Turn-On
White = Left Front (+)
White/Black = Left Front (-)
Gray = Right Front (+)
Gray/Black = Right Front (-)
Green = Left Rear (+)
Green/Black = Left Rear (-)
Purple = Right Rear (+)
Purple/Black = Right Rear (-)
Purple/White = VSS
Red/White = Reverse (100mA Max)
We recommend reading this installation guide before starting any
work. Following these instructions from “Start” to” Finish” will ensure
a smooth and hassle free installation. We telephone support M-F
9:00 AM – 5:00 PM PDT at 1 (855) 822-1348. We are here to help.
PARTS INCLUDED:
(1) Interface Module
(2) VW Harness
(1) Instruction Sheet
PRECAUTIONS:
- Remove the negative side of the battery to avoid any short circuits
during the installation.
- Do not install the interface near any major components or near the
HVAC system. This may cause damage or overheating to the vehicle.
PRELIMINARY:
Please read the entire manual before installing this interface.
Before installing this interface please review the options before
removing the factory radio. Some options may need to be adjusted
prior to removing the factory radio.
RADIO REPLACEMENT FOR SELECT VOLKSWAGEN VEHICLES 2002-UP
VOLKSWAGEN
2012 - 2014 Beetle
2009 - 2014 CC
2006 - 2012 Eos
2002 - 2014 Golf
2006 - 2014 GTI
2002 - 2014 Jetta
2002 - 2014 Passat
2006 - 2011 Rabbit
2009 - 2014 Tiguan
2004 - 2010 Touareg
IMPORTANT NOTES:
1. Driver information display will show the
last information that was shown prior to
removing the factory radio.
2. This interface does not retain the factory
Bluetooth or Sirius SAT radio.
3. The radio is designed to shut when
the key is removed.
2010 and Up vehicles with a premium
sound
system do not retain the RAP feature
SOCVW-21
WIRING COLOR CODES
The module has been rated for up to max of output. 2A
For applications demanding a continuous output of 3A or more,
we recommend using a standard BOSCH (SPDT) relay.
See your local car audio specialist.
Below is a diagram on how to install the BOSCH relay.
OVERVIEW OF INSTALLATION
CONNECT THE WIRES,
COLOR FOR COLOR.
INSTALLATION TIPS
1. Test the radio for power, turn the key to the “ON” position and
that the new radio is getting power. If no power, please
revise your wiring connections with multi-meter, available at your
local car audio dealer.
2. Test the installation by turning the vehicle to the “ON” position,
then back to the “OFF” position. Remove the key and that
the radio shuts
IMPORTANT:
DO NOT DISCONNECT THE AIRBAG CONNECTOR
BEHIND THE DASH PANEL WHILE KEY IS IN
THE IGNITION.
USING A RELAY
Rev. 050514


Produktspezifikationen

Marke: CRUX
Kategorie: Nicht kategorisiert
Modell: SOCVW-21

Brauchst du Hilfe?

Wenn Sie Hilfe mit CRUX SOCVW-21 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert CRUX

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-