CRUX CS-GM43 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr CRUX CS-GM43 (3 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/3
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.03252022
1 of 3
- Retains chime functions.
- Pre-programmed to retain factory Steering Wheel Controls
- RAP (Retained Accessory Power).
- Provides illumination and reverse outputs.
- Made for non-ampliîšżed vehicles or vehicles that will have their amps bypassed.
- Retains factory back-up camera. (Excluding Camaro (IOR) 2019-Up)
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
CS-GM43 MODULE CS-GM43R HARNESS CS-GM43S HARNESS SWC CABLE
CS-GM43
Radio Replacement Interface with Steering Wheel Control
Retention for GM Vehicles 2019 - Up
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
CS-GM43
Radio Replacement Interface with Steering Wheel Control
Retention for GM Vehicles 2019 - Up
2 of 3
OEM CAMERA RETENTION:
The CS-GM43 has a potenîžźometer to adjust the chime vol-
ume. It is set at half way by default. To adjust the volume,
simply use a suitable screw driver and turn the potenîžźometer
clockwise to increase the volume and counter-clockwise to
decrease the volume.
Chime
Volume
Adjustment
CHIME VOLUME ADJUSTMENT:
DIP SWITCH SETTINGS:
AFTERMARKET RADIO DIP SWITCH SETTINGS:
NOTE: Cap or Insulate the 3.5mm plug and Blue/Yellow wire if not being used.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
For aermarket radios that have wires for SWC connecons,
cut oîś« the 3.5mm plug on the Crux SWC Cable (opîžźon B)
and connect the SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.
rev.03252022
The CS-GM43 is prewired with an RCA connector to retain the OEM camera on vehicles with a IOR system.
1. Connect Yellow video RCA to the new aermarket radio reverse camera input.
2. Test the video feed before installing the radio back into the dashboard. (Radio may need to be set prior to tesîžźng)
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
CS-GM43
Radio Replacement Interface with Steering Wheel Control
Retention for GM Vehicles 2019 - Up
3 of 3
VEHICLE APPLICATIONS:
rev.03252022
2019-Up
2019-Up
2019-Up
2019
2019-Up
2019-Up
2019-Up
2019-Up
2019-Up
2019
Chevrolet
Blazer*
Camaro*
Colorado
Cruze
Equinox*
Malibu*
Silverado*
Sonic
Spark
Volt
2019-Up
2019-Up
2019-Up
2019-Up
GMC
Acadia*
Canyon
Sierra 1500*
Terrain*
2019-Up
Cadillac
XT4
NOTES:
- Does not retain Bose amplier.
- Does not retain OnStar.
Compaîžźble with the following radio codes: IOR, IOS, IOT, or IOU
NOTE: The radio code can be found in the Glove Box.
NOTE: Newer model GM vehicles are now using a QR code label. If the Service Parts Idencaon Label is not located in
the Glove Box, reference the Vehicle Cercaon Label on the driver’s door jam opening for the QR code.
*USE GM49R-EXT or GM49S-EXT, 5 foot Extension Harness is used with GM IOR, IOU or IOS in cases where the Radio Control
Module is located at front passenger side (by the door hinge). Sold separately.


Produktspezifikationen

Marke: CRUX
Kategorie: Nicht kategorisiert
Modell: CS-GM43

Brauchst du Hilfe?

Wenn Sie Hilfe mit CRUX CS-GM43 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert CRUX

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-