BeamZ S700 160.438 Bedienungsanleitung
Lesen Sie kostenlos die đ deutsche Bedienungsanleitung fĂŒr BeamZ S700 160.438 (12 Seiten) in der Kategorie Wir. Dieser Bedienungsanleitung war fĂŒr 13 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/12
Ref. Nr. 160.438
S700
SMOKE MACHINE
INSTRUCTION MANUAL
GEBRUIKSAANWIJZING
BEDIENUNGSANLEITUNG
V1.1
- 2 -
- 3 -
Warning:
- The smokemachine must be placed at least 100 cm away from inflammable materials such as curtains,
books, etc. Make sure that the housing cannot be touched by accident.
- Use only Beamz water-based smoke fluid recommended by your dealer.
- Poor smoke liquid caused permanent damage, bad effect, clogging, spitting of unevaporated liquid etc.
- Never add flammable fluids (oil, gas, perfume) to the fog liquid.
- Always keep enough smoke liquid in the tank.
Use of the device without liquid will cause damage to the pump and heater.
- Do not obstruct the openings on top of the case to guarantee a good ventilation.
- Donât put any objects on the smoke machine.
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the first use, have the unit checked by a qualiïŹed person.
- The unit contains voltage carrying parts. DO NOT open the smokemachine
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It
needs to be repaired by a qualiïŹed technician.
- Only connect this unit to an earthed mains outlet of 220-240Vac/50Hz .
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please
let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a
steel cable, etc. which has to be fastened separately from the mounting bracket.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings
must be fulfilled.
- Keep out of the reach of children.
Location
Select a location where it is easy to fill the tank. It is also possible to hang the unit by means of the supplied
holder and fixing screws.
Installation and Use
Unpack the fog machine. Fill the fluid tank by means of a funnel. Plug the unit into a mains outlet. Thus the
heating element is automatically switched on. Depending on the room temperature, it takes about 2 minutes
until the working temperature is reached. Then the thermostat is clicking and the LED on the manual control
lights up. Push the switch once and the smoke machine will produce a nice thick fog. Once the smoke machine
has reached its working temperature (the LED is lit) the smoke machine can produce fog for a while. After this
period of time, the fog generator is cooled so much down that the thermostat switches off. Wait a while until the
working temperature is reached again. It is recommended to produce smoke with small pauses in between so
that the temperature is maintained and the thermostat doesnât switch off.
Make sure that there is always enough liquid smoke contained in the tank. Use of the smoke machine without
liquid can permanently damage the unit. Once the smoke machine generates little smoke or pump generate
another 'rattling' sound i turn off the unit direct. Check the fluid level and fill the tank when it is empty, check the
hose and filter blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists,
switch unit direct off to prevent further damage and contact your dealer.
Switching the unit off
Switch the unit off by unplugging it from the mains. Otherwise the 700W heating element will draw unnecessarily
current.
Produktspezifikationen
| Marke: | BeamZ |
| Kategorie: | Wir |
| Modell: | S700 160.438 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit BeamZ S700 160.438 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Wir BeamZ
31 Juli 2024
29 Juli 2024
25 Juli 2024
24 Juli 2024
16 Juli 2024
9 Juli 2024
8 Juli 2024
Bedienungsanleitung Wir
- Wir Crivit
- Wir Clatronic
- Wir G3 Ferrari
- Wir Ernesto
- Wir Tristar
- Wir Hama
- Wir Sunbeam
- Wir Bestron
- Wir Gastroback
- Wir Russell Hobbs
- Wir Steba
- Wir Tefal
- Wir IKEA
- Wir Black And Decker
- Wir Ryobi
- Wir Cuisinart
- Wir Fritel
- Wir Graef
- Wir Kenwood
- Wir Krups
- Wir Moulinex
- Wir Waring Commercial
- Wir Exquisit
- Wir Bartscher
- Wir Continental Edison
- Wir Livoo
- Wir Hazet
- Wir Kalorik
- Wir Team
- Wir Toolcraft
- Wir Wolf
- Wir Victorinox
- Wir HQ Power
- Wir Swan
- Wir Hamilton Beach
- Wir Oster
- Wir Girmi
- Wir Nutrichef
- Wir Underwater Kinetics
Neueste Bedienungsanleitung fĂŒr -Kategorien-
3 Oktober 2024
30 September 2024
29 September 2024
24 September 2024
12 September 2024
7 September 2024
7 September 2024
7 September 2024
5 September 2024
4 September 2024