Trek Powerfly FS 4 Gen 2 Bedienungsanleitung

Trek Fiets Powerfly FS 4 Gen 2

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Trek Powerfly FS 4 Gen 2 (10 Seiten) in der Kategorie Fiets. Dieser Bedienungsanleitung war für 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/10
2021 POWERFLY FULL SUSPENSION
SERVICE MANUAL SUPPLEMENT
Table of Contents
Install the rear fender and rear rack 1
Install the rear mini fender 2
Install the front fender 2
Remove the rear shock 3
Install the rear shock 4
Install the rear derailleur hanger 5
Cable routing 6
Remove the early Bosch RIB system 7
Install the early Bosch RIB system 9
Remove the new RIB system 10
Install the new RIB system 11
Bosch drive unit removal/installation 15
Aftermarket spec limitations 15
 2021PoweryFullSuspensionservicemanualsupplement
NOTE This manual has the unique design
features and components for the 2021 Powery
FS bicycle.
2
 2021PoweryFullSuspensionservicemanualsupplement
Install the rear mini fender
1. Remove the rear wheel.
2. Use the two M5x0.8x14mm bolts and at
washers to attach the mini fender to the two
holes at the top of the seatstay.
NOTE Make sure these bolts have
threadlocker applied.
a. If you are reusing these bolts, clean
with isopropyl alcohol and apply Loctite
242 threadlocker or similar prior to
attachment.
3. Torque the bolts to 6Nm.
TWO BOLTS
& WASHERS
MINI FENDER
Install the front fender
NOTE The 27.5 model has a different
front fender than the 29er model.
1. Use an M5 bolt and washer to attach the
U-shaped front fender strut to the fender.
LOWER FORK
ARCH
FENDER STRUT
STRUT TO
FRONT FORK
2. Torque the bolt to 2.5Nm.
3. Use an M6 bolt to attach the fender and strut
assembly to the lower fork arch.
NOTE Make sure the lower fork arch bolt
has threadlocker applied.
a. If you are reusing the fork arch bolt,
clean with isopropyl alcohol and apply
Loctite 242 threadlocker or similar prior
to attachment.
4. Torque the bolt to 9Nm.
5. Use two M5 bolts to attach the struts to the
front fork.
NOTE Make sure the strut bolts have
threadlocker applied.
a. If you are reusing the strut bolts, clean
with isopropyl alcohol and apply Loctite
242 threadlocker or similar prior to
attachment.
6. Torque the strut bolts to 6Nm.

Produktspezifikationen

Marke: Trek
Kategorie: Fiets
Modell: Powerfly FS 4 Gen 2

Brauchst du Hilfe?

Wenn Sie Hilfe mit Trek Powerfly FS 4 Gen 2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Fiets Trek

Bedienungsanleitung Fiets

Neueste Bedienungsanleitung für -Kategorien-