Sony Walkman WM-FX490 Bedienungsanleitung

Sony Kassettenspieler Walkman WM-FX490

Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Sony Walkman WM-FX490 (2 Seiten) in der Kategorie Kassettenspieler. Dieser Bedienungsanleitung war fĂĽr 5 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
2-583-956- (1)11
Radio
Cassette Player
© 2005 Sony Corporation Printed in China
WM-FX490
Operating Instructions
“WALKMAN” is a registered trademark of Sony Corporation to
represent Headphone Stereo products.
is a trademark of Sony Corporation.
Preparations A
To Insert Battery
Slide and open the battery compartment lid,
and insert one R6 (size AA) dry battery with
correct polarity.
Replace the battery with new one when “ ”
flashes on the display.
To attach the battery compartment
lid, if it is accidentally detached
Attach it as illustrated.
Playing a Tape B
1If the HOLD function is turned on, slide the
HOLD switch in the opposite direction of
the G mark to unlock the controls.
2Insert a cassette.
3Press Y (play)•DIRECTION.
Adjust the volume with VOL.
Note on the cassette holder
When opening the cassette holder, press the x button
and make sure the tape is stopped by checking through
the cassette window, then slide the OPEN switch.
If the cassette holder is opened before the tape is
stopped, the tape may loosen and be damaged.
To Press
Switch playback to Y•DIRECTION during
the other side playback
Stop playback x•RADIO OFF
Fast forward FF during stop
Rewind REW during stop
Play the same side from REW during playback
the beginning (Auto
Play function)
Play the other side from FF during playback
the beginning (Skip
Reverse function)
To select playback mode
Press MENU repeatedly to set the cursor to MODE
on the display.
Then press SET to select the desired mode.
To play Select
Both sides repeatedly s
Both sides once from d
the side facing the
cassette holder
Using Other Functions
To lock the controls
Set the HOLD switch to the direction of the markG
to lock the controls.
To emphasize bass sound
Press MENU repeatedly to set the cursor to MB
(MEGA BASS) on the display. Then, press SET to
show “ ”. With each press, the indications changez
as follows:
z : emphasizes bass sound (MEGA BASS)
No message: off (normal)
Notes
•If the sound is distorted with the mode “MB”, turn
down the volume of the main unit or select normal
mode.
•Bass emphasis may not show great effect if the
volume is turned up too high.
To protect your hearing—AVLS
(Automatic Volume Limiter
System)
When you set the AVLS function to active, the
maximum volume is kept down to protect your
ears.
Press MENU repeatedly to set the cursor to AVLS
on the display. Then press SET to show “z”.
Note
The AVLS function will be cancelled when you replace
the battery.
Listening to the Radio B
1If the HOLD function is turned on, slide the
HOLD switch in the opposite direction of
the G mark to unlock the controls.
Make sure that the tape has stopped
completely.
2Press FM or AM to select the desired band
and to turn on the radio.
3Press PRESET/TUNING + or – to tune in to
the desired station.
If the signal is strong, you can scan for
stations. Press MENU repeatedly to set the
cursor on the display to TUNE MODE and
press SET to display “MANUAL”. Then
hold down PRESET/TUNING + or – for a
few seconds.
To turn off the radio
Press x•RADIO OFF.
To improve broadcast reception C
• Extend the headhones/earphones cordFor FM:
(antenna). If the reception is still not good, press
MENU repeatedly to set the cursor on the display
to FM MODE. Then press SET to switch between
“LOCAL” and none (DX), or “MONO” and none
(stereo) for best reception.
•For AM: Reorient the unit itself.
(turn over)
A
B
C
* There is a tactile dot beside VOL on the main unit to show
the direction to turn up the volume.
** The button has a tactile dot.
i
FWD
REV
OPEN
HOLD
MENU
SET
VOL*
FF•PRESET/
TUNING+
Y•DIRECTION**
FM
AM
x•RADIO OFF
REW•PRESET/
TUNING –
HOLD
MENU
SET
Presetting Radio Stations
D
You can preset up to 40 stations, 35 for FM and 5 for
AM.
Presetting Automatically Scanned
Stations
1Press FM or AM to select the desired band.
2Press and hold ENTER for more than 3
seconds.
Preset number 1 will flash on the display
and the Walkman starts scanning the
stations from the lower frequencies and
stops for about 5 seconds when a station is
received.
3If you wish to preset the currently received
station, press ENTER while the preset
number is flashing.
The received station is preset on preset
number 1 and the unit starts scanning for
the next receivable station.
4Repeat step 3 until all receivable stations
are preset.
To stop scanning
Press x•RADIO OFF. The radio is turned off at the
same time.
Notes
• If stations are already stored, the newly preset stations
replace the old ones when the above procedure is
completed.
• If stations cannot be preset automatically, preset them
manually.
Presetting Stations Manually
1Press FM or AM to select the desired band.
2Press ENTER.
The frequency digits will flash on the
display.
3While the frequency digits are flashing,
tune in to a station you wish to store using
PRESET/TUNING + or – and press
ENTER.
The preset number will flash on the
display.
4While the preset number is flashing, select
the preset number you want using
PRESET/TUNING + or – and press
ENTER.
Notes
• If you cannot complete step 3 or 4 while the indicators
are flashing, repeat from step 2.
• If a station is already stored, the new station replaces
the old one.
Playing the preset radio stations
1Press FM or AM to select the desired band.
2Press MENU repeatedly to set the cursor on
the display to TUNE MODE. Then press
SET to display “PRESET”.
3Press PRESET/TUNING + or –.
To cancel a stored station
1Follow the procedure above and in step 3, select
the preset number you want to cancel and then
press ENTER. The frequency digits will flash on
the display.
2Press and hold PRESET/TUNING + or –. The
frequency digit starts running up or down. Keep
holding down the button until “- - - -” is displayed.
3Press ENTER while “- - - -” is flashing. A preset
number will flash on the display.
4Press ENTER to cancel the stored station.
Scanning the preset radio stations
— DAPS (Digital Auto Preset Scanning)
1Press FM or AM to select the desired band.
2Press and hold FM or AM pressed in step 1
for 2 seconds or more.
The preset stations of the selected band will
be played for about 5 seconds each. (During
DAPS the indicators on the display flash.)
3Press FM or AM again to select the station
while the desired preset station is being
played.
Notes
• If there are no stations stored, the DAPS function does
not work.
• Until a station is selected in step 3, the DAPS function
turned on in step 2 will continue.
• In step 2 or 3, if you select a band which you did not
select in step 1 by pressing FM or AM, the newly
selected band will be played normally.
D
Enjoying Your Favorite Radio
Stations — DSB (Direct Station Buttons)
You can preset up to 5 of your favorite stations on
the Direct Station Buttons (1 - 5) and play a station
of your choice just by pressing the corresponding
button.
1Press FM or AM to select the desired band.
2Tune in to the desired station.
3Hold down one of the Direct Station
Buttons (1 - 5) to which you want to assign
the station for 2 seconds.
When the station has been preset
successfully, the beep sounds and the
indication “F1”, “F2”, “F3”, “F4” or “F5”
appears on the display.
To play a preset radio station (DSB)
You can listen to the station you want by pressing
the buttons (1 - 5) without selecting the band.
Make sure that the tape has stopped completely.
Note
If 5 stations are already stored on the Direct Station
Buttons, the newly preset station replaces the old one
when the above procedure is completed.
Precautions
On batteries
• Do not carry dry batteries with coins or other metallic objects.
It can generate heat if the positive and negative terminals of
the batteries are accidentally contacted by a metallic object.
• When you are not going to use your Walkman for a long time,
remove the battery to prevent damage from battery leakage
and corrosion.
On handling
• Do not leave the unit in a location near heat sources, or in a
place subject to direct sunlight, excessive dust or sand,
moisture, rain, mechanical shock, or in a car with its windows
closed.
• We do not recommend the use of tape longer than 90 minutes.
They are very thin and tend to be stretched easily. This may
cause malfunction of the unit or sound deterioration.
• The LCD display may become hard to see or slow down when
using the unit at high temperatures (above 40°C) or at low
temperatures (below 0°C). At room temperature, the display
will return to its normal operating condition.
• If the unit has not been used for a long time, set it in the
playback mode to warm it up for a few minutes before
inserting a cassette.
On headphones/earphones
Road safety
Do not use headphones/earphones while driving, cycling, or
operating any motorized vehicle. It may create a traffic hazard
and is illegal in some areas. It can also be potentially dangerous
to play your headphones/earphones at high volume while
walking, especially at pedestrian crossings.
You should exercise extreme caution or discontinue use in
potentially hazardous situations.
Preventing hearing damage
Do not use headphones/earphones at high volume. Hearing
experts advise against continuous, loud and extended play. If
you experience a ringing in your ears, reduce volume or
discontinue use.
Caring for others
Keep the volume at a moderate level. This will allow you to hear
outside sounds and to be considerate to the people around you.
On maintenance
• Clean the tape head and tape path using a cotton swab and
commercially available cleaning solvent after every 10 hours
of use.
• To clean the exterior, use a soft cloth slightly moistened in
water. Do not use alcohol, benzine or thinner.
• Clean the headphones/earphones plugs periodically.
Troubleshooting
The display shows incorrect information.
• The battery is weak. Replace the battery with new one.
The display and the operation are not normal.
• Remove the power sources for 15 seconds or more, and then
set them again.
* The button has a tactile dot.
ENTER
PRESET/TUNING+
1, 2, 3*, 4, 5 FM
AM
PRESET/TUNING–
i
SET
MENU
x•RADIO OFF
Specifications
• Frequency range
FM: 87.5 - 108 MHz
AM: 531 - 1 602 kHz
• Output
Headphones ( ) jacki
Load impedance 8 - 300 Ω
• Power requirements
One R6 (size AA) battery: 1.5V DC Ă— 1
• Dimensions (w/h/d)
Approx. 81.1 Ă— 111.2 Ă— 29.3 mm, excl. projecting parts and
controls
• Mass
Approx. 137 g (main unit only)
• Supplied accessories
Stereo headphones or earphones (1)
Hand strap (1)
Design and specifications are subject to change without
notice.
Battery life* (approximate hours)
Sony alkaline Sony R6P
LR6 (SG)** (SR)
Tape playback 35 9
Radio reception 40 14
* Measured value by the standard of JEITA (Japan Electronics
and Information Technology Industries Association).
(Using a Sony HF series cassette tape)
**When using a Sony LR6(SG) alkaline dry battery (produced
in Japan).
Note
• The battery life may be shorter depending on the operating
condition, the surrounding temperature and battery type.


Produktspezifikationen

Marke: Sony
Kategorie: Kassettenspieler
Modell: Walkman WM-FX490

Brauchst du Hilfe?

Wenn Sie Hilfe mit Sony Walkman WM-FX490 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Kassettenspieler Sony

Bedienungsanleitung Kassettenspieler

Neueste Bedienungsanleitung fĂĽr -Kategorien-