Sony BTA-NW1 Bedienungsanleitung
Sony
Sonstiges Kamerazubehör
BTA-NW1
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Sony BTA-NW1 (36 Seiten) in der Kategorie Sonstiges Kamerazubehör. Dieser Bedienungsanleitung war für 17 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/36
3-070-124-11 ( )2
Modem Adaptor
with Bluetooth™
Function
Operating Instructions
Before operating the unit, please read this manual thoroughly, and retain
it for future reference.
Owner’s Record
The model and serial numbers are located on the bottom. Record the serial
number in the space provided below. Refer to these numbers whenever
you call upon your Sony dealer regarding this product.
BTA-NW1
© 2001 Sony Corporation
Model No. BTA-NW1
Serial No.
GB
Mode d’emploi FR
2-GB
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
Countries and areas
This product is intended to be used in the following countries or areas.
Australia, Austria, Belgium, Canada, Denmark, Finland, France, Germany, Greece,
Hong Kong, Ireland, Japan, Luxembourg, Netherlands, New Zealand, Norway,
Portugal, Singapore, Sweden, Switzerland, UK, USA
This product is intended to be in indoor use only in Canada and France.
Regulatory Information
For the Customers in the USA
CAUTION
You are cautioned that any changes or modifications not expressly approved in this
manual could void your authority to operate this equipment.
To comply with FCC RF exposure compliance requirements, a separation distance of at
least 20 cm must be maintained between enclosure of this equipment and all persons.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Part 68
This equipment (MDM-5614G exclusive modem card) complies with Part 68 of the FCC
rules. On the bottom of this equipment is a label that contains among other information,
the FCC equivalence number (REN) for this equipment. If requested, this information
must be provided to the telephone company.
This modem uses the USOC RJ-11 telephone jack.
3-GB
The REN is used to determine the quantity of devices which may be connected to the
telephone line. Excessive RENs on the telephone line may result in the devices not
ringing in response to an incoming call. In most, but not all areas, the sum of the RENs
should not exceed five (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company
to determine the maximum REN for the calling area.
If the terminal equipment (
MDM-5614G exclusive modem card
) causes harm to the
telephone network, the telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn’t practical, the
telephone company will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operations of the equipment. If this happens, the
telephone company will provide advance notice in order for you to make the necessary
modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment (MDM-5614G exclusive modem card),
please contact 1-800-222-SONY (7669), or write to the Sony Customer Information
Service Center, 12451 Gateway Blvd., Fort Myers, Fl 33913 for repair and (or) warranty
information. If the trouble is causing harm to the telephone network, the telephone
company may request you remove the equipment from the network until the problem
is resolved.
Repair of this equipment should be made only by a Sony Service Center or Sony
authorized agent. For the Sony Service Center nearest you, call 1-800-222-SONY (7669).
This equipment cannot be used on public coin service provided by the telephone
company. Connection to Party Line Service is subject to state and possible provincial
tariffs. (Contact the state or provincial utility service commission, public service
commission or corporation commission for information.)
For the Customers in CANADA
Operating Condition
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding. Equipment
(or its transmit antenna) that is installed outdoors is subject to licensing.
INDUSTRY CANADA NOTICE
NOTICE: The Industry Canada label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protective,
operational and safety requirements as prescribed in the appropriate Terminal
Equipment Technical Requirements document(s). The Department does not guarantee
the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The equipment
must also be installed using an acceptable method of connection.
Produktspezifikationen
| Marke: | Sony |
| Kategorie: | Sonstiges Kamerazubehör |
| Modell: | BTA-NW1 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Sony BTA-NW1 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Sonstiges Kamerazubehör Sony
2 Oktober 2024
21 September 2024
8 September 2024
8 September 2024
16 August 2024
12 August 2024
10 August 2024
9 August 2024
6 August 2024
6 August 2024
Bedienungsanleitung Sonstiges Kamerazubehör
- Sonstiges Kamerazubehör Hama
- Sonstiges Kamerazubehör Panasonic
- Sonstiges Kamerazubehör Canon
- Sonstiges Kamerazubehör König
- Sonstiges Kamerazubehör Metz
- Sonstiges Kamerazubehör Olympus
- Sonstiges Kamerazubehör Nikon
- Sonstiges Kamerazubehör DJI
- Sonstiges Kamerazubehör Leica
- Sonstiges Kamerazubehör Hähnel
- Sonstiges Kamerazubehör Thinkware
- Sonstiges Kamerazubehör Digipower
- Sonstiges Kamerazubehör Axis
- Sonstiges Kamerazubehör Havis
- Sonstiges Kamerazubehör CamLink
- Sonstiges Kamerazubehör FeiYu-Tech
- Sonstiges Kamerazubehör Lastolite
- Sonstiges Kamerazubehör Xit
- Sonstiges Kamerazubehör Sevenoak
- Sonstiges Kamerazubehör Kata
Neueste Bedienungsanleitung fĂĽr -Kategorien-
2 Oktober 2024
4 September 2024
4 September 2024
4 September 2024
3 September 2024
3 September 2024
3 September 2024
3 September 2024
2 September 2024
2 September 2024