Saturn ST-CC7109 Bedienungsanleitung

Saturn Eisen ST-CC7109

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Saturn ST-CC7109 (17 Seiten) in der Kategorie Eisen. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/17

ST-CC7109

IRON

УТЮГ

ПРАСКА

IRON

Dear Buyer!

We congratulate you on having

bought the device under trade

name “Saturn”. We are sure that

our devices will become faithful

and reliable assistance in your

housekeeping.

Avoid extreme temperature

changes. Rapid temperature

change (e.g. when the unit is

moved from freezing temperature

to a warm room) may cause con-

densation inside the unit and a

malfunction when it is switched

on. In this case leave the unit at

room temperature for at least 1.5

hours before switching it on.If the

unit has been in transit, leave it

indoors for at least 1.5 hours be-

fore starting operation.

IMPORTANT SAFETY INSTRUCTIONS

When using your flatiron, basic safety

precautions should always be followed,

including the following:

READ ALL INSTRUCTIONS BEFORE

USING

1. Use iron only for its intended use.

2. To protect against a risk of electric

shock, do not immerse the iron in water

or other liquids.

3. The iron should always be turned to

Off before plugging or unplugging

from outlet. Never yank cord to discon-

nect from outlet; instead, grasp plug

and pull to disconnect.

4. Do not allow cord to touch hot sur-

faces. Let iron cool completely before

putting away. Loop cord loosely around

iron when storing.

5. Always disconnect iron from electrical

outlet when filling with water or empty-

ing and when not in use.

6. Do not operate iron with a damaged

cord or if the iron has been dropped or

damaged. To avoid the risk of electric

shock, do not disassemble the iron take

it to a qualified serviceman for examina-

tion and repair. Incorrect reassembly

can cause a risk of electric shock when

the iron is used.

7. Close supervision is necessary for any

appliance being used by or near chil-

dren. Do not leave iron unattended

while connected or on an ironing board.

It is not advised to use this appliance by

children under 14.

8. Burns can occur from touching hot

metal parts, hot water, or steam. Use

caution when you turn a steam iron

upside down – there may be hot water

in the reservoir.

9. If the malfunction indicator goes on,

the flatiron is not operating normally.

Disconnect from the power supply and

have the flatiron serviced by qualified

service personnel.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not

operate another high wattage appliance

on the same circuit.

2. If an extension cord is absolutely

necessary, a 10-ampere cord should be

used. Cords rated for less amperage

may overheat. Care should be taken to

arrange the cord so that it cannot be

pulled or tripped over.

SAVE THESE INSTRUCTIONS.

More specifically:

DO NOT let children or untrained per-

sons use the appliance without supervi-

sion.

NEVER immerse the iron, cable or plug

in any liquid.

DO NOT leave the hot iron touching fab-

rics or very inflammable surfaces.

DO NOT leave the appliance unneces-

sarily plugged in. Disconnect the plug

from the mains when the appliance is

not being used.

NEVER touch the appliance with wet or

damp hands.

DO NOT use the power cord or the ap-

pliance in order to pull the plug out of

the socket.

DO NOT leave the appliance exposed to

the weather (rain, sun, etc. ).

DO NOT leave the iron without supervi-

sion when it is connected to the power

supply.

DO NOT fill the reservoir with water

before removing the plug from the

socket.

PLEASE NOTE!

Do not use chemical additive, scented

substances or decalcifiers. Failure to

comply with the above-mentioned regu-

lations leads to the loss of guarantee.

DESCRIPTION OF DEVICE

(1). Spray organ

(2). Filler door

(3) Steam dial

(4). Spray button

(5). Shot-steam button

(6). Auto shot off indication light

(7). Supply cord

(8). Cord bushin

(9). Transparent water tank

(10). Thermostat knob for temperature

regulation

(11). Self-cleaning button

(12). Plate with steam vents

(13). Maximum filling level

(14). Water measure

ANTI-CALC SYSTEM

A special resin filter inside the water

reservoir softens the water and prevents

scale build-up in the plate. The resin

filter is permanent and does not need

replacing.

Please note:

Use tap water only. Distilled

and/demineralised water makes the

anti-calc system ineffective by altering

its physicochemical characteristics.

Do not use chemical additives, scented

substances or decalcifiers. Failure to

comply with the above-mentioned regu-

lations leads to the loss of guarantee.

ANTI-DRIP SYSTEM

With the anti-drip system, you can per-

fectly iron even the most delicate fab-

rics.

Always iron these fabrics at low temper-

atures. The plate may cool down to the

point where no more steam comes out,

but rather drops of boiling water that

can leave marks or stains. In these cas-

es, the Anti-drip system automatically

activates to prevent vaporization, so

that you can iron the most delicate fab-

rics without risk of spoiling or staining

them.

G E N E R A L I N S T R U C T I O N S

When using the iron for the first time,

you may notice a slight emission of

smoke and hear some sounds made by

the expanding plastics. This is quite

normal and it stops after a short time.

We also recommend passing the iron

over an ordinary cloth before using it for

the first time.

PREPARATIONS

Soft the laundry to be ironed according

to the international symbols on the

garment label, or if this is missing, ac-

cording to the type of fabric.

GARMENT

LABEL

FABRIC

TYPE

THERMOSTAT

REGULATION

synthetic

low tempera-

ture

silk -

wool

··

medium tem-

perature

Cotton -

linen

···

high tempera-

ture

Fabric not to be ironed

Start ironing the garments requiring a

low temperature.

This reduces the waiting times (the iron

takes less time to heat up than to cool

down) and eliminates the risk of scorch-

ing the fabric.

STEAM IRONING

Filling the reservoir

- Check that the plug is disconnected

from the socket.

- Move the steam selector (3) to “0”

[Fig. 1].

- Open the lid (2).

- Raise the tip of the iron to help the

water enter the opening without over-

flowing.

- Slowly pour the water into the reser-

voir using the special measure (15) and

taking care not to go over the maximum

level (about 300ml) indicated by “MAX”

on the reservoir [Fig. 2].

- Close the lid (2).

SELECTING THE TEMPERATURE.

- Put the iron in a vertical position.

- Put the plug in the socket.

- Adjust the thermostat knob (10) ac-

cording to the international symbol on

the garment label [Fig. 3]. The plate

temperature control light (9) indicates

that the iron is heating up. Wait until

the plate temperature control light goes

off before ironing.

Warning: during ironing, the plate tem-

perature control light (9) comes on at

intervals, indicating that the selected

temperature is maintained. If you lower

the thermostat temperature after iron-

ing at a high temperature, do not start

ironing until the plate temperature con-

trol light comes on again.

SELECTING THE STEAM.

The quantity of steam is regulated by

the steam selector (3).

- Move the steam selector to a position

between minimum and maximum de-

pending on the quantity of steam re-

quired and the temperature selected

[Fig. 1].

Warning: the iron gives off steam con-

tinuously only if you hold the iron hori-

zontally. You can stop the continuous

steam by placing the iron in a vertical

position or by moving the steam selec-

tor to “0”. As indicated on the thermo-

stat knob (11) and in the initial table,

you can only use steam at the highest

temperatures.

If the selected temperature is too low,

water may drip onto the plate.

SELECTING SHOT-STEAM AND

STEAM WHEN IRONING VERTICAL-

LY.

Press the shot-steam button (5) to gen-

erate a powerful burst of steam that can

penetrate the fabrics and smooth the

most difficult and tough creases. Wait

for a few seconds before pressing again

[Fig. 4].

By pressing the shot-steam button at

intervals you can also iron vertically

(curtains, hung garments, etc.) [Fig. 5].

Warning: the shot-steam function can

only be used at high temperatures. Stop

the emission when the plate tempera-

ture control light (9) comes on, than

start ironing again only after the light

has gone off.

DRY IRONING

To iron without steam, follow the in-

structions in section “steam ironing”,

leaving the steam selector (3) on posi-

tion “0”.

SPRAY FUNCTION

Make sure that there is water in the

reservoir. Press the spray button (4)

slowly (for a dense spray) or quickly (for

a vaporized spray) [Fig. 6].

Warning: for delicate fabrics, we rec-

ommend moistening the fabric before-

hand using the spray function (4), or

putting a damp cloth between the iron

and the fabric. To avoid staining, do not

use the spray on silk or synthetic fab-

rics.

CLEANING

Please note: before cleaning the iron in

any way, make sure that the appliance

plug is not connected to the socket.

Any deposits, starch residue or size left

on the plate can be removed using a

damp cloth or an unabrasive liquid de-

tergent.

Avoid scratching the plate with steel

wool or metallic objects.

The plastic parts can be cleaned with a

damp cloth then wiped over with a dry

cloth.

SELF-CLEANING

The self-cleaning feature cleans inside

the plate, removing impurities. We rec-

ommend using it every 10-15days. Di-

rections:

-Fill the reservoir up to the maximum

level indicated and set the steam selec-

tor

-Set the thermostat knob (11) to the

maximum temperature and wait for the

light (6) to turn off.

-Pull the plug out of the socket and hold

the iron horizontally over the sink.

-Hold the cleanout button (12) setting

until all the boiling water, steam, impu-

rities come out [Fig. 7].

-When the soleplate has cooled down,

you can clean it with a damp cloth.

HOW TO PUT IT AWAY

- Disconnect the plug of the iron from

the socket.

- Empty the reservoir by turning the

iron upside down and gently shaking it.

- Leave the iron to cool down complete-

ly.

- Roll up the power cord with the re-

winder [Fig. 8].

- Always put the iron away in a vertical

position.

ADVICE FOR GOOD IRONING

We recommend using the lowest tem-

peratures with fabrics that have unusual

finishes (sequins, embroidery, flush,

etc.).

If the fabric is mixed (e.g. 40% cotton

60% synthetics), set the thermostat to

the temperature of the fibre requiring

the lower temperature.

If you don’t know the composition of the

fabric, determine the suitable tempera-

ture by testing on a hidden corner of the

garment. Start with a low temperature

and increase it gradually until it reaches

the ideal temperature.

Never iron areas with traces of perspira-

tion or other marks: the heat of the

plate fixes the stains on the fabric, mak-

ing them irremovable.

The size is more effective if you use a

dry iron at a moderate temperature:

excess heat scorches it with the risk of

forming a yellow mark.

To avoid marking silk, woolen or syn-

thetic garments shiny, iron them inside

out.

To avoid marking velvet garments shiny,

iron in one direction (following the fibre)

and do not press down on the iron.

The heavier the washing machine is

loaded, the more garments come out

Produktspezifikationen

Marke:	Saturn
Kategorie:	Eisen
Modell:	ST-CC7109

Brauchst du Hilfe?

Wenn Sie Hilfe mit Saturn ST-CC7109 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten

Ihren Namen*

Deine E-Mail*

Schreiben Sie hier Ihre Frage

Bedienungsanleitung Eisen Saturn

Saturn ST-CC7109 Bedienungsanleitung

16 August 2024

Saturn ST-CC0211 Bedienungsanleitung

8 August 2024

Saturn ST-CC7138 Bedienungsanleitung

2 August 2024

Saturn ST-CC0215 Bedienungsanleitung

30 Juli 2024

Saturn ST-CC0217 Bedienungsanleitung

29 Juli 2024

Saturn ST-CC7136 Bedienungsanleitung

29 Juli 2024

Saturn ST-CC0213 Bedienungsanleitung

25 Juli 2024

Saturn ST-CC7130 Bedienungsanleitung

23 Juli 2024

Saturn ST-CC0214 Bedienungsanleitung

14 Juli 2024

Saturn ST-CC0229 Bedienungsanleitung

12 Juli 2024

Bedienungsanleitung Eisen

Neueste Bedienungsanleitung für -Kategorien-

Jata PL1028 Bedienungsanleitung

16 Oktober 2024

Swan SI5090N Bedienungsanleitung

16 Oktober 2024

Tefal FV9250 Program8 Bedienungsanleitung

16 Oktober 2024

Termozeta Lella Bedienungsanleitung

16 Oktober 2024

Imetec E9801 Bedienungsanleitung

16 Oktober 2024

Black And Decker IR1160NC Bedienungsanleitung

14 Oktober 2024

Alpina SF-1303 Bedienungsanleitung

13 Oktober 2024

Bosch TDI953222V Bedienungsanleitung

13 Oktober 2024

Day 72443 Bedienungsanleitung

12 Oktober 2024

Clatronic DBS 3001 Bedienungsanleitung

12 Oktober 2024