Pyle PHMD4 Bedienungsanleitung

Pyle Detektor PHMD4

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung fĂŒr Pyle PHMD4 (7 Seiten) in der Kategorie Detektor. Dieser Bedienungsanleitung war fĂŒr 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/7
1
Treasure Hunter Platinum
Weatherproof Pro etal Detector-M with
Integrated Circuitry Headphones
PHMD4
www.pyleaudio.com
The Treasure Hunter Platinum professional detector has all the circuitry built into the
headphones. me and weatherproof. It is a superior unit The tal detector is water resistant
made to last for years of treasure seeking fun for the professional or beginner.
OWNER'S MANUAL INSTRUCTION _____
2
SPECIFICATIONS
Operating Search Frequency: 2.4KHZ
Search- coil: 7.8 inch Concentric, Waterpr oof
Audio Frequency: 400HZ
Operating Environments: Land, Seaside, River, Rain, Shallow Water
Water Resistant: Detecting in rain and submergence accidental in water acceptable
Length: Adjustable from: 39.4 inch to 47.3 inch
Battery: a 9- (not included) volt Alkaline
Battery Life: Up to 20 hours
Low Bat tery Indicator: When the speaker sounds a long tone, it’s time to replace the
battery.
FEATURES
Your metal detector has all the circuitry built into the headphones. By eliminating a
control housing, weight of the detector is signiïŹcantly reduced and so is easy for you
to operate. the Treasure Hunter When you travel, also takes up very little room.
The metal detector utilizes sweep motion . search It means you have to move the
search metal-coil to ïŹnd your ts. targe
The me tal detector is water resistant, it can be used in rain and can be accidentally
dropped in water, but not used for scuba diving. t -However, he search coil can be
submerged in water.
ASSEMBLY
Assembling your metal detector is easy and requires no special tools. Just follow these
steps:
1. Rotate the stem’s lock nut clockwise to loosen it. the stem and align the holes Insert
on the then rotate the stem’s lock nut search- coil bracket and the stem,
counterclockwise to tighten it.( ) see Figure 1
3
2. - Wind the search coil cable around the stem. Use the nylon on the stem to fasten the
cable.(see Figure 2)
3. Rotate the stem’s lock nut clockwise to loosen it. Stand and stretch your arm,
holding your metal detector to make the search above the ground for - hovers coil
about 1 inch. Rotate the stem’s lock nut counterclockwise to tighten it.
4. Loosen the knob at the search-coil’s end, -and adjust the search coil angle to the
desired angle so that it is parallel with the ground. Then tighten the knob.
INSTALLING THE BATTERY
Your -metal detector operates with a 9 volt battery(not supplied).The battery
–compartment is headphones. located in the Please make sure the power switch is in
the “OFF” position before installing the battery. Place a coin into the slot on the
ear-cup and turn until the cup “pops” open exposing the battery compartment.( see
Figure 3)


Produktspezifikationen

Marke: Pyle
Kategorie: Detektor
Modell: PHMD4

Brauchst du Hilfe?

Wenn Sie Hilfe mit Pyle PHMD4 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Detektor Pyle

Bedienungsanleitung Detektor

Neueste Bedienungsanleitung fĂŒr -Kategorien-