Philips HTL8162 Bedienungsanleitung

Philips Soundbar HTL8162

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Philips HTL8162 (1 Seiten) in der Kategorie Soundbar. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
Warranty
1. Proof of purchase s ot omp ied with this warranty rd. i n acc an ca
2. The warranty card is not completed immediately after purchase.
3. The apparatus is not used according to this user manual.
4. Defects re used due to proper or reckless use. a ca im
5. Any repairs are done by persons other than Philips authorized service centre.
6. The serial number is tampered with.
7. Defects due to uses beyond ca control like light g, bnormal oltage or while tr sit to the nin a v in an
purchaser’s residence.
Product Sl. No.Model No.
Invoice Number Date of Purchase: / /
Customer’s Name and address:
PIN:
Always there to help you!
Visit us at www.support.philips.com
Helpline: 1800 425 6396
Email: india.callcentre@tpv-tech.com
(10 a.m. to 9 p.m. Mondays to Saturdays & 10
a.m. to 6 p.m. on Sundays)
Deal r e Name & S :tamp
This Philips soundbar is warranted against any defect due to defective materials or workmanship for 12 months
from the date of purchase, should a defect develop during the warranty, TPV Technology India Pvt. Ltd.,
its authorized service center in India.
FREE OF CHARGE at any of
System sipo tioning :
The subwoofer is recommended to be put
Helpful Hint:
- To avoid magnetic interference, do not position
the speakers, too close to your TV.
Playing the speakers and sub oow fer
Audio source / player
SOUNDBAR
The soundbar is recommended to be put on
the at desktop to get a better acoustic eect.
PAIR MUT E
TONE
VOL+
VOL-
AUD USB
BT ARC OPT
10987 11
总尺寸:660x173mm
工艺:风琴105G铜版纸 双面印刷
成品尺寸:110x86.5mm
成品正面: 成品背面:
Soundbar
HTL8162
User ma alnu
SOUNDBAR 2.1
H TL 8162
User manual
General information
Safety instructions
Plea r carefully t safety mark on back sidese ead he the
This mark is intended to alert the user from
the non isolated dangerous voltage within the
constitute a risk of electric shock to persons.
This mark is intented to alert the user for
important operating and servicing instruction.
Warnings
Avoid sustained periods on high-volume use, and
do not turn the volume to maximum level while using
high output signal, such as Mobile Phone or DVD,
etc., as this will cause distortion and may damage the
loudspeaker cones.
when not in use.
Do not open the cover or back panel to avoid
electrical shock or any other accidents. No user-
serviceable parts are inside.
Only for indoor use.
Plug the system to the AC outlet with the right voltage
marked on the back panel of the Subwoofer and soundbar.
The MAINS plug is used as the disconnect device, the
disconnect device shall remain readily operable.
Accessories
The product shall not be exposed to dripping or splashing
be placed on the product.
Connections
Soundbar back panel
Subwoofer back panel
Top panel operation Remote controls
* AVAILABLE IF CONNECTED* AVAILABLE IF CONNECTED
Bluet eraooth Op ting Instruction
1. R m Press S C key fro soundbar or re ote m control to Bluetooth mode;
2. the When selecting Bluetooth “bt.” in displaymode. “.” of will start bli king and you hear n will an audi ne o to
which ind s micate Bluetooth pairing ode.
3. obile mFor pairing with pho devne or other Bluetooth ices, se the dev med “Pharch ice na ilips HTL8162 an d
pair it. Once paired, “.of “bt.” slowly ash and come up with another audio tone. “.” of “bt.will stop ash
when playing music.
4. n Press a d hold con n con for 3 se ds from remote control i order to force dis nect the
. Bluetooth connection
Note: While using Bluetooth, if external call comes, then speaker s ystem goes in mute mode in
order cy m ato protect priva of obile phone user. Oper tion ce s resumes on the c iall dis on ected.c n
Troubleshooting
Problem Solution
1. No power.
2. No sound or distorted sound.
3. The remote control does not
function properly.
4. Low hum or buzz sound.
drive cannot be read.
6. Slow operation of the USB
Check if the AC power cord is properly inserted into the AC mains socket.
Adjust the volume / select the correct source to choose the equipment
that you want to hear through the system.
Reduce the distance between the remote control and the system. Replace
the batteries with new ones / Point the remote control directly towards the
IR sensor (located on front panel of the subwoofer) / Check that the batteries
Place the product as far away as possible from electrical devices that may be
causing interference / Check power supply voltage and consult electrician.
Drive is
7. BT not working. Reduce the distance or device is not paired.
Warning -
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty.
below before taking the system for repair. If you are unable to remedy the problem by following hints
mentioned in below table.
and play. / Take out USB drive and insert it again properly.
1.
2. PAIR
3. MUTE
4. VOL+
5.
6.
7.
8. VOL-
9. BT
10. ARC
11. OPT
12. AUD
13. USB
14. TONE
1. : Power ON or Standby mode.
2. PAIR:
Turn both soundbar and subwoofer on, they will pair automatically.
Suggest not to change the ID if speaker system is working ne.
a. In case they don't get paired, press "MUTE" and hold 5 seconds to reset,
choose any mode and then short press "PAIR" continuously until "1d"
show on display, switch the subwoofer o and red & blue light will ash
alternately after restart, press “PAIR” to conrm the connection, the
subwoofer LED will go to solid blue when successfully connected.
b. How to change frequency ID: “CHxx” will show on display after long press
“PAIR”, press again to select the ID, subwoofer blue LED will ash and stay
solid blue once successfully paired.
3. MUTE: Turn volume o, short press again to activate.
4. VOL+: To increase the Volume by short or long press VOL+.
5. : Play the previous song by pressing “ ” but not in audio mode.
6. : Play/pause in USB*/BT mode and MUTE in audio mode.
7. : Play next song by pressing “ ”, but not in audio mode.
8. VOL-: To decrease the Volume by short or long press VOL-.
9. BT: Bluetooth mode.
10. ARC: HDMI ARC mode.
11. OPT: Optical mode.
12. AUD: Audio input mode.
13. USB: USB* mode.
14. TONE: Press to adjust Bass&Treble settings by using VOL+/-buttons.
Bass&Treble levels:-6(min) +6(max).~
(1)
(2)
(8)
(4)
(5)
(9)
(14)
(12)
(3)
(7)
(10)
(11)
(13)
(6)
1. AC Power cord.
2. Input Connect to sound sources
such as computer, CD player, MP3, etc.
3. Optical Input.
4. USB* slot.
5. HDMI ARC Input.
(5) (7)(6)
(2)(1) (5)(3) (4)
Item Remote control User manual
Quantity 1
2RCA- 2RCA cable
1 1 1
Optical cable
1
Power cable
Total system power 160W RMS
Soundbar power 40W p1-x2 RMS
Subwoofer power 80W RMS
Separation
SNR
Audio input socket 2RCA- 2RCA cable
Power consumption 34.3 W
Subwoofer 1 Way
Speaker size 8 inches
Impedance 4 Ohm
Frequency range 60Hz - 150Hz
Dimension (mm) W x H x D 240x 420 x 240
Weight kg6.37
Soundbar
Speaker size
Impedance
Frequency range
Product D ensio m W Dim n ( m) x H x
Net Weight
BT versio V5. n 0
960x 70.5 x 108
2 Way
4070 * 4
4 Ohm
140Hz - 20KHz
3.13 kg
BT range
USB max capacity
playability
Up to 32GB
Up to 10 meters
MP3 track
>55db
>40db
Care and safety information
Avoid high temperatur , mo ture, water and stes is du
Apparatus should not be exposed to dripping or
splashing of liquid.
Do not place any source of danger on the Subwoofer,
Do not install near heat sources.
Do not block any ventilation opening
Place the apparatus in a location with adequate
ventilation to prevent internal heat build up. Allow at
least 10cm (4 inches) of free space all around the
apparatus for adequate ventilation.
At high volume the back cover of Subwoofer becomes
hot. Do not touch it.
Care of the cabinet
Use a soft cloth slightly moistened to clean the cabinet.
Do not use a solution containing alcohol, spirits,
ammonia or abrasives.
Attentio should be draw to the environmental n n
aspects of batter disposal.y
Batteries shall not be exposed to e essive heat such s xc a
***Do NOT use US B for c har ging devices which can caus e damage to
you exter nal devic er s.thank you.
U S B
(1) (5)(3)
(2) (4) (6)
(7)
1. : Power or standby mode.
2. SRC: Change the input mode: “bt” denotes Bluetooth Mode,
Hddenotes HDMI ARC Mode,OP” denotes Optical Mode,
AU” denotes Audio Mode Ud” denotes USB* mode.,
3. : Play/pause in USB*/BT mode.
4. : Play the previous song in USB*/BT mode.
5. : Play next song in USB*/BT mode.
6. : Volume decrease.
7. : Volume increase.
3. 2. SRC1. 4. 5. -
6. +
7.
5. AC IN: AC Power cord.
6. LED: Solid red when not connected,
Solid blue when connected.
7. ON/OFF
To turn on the subwoofer for wireless pairing,
To turn o the subwoofer.
Remark:
In order not to disturb in the dark, the LED display of soundbar is set to be dim after
30 seconds if there is no operation, and display o after another 90 seconds.
You can press any button to resume.
Remark:
In order not to disturb in the dark, the LED display of soundbar is set to be dim after
30 seconds if there is no operation, and display o after another 90 seconds.
You can press any button to resume.


Produktspezifikationen

Marke: Philips
Kategorie: Soundbar
Modell: HTL8162

Brauchst du Hilfe?

Wenn Sie Hilfe mit Philips HTL8162 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Soundbar Philips

Bedienungsanleitung Soundbar

Neueste Bedienungsanleitung für -Kategorien-