PAC LCGM24 Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr PAC LCGM24 (1 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 4 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
LCGM24
Radio Replacement Interface for General Motors Vehicles
Paciî‚żc Accessory Corporation
® | Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
©2013 Pacic Accessory Corporation
www.pac-audio.com
Rev. 050213
P ifi A C ti
P ifi A C ti
The LCGM24 allows the replacement of a factory radio in select General Motors vehicles with Class II radios. Using this interface
will retain factory features such as warning chimes and provides a data-bus generated 12-volt retained accessory power output
(RAP). RAP keeps the radio powered after key-off, just like the factory system. The LCGM24 also issues data commands that
maintain a “healthy” system status to other vehicle systems.
Introduction & Features
Installation Steps
PLEASE NOTE: This Interface is intended
for use in vehicles without OnStar® or
Bose® or when OnStar® or Bose® does
not need to be retained.
1. Wire your aftermarket radio to the LCGM24’s
harness according to the wiring connections chart.
The red accessory wire will support up to 10 amps
of current draw.
2. Remove the factory radio and plug in the LCGM24’s
24-pin harness into the factory vehicle harness.
Using the supplied length of wire, mount the
interface within the dash of the vehicle with double
sided tape or wire ties. There are no adjustments
to make, just mount your aftermarket radio and re-
install your factory dash panels and you’re done!
1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on.
2. Turn on the radio & check balance & fade.
3. Turn off vehicle & remove key. RAP will be active & keep the radio on for 10 minutes or until the drivers door is opened.
4. The LED & radio will turn off when RAP turns off or the drivers door is opened.
Testing & Veriî‚żcation
Illustration / Schematic
Yellow Battery +12v
Black Ground
Red Accessory +12v
(10A)
Blue Antenna On Input
White Front L + input
White / Black Front L - input
Grey Front R + input
Grey / Black Front R - input
Green Rear L + input
Green / Black Rear L - input
Purple Rear R + input
Purple / Black Rear R - input
Wiring Connections
Aftermarket Radio
Connections
To Vehicle
Connector


Produktspezifikationen

Marke: PAC
Kategorie: Nicht kategorisiert
Modell: LCGM24

Brauchst du Hilfe?

Wenn Sie Hilfe mit PAC LCGM24 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert PAC

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-