NAV-TV NTV-KIT508 Bedienungsanleitung

NAV-TV Dashcam NTV-KIT508

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für NAV-TV NTV-KIT508 (4 Seiten) in der Kategorie Dashcam. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
BHM
09/ /14 24
NTV-DOC192
Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for :
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
1 | P a g e
3950 NW 120th Ave, Coral Springs, FL 33 TEL 561-955-9770 FAX 561-955-9760 065
www.nav-tv.com info@nav-tv.com
VW-CAM
NTV-KIT508
Overview
The -VW CAM is a factory trunk VW logo replacement for select VW’s which ips open to reveal
a reverse camera whenever the vehicle is placed in reverse. Opening the trunk is sll
operaonal by pressing the logo manually, provided the doors are unlocked.
Kit Contents
VW-C AM
Camera Extension
Harness
Power Harness
Drain Tube
VW Logo
ï‚· 04-08 Phaeton
 06-14 Jea, Passat
ï‚· 07-14 EOS
ï‚· 07-15 GTI
ï‚· 08-14 Beetle, CC
ï‚· 08-15 Golf, Golf7
ï‚· 09-14 Routan, Touareg
BHM
09/ /14 24
NTV-DOC192
Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for :
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
2 | P a g e
VW-CAM Installaon
1. Verify the factory VW trunk logo opens the trunk properly (vehicle must be fully
unlocked).
2. Begin by removing the factory trunk liner. It is held
in by various plasc clips:
3. Disconnect the 2-pin plug connected to the factory
logo handle:
4. Remove (3x) Torx bolts that secure the factory VW
logo to the trunk lid. Carefully pull the VW logo oî…¸
of the trunk lid.
The next few steps picture the VW CC, other vehicles will be similar.
BHM
09/ /14 24
NTV-DOC192
Agreement End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for :
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 | P a g e
5. With a small at pry tool, carefully pry the chrome colored VW logo from the OEM
handle base. It is secured with clips only.
6. If the OEM chrome VW logo does not î…¬t
properly on the VW-CAM handle, it may
be necessary to remove (pry oî…©) the
oponal black oblong layer which comes
connected by default on the VW-CAM.
7. Run the smaller end of the provided from hole in the edge of the trunk lid to Drain Tube
the white nipple on the VW-CAM.
8. Bolt the VW-CAM into the trunk lid in the same orientaon that the OEM handle was
removed, using the same Torx bolts.
9. Reconnect the OEM 2-pin plug to the VW- 2-pin plug (black & yellow wires). CAM’s


Produktspezifikationen

Marke: NAV-TV
Kategorie: Dashcam
Modell: NTV-KIT508

Brauchst du Hilfe?

Wenn Sie Hilfe mit NAV-TV NTV-KIT508 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Dashcam NAV-TV

Bedienungsanleitung Dashcam

Neueste Bedienungsanleitung für -Kategorien-