Metra TE-190 Bedienungsanleitung

Metra Dashcam TE-190

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Metra TE-190 (4 Seiten) in der Kategorie Dashcam. Dieser Bedienungsanleitung war für 15 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
©COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
iBEAMUSA.comiBEAM Vehicle Safety Sytems ®REV. 04/06/2020 INSTTE-190
Attention! When testing the aftermarket
equipment, ensure that all factory equip-
ment is connected before cycling the key to
ignition.
TE-190
INSTALLATION INSTRUCTIONS
#IBEAMSAFETY
Wiring 2 .....................................................................
Specs 3 .......................................................................
TABLE OF CONTENTS
TOOLS REQUIRED
• Wire stripper
• Tape
• Digital Multi-meter
• Cutter
Universal 190° Wide Angle
Adjustable Camera
Visit for more detailed informatuon about the product. iBEAMUSA.com
Product Features
• Wide viewing angle
• Resolution: 600 TV Lines
• Water resistant - IP69K
• Mirror image - switchable
• Selectable parking lines
• Camera lens - adjustable
Part Components
A) Camera B) Accessories C) Harness
A B C
1.800.221.0932
|
iBEAMUSA.com
2
Camera Wiring/Install
(Figure A)
1. Find a desirable location to mount the
camera. Make sure this location is away
from moving objects and has a clear
visual of the desired view wanted from
the camera.
2. Drill a 8 mm size hole for the bolt and
wiring to be ran into the vehicle. Secure
the camera with the provided nut.
3. Connect the wires to the designated
sources below. Verify with a multi-meter
that the correct wire is being used
• RED wire to 12V reverse or accessory
if desired
• BLACK wire to chassis ground
4. Run the extention wire to the location
where the visual will be displayed, ex.
aftermarket radio or monitor.
5. There are two loops located on the
camera wire.
• GREEN loop - Parking lines on/off
• BROWN loop - Mirror/normal image
NOTE: Figure B shows adjustablity of camera.
(Figure A)
(Figure B)
WIRING/INSTALL
REV. 04/06/2020 INSTTE-190 3
Image Sensor 1/4 color cmos
Signal NTSC
Resolution 600 TV Lines
Viewing Angle 210° Diagonally, 190° Hori-
zontal, 140° Vertical
Mininum Illumination 0.01 Lux/F1.2
Current Consumption 25-55 mA
Power Range 6V-26V DC
S/N ratio 46 dB
Operating Temp. -35° C ~ 80° C
Storage Temp. - 50° C ~ 105° C
Water Resistance IP69K
Mirror/Normal Image Selectable
Parking Line Selectable
Horizontal/Vertical mount Adjustable
Diameter 26mm (D) * 23.5 mm (W) *
22mm (H)
Measurements in mm. Measurements in mm.
SPECIFICATIONS


Produktspezifikationen

Marke: Metra
Kategorie: Dashcam
Modell: TE-190

Brauchst du Hilfe?

Wenn Sie Hilfe mit Metra TE-190 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Dashcam Metra

Bedienungsanleitung Dashcam

Neueste Bedienungsanleitung für -Kategorien-