Kathrein UWS 24 Bedienungsanleitung

Kathrein Schalten UWS 24

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kathrein UWS 24 (4 Seiten) in der Kategorie Schalten. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/4
1 / 4
UWS 24 20550001
Wideband to Quatro Converter
About this Manual
This document is part of the product.
►Read this manual carefully before using the converter
for the fi rst time.
►Keep this document for reference throughout the
service life of the device and pass it on to any new
owner or user.
For the most up-to-date version of this manual, go to
www.kathrein-ds.com.
Keep this manual in a safe place for future
reference and include it with the unit when
passing it on to the next user.
Features
■Converter for converting two wideband signals to four SAT-IF levels
■The use of terminating resistor EMK 03 (order no. 237169) enables the adaptation to the LNB‘s oscillator frequency
(10.40 GHz or 10.41 GHz)
■Power supply via “horizontal low” trunk
■Terrestrial signals in the 5–862 MHz band can be received even when the satellite receiver is switched off
■Installation on EXR 2508 (order no. 20510095) or EXR 2558 (order no. 20510096) possible using EMU 250 coupler
(order no. 20510044)
■Kathrein Power Saving:
If no receiver is active in a system using Kathrein Power Saving, both the LNB and the converter are switched off
Scope of Supply
■UWS 24
●Instructions for use for UWS 24
Transport and Storage
►Use the original packaging for transporting the device; store it in a dry place
►Make sure there is no water condensation build-up.
Intended Use
►The device described in this manual is only intended for the installation of satellite reception systems and may only
be installed by trained specialists
►Any other use or the non-observance of these instructions will result in the loss of the warranty and guarantee
►The manufacturer accepts no liability for accidents caused by the user opening the unit
►Opening the unit and attempting to repair it yourself voids all warranty claims
suitable for DVB-T/T2
44,1 63,45
111,5
148
134
205500001
UWS 24
Made in Germany
H Wideband
Config
V Wideband
Terr.
H low
V low
V high
H high
Open: LNB 10,40 GHz
Term:
18 V 18 V
Wideband - Quatro - Converter
Digital Systems GmbH
LNB
10,4 GHz1
2 / 4
Safety Precautions
Installation Instructions
Risk of damage to property!
Use a coaxial cable with an inner conductor diameter
of 1.2 mm max. and without any burrs. Ensure short-
circuit-free installation.
►Connectors for coaxial cables: 75 Ω RF connectors
(F series) according to EN 61169-24
►Use wood screws (max. Ø 4 mm) for fastening
►May not be installed in damp rooms
►Use recommended accessories only
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
Improper intervention can endanger the electrical safety of the device.
►Do not open or tamper with the unit
►Always disconnect the mains plug from the socket when working on the system
►Ensure adequate clearance: at least 5 cm to all sides
►Ensure free circulation of air to dissipate the heat from the unit
►Do not place any liquid-fi lled items on top of the device
►Do not expose the device to dripping or splashing water
►Admissible ambient temperature: -20 to +55°C
►The device may only be installed in dry indoor areas
►Do not install the device on or against easily combustible material
►The device is intended for wall mounting only! All other installation positions are prohibited
►Comply with the safety regulations set out in the current EN 60728-11 and EN 62368-1 standards
►The equipment must be provided with an equipotential bonding wire (Cu, at least 4 mm
2)
Input level:
To prevent overloading of the inputs, the level must not exceed 80 dBµV per transponder.
For higher input levels (> 80 dBµV) we recommend to use an attenuator (e.g. ERE 01 with 6 dB, order no.
274854).
Observe the oscillator frequency of the LNB:
Wideband feed systems using an oscillator frequency of 10.41 GHz are available on the market. To be able
to use these, screw an EMK 03 terminating resistor onto the “confi g” socket. The change is eff ective imme-
diately.
This is not required when using the Kathrein feed system UAS 582 (order no 20110032.
3 / 4
Example of Use
2
T
err.
V
high
H
high
V
low
H
low
1
4
3
6
5
8
7
20510095
230V~ 50-60Hz 17W
Power
OFF
Saving
ON
H low:
ma x.
800mA
2
T
err.
V
high
H
high
V
low
H
low
1
4
3
6
5
8
7
Power
Saving
20510096
ESD..
ESC..
ESD..
ESC..
KAZ 11/12*
UAS
582
KA Z 12
21810002
A
KAZ 11
507205
A
T
err.
V
Wideband
Config
H
Wideband
205500001
V
high
H
high
V
low
H
low
18V
18V
Open: LNB 10,40 G Hz
Term: LNB 10,41 G Hz
Wideband - Quatr o - Converte
Made in Ge rmany
UWS 24 | EXR 2558 | EXR 2508
Technical Data
Type | Order No. UWS 24
205500001
Frequency range Terrestrial SAT
Input MHz 5–862 290–2350
Output MHz 5–862 950–2150
LNB oscillator frequency
Without confi g resistance GHz - 10.40
With confi g resistance GHz - 10.41
Throughloss dB -0.5 0
Max. input level dBµV - 80
Permissible supply voltage on horiz. low V 12–19
Current drain at 18 V mA 150
Max. remote feed current mA 800
Protection class IP 30
Permissible ambient temperature °C -20 to +55
Connections F connectors
Dimensions (W x H x D) mm 159 x 148 x 43
Packing unit/weight pc./kg 1 (10)/0.45

Produktspezifikationen

Marke: Kathrein
Kategorie: Schalten
Modell: UWS 24

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kathrein UWS 24 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Schalten Kathrein

Kathrein

Kathrein EXR 2908 Bedienungsanleitung

4 August 2024
Kathrein

Kathrein EXD 2532 Bedienungsanleitung

3 August 2024
Kathrein

Kathrein VWS 2900 Bedienungsanleitung

2 August 2024
Kathrein

Kathrein UWS 24 Bedienungsanleitung

1 August 2024
Kathrein

Kathrein EXD 154 Bedienungsanleitung

29 Juli 2024
Kathrein

Kathrein EXD 1532 Bedienungsanleitung

17 Juli 2024
Kathrein

Kathrein EXR 1708 Bedienungsanleitung

6 Juli 2024
Kathrein

Kathrein EXI 3591 Bedienungsanleitung

5 Juli 2024

Bedienungsanleitung Schalten

Neueste Bedienungsanleitung für -Kategorien-

Netgear

Netgear GS110TPP Bedienungsanleitung

15 Oktober 2024
Hager

Hager K7F10M1W Bedienungsanleitung

12 Oktober 2024
Tripp Lite

Tripp Lite B005-DPUA4 Bedienungsanleitung

11 Oktober 2024
Lancom

Lancom CS-8132F Bedienungsanleitung

8 Oktober 2024
Lancom

Lancom YS-7154CF Bedienungsanleitung

8 Oktober 2024
Perel

Perel E305W3-G Bedienungsanleitung

5 Oktober 2024
TP-Link

TP-Link Festa FS328G Bedienungsanleitung

4 Oktober 2024
Totolink

Totolink SW24DM Bedienungsanleitung

4 Oktober 2024
Black Box

Black Box ACX300-R Bedienungsanleitung

4 Oktober 2024
Totolink

Totolink SW1008P Bedienungsanleitung

3 Oktober 2024