Kathrein EXR 2908 Bedienungsanleitung

Kathrein Schalten EXR 2908

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kathrein EXR 2908 (3 Seiten) in der Kategorie Schalten. Dieser Bedienungsanleitung war für 6 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/3
QCascadable multi-switch for splitting 8 Sat levels and
terrestrial signals to multiple receivers
QOnly one downlink per receiver needed (two for twin
receivers)
QFacility to select horizontal/vertical, low/high, Sat position A/
position B independently for each receiver using DiSEqC™
controls
QIf not using DiSEqC™ controls, changing the horizontal/
vertical, low/high of Sat position A can be performed, also by
tone burst changing Sat position A/position B
QIntegral amplifi er for low attenuation in Sat signal band
QIntegral pre-emphasis to equalise cable attenuation
QTerrestrial signals also receivable with Sat receiver switched
off
QTerrestrial band: 5-862 MHz, passive
QHigh degree of insulation between outputs
QCan be remote fed via the horizontal low inputs.
All other inputs are voltage-free (enabling operation with
UAS 485)
QFor indoor mounting
EXR 2908
QMulti-switch for 8 connections, with integral power supply unit
QLow power consumption based on high-effi ciency short-
circuit-proof switch-mode power supply unit
QCan be extended using EXR 2998
EXR 2998
QMulti-switch loop-through for system extension with eight
connections each
QHighly cascadable (up to 40 connections)
Sat-IF splitting system (8 x Sat-IF)
Multi-switch
EXR 2908
EXR 2998
20510019
20510020
Multi-switch
936.3280/ /0 09/1.3eB 8
Setting Effect
22 kHz High/Low All inputs position “A” can be selectedĺ
Tone Burst Pos. A/B All inputs position “A” and “B” can be selectedĺ
*) The terms for the settings in the receiver menus are specifi c to the respective model and manufacturer!
Settings for receivers without DiSEqC™
Setting Effect
DiSEqC™ “On” All inputs can be selected
22 kHz and tone burst to “Off” Changeover time is shortened
Settings for receivers with DiSEqC™
EXR 2908
20510019
EXR 2998
20510020
Technical data
Type EXR 2908 EXR 2998
Order no. 20510019 20510020
Subscriber connections 8 8
Inputs 1 x terr. 8 x Sat-IF 1 x terr. 8 x Sat-IF
Frequency ranges MHz 5-862 950-2150 5-862 950-2150
Through loss dB - - 3.5 1-2.5 ¹ )
Attenuation ¹)dB 10-13 5-0 13-16 5-0
Horizontal/vertical isolation dB - 25 - 25
Subscriber isolation dB 25 25 25 25
Max. output level ²)dBµV - 109 - 109
Screening factor dB
5-300 MHz > 85
300-470 MHz > 80
470-1000 MHz > 75
1000-2150 MHz > 55
Control with DiSEqC™ Vert./horiz., low/high, pos. A/B
Controls without DiSEqC™
- with 14/18 V and 0/22 kHz
- with tone burst
Vert./horiz., low/high, (pos. A)
Pos. A/B
Current consumption per subscriber mA 30
Nominal input voltage V 198-253 -
Nominal input power (800/400 mA load) W 18.1 / 10 -
Secondary voltage ³)V 18 -
Max. total remote feed current ³)mA 800 -
Max. remote feed current per trunk mA - 1000
Protection class/protection type II (totally insulated)/IP 30 IP 30
Permissible ambient temperature °C - 20 to + 55 - 20 to + 55
Connections F-connectors F-connectors
Dimensions (W x H x D) mm 227 x 228 x 44 172 x 228 x 44
Packing unit/Weight units/kg 1 (10)/1.0 1 (10)/0.85
¹)
Frequency-dependent attenuation
²)
SAT to EN 50083-3, 35-dB-IMA
³)
Via horizontal low inputs
936.3280/ /0 09/2.3eB 8
Reception range Position A/satellite 1 (e.g. ASTRA) Position B/satellite 2 (e.g. EUTELSAT)
Low band High band Low band High band
Vertical Horizontal Vertical Horizontal Vertical Horizontal Vertical Horizontal
Command E2 10 38 F0 E2 10 38 F2 E2 10 38 F1 E2 10 38 F3 E2 10 38 F4 E2 10 38 F6 E2 10 38 F5 E2 10 38 F7
DiSEqC™ commands, e.g. for Kathrein measuring instrument MSK 25 or MSK 33
• The equipment described is designed solely for the installation of satellite receiver systems.
• Any other use, or failure to comply with these instructions, will result in voiding of warranty cover.
• The equipment may only be installed in dry indoor areas. Do not mount on or against highly combustible
materials.
• The equipment must be provided with an earthing wire (Cu, at least 4 mm2).
• The safety regulations set out in the current EN 60728-11 and EN 60065 standards must be complied with.
• Fixings: Wood screws, max Ø: 4.5 mm
• Connector: HF plug 75 (series F) to EN 61169-24.
•Unused subscriber ports should be closed off by 755 Ohm resistors (e.g. EMK 03).
Current-carrying unit
• Do not open or tamper with the unit!
• When working on the system always unplug the mains plug from the wall socket!
• Ensure adequate clearance! Min. 5 cm to all sides!
• Do not install overhead.
• Free circulation of air must be possible to discharge the heat emitted by the unit.
Risk of overheating!
• Permissible ambient temperature -20 to +55°C
Important:
• No liquid-fi lled items may be placed on top of the power supply unit.
• The power supply unit must not be exposed to dripping or splashing water.
• The mains plug must be easily accessible and operable.
• The only reliable method of disconnecting the unit from the mains is to unplug it.
Electronic equipment - in accordance with directive 2002/96/EC OF THE EUROPEAN is not household waste
PARLIAMENT AND THE COUNCIL dated 27th January 2003 on used electrical and electronic equipment, it
must be disposed of properly.
At the end of its service life, take this unit for disposal to an appropriate offi cial collection point.
Installation and safety instructions
System example
936.3280/ /0 09/3.3e/ZWT Technical data subject to change.B 8
Terrestrial
antenna
(symbolic representation)
UAS 484 or
UAS 485
UAS 484 or
UAS 485
KATHREIN-Werke KG . Anton-Kathrein-Straße 1 – 3 . P.O. Box 100 444 . 83004 Rosenheim . GERMANY
. phone +49 8031 184-0 . Fax +49 8031 184-306
Internet: http://www.kathrein.de
• If the inner cable conductor diameter is
greater than 1.2 mm or in case of burr, the
device sockets may be destroyed.
Diameter
0.6-1.2 mm
free of burrs
Max. 2 mm excess
length
Clamping torque max.
3 Nm (danger of over-
winding)

Produktspezifikationen

Marke: Kathrein
Kategorie: Schalten
Modell: EXR 2908

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kathrein EXR 2908 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Schalten Kathrein

Kathrein

Kathrein EXR 2908 Bedienungsanleitung

4 August 2024
Kathrein

Kathrein EXD 2532 Bedienungsanleitung

3 August 2024
Kathrein

Kathrein VWS 2900 Bedienungsanleitung

2 August 2024
Kathrein

Kathrein UWS 24 Bedienungsanleitung

1 August 2024
Kathrein

Kathrein EXD 154 Bedienungsanleitung

29 Juli 2024
Kathrein

Kathrein EXD 1532 Bedienungsanleitung

17 Juli 2024
Kathrein

Kathrein EXR 1708 Bedienungsanleitung

6 Juli 2024
Kathrein

Kathrein EXI 3591 Bedienungsanleitung

5 Juli 2024

Bedienungsanleitung Schalten

Neueste Bedienungsanleitung für -Kategorien-

Netgear

Netgear GS110TPP Bedienungsanleitung

15 Oktober 2024
Hager

Hager K7F10M1W Bedienungsanleitung

12 Oktober 2024
Tripp Lite

Tripp Lite B005-DPUA4 Bedienungsanleitung

11 Oktober 2024
Lancom

Lancom CS-8132F Bedienungsanleitung

8 Oktober 2024
Lancom

Lancom YS-7154CF Bedienungsanleitung

8 Oktober 2024
Perel

Perel E305W3-G Bedienungsanleitung

5 Oktober 2024
TP-Link

TP-Link Festa FS328G Bedienungsanleitung

4 Oktober 2024
Totolink

Totolink SW24DM Bedienungsanleitung

4 Oktober 2024
Black Box

Black Box ACX300-R Bedienungsanleitung

4 Oktober 2024
Totolink

Totolink SW1008P Bedienungsanleitung

3 Oktober 2024