Kathrein EXD 154 Bedienungsanleitung

Kathrein Schalten EXD 154

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Kathrein EXD 154 (8 Seiten) in der Kategorie Schalten. Dieser Bedienungsanleitung war für 19 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF
Seite 1/8
1 / 8
EXD 154
2050000003
Sat-IF Distribution System (4 x Sat-IF)
Digital Wideband Multi-switch
About This Manual
This document is part of the product.
►Do not install or use the device until you
have read and understood this document.
►Keep this document for reference throug-
hout the service life of the device and pass it
on to any new owner or user.
For the most up-to-date version of this docu-
ment, go to www.kathrein-ds.com.
Features
Universal multi-switch with automatic
operating mode detection. A standard TV or
16 receivers each can be operated in single
cable mode at each connection.
All types of signalling are supported and
automatically detected: 14/18 V 0/22 kHz
(legacy), DiSEqC™ 1.0, single cable stan-
dards according to EN 50494, as well as the
extended command set according to EN
50607 (SCD2 or JESS); PIN codes can also
be used in single cable operation.
Latest IC technology with full band captu-
ring ensures the best signal quality. The
inputs are broadband and can also be
operated with wideband LNBs (e.g. UAS
582). This means that a multi-feed system
can be implemented (for two LNBs, the TV
set must support either DiSEqC™ or the
single-cable standard).
QR code for user instructions
For indoor installation
The integrated AGC (Automatic Gain
Control) ensures that the Sat IF signals
have a constant output level and more
reserve in the distribution.
When all TV sets/receivers are switched
o, the multi-switch no longer consumes
any power. If Kathrein Power Saving is acti-
vated, the LNBs are also switched o.
suitable for DVB -T/T2
Wideband to Quatro mode:
In this case, the two inputs of the wideband
LNB are permanently connected to the four
outputs of the multi-switch. The outputs of
the EXD 154 behave like a Quatro LNB, so
that an additional standard multi-switch
can be connected.
The NCF 18 is a highly ecient, short-
circuit-proof switched-mode power supply
unit
Tip The QR code on the front of the
multi-switch will take you to our
website where you can download
these instructions:
111,6
134
148
159
2050000003
2 4
1 3
V low
V high
H high
Terr.
H low
18V
300mA ma x.
Pow er
Saving
Wideband
Universal
Wideband
Universal
ON
OFF
WB-Quatro
DC
42,5
2 / 8
Transport and Storage
►Use the original packaging for transporting
the device; store it in a dry place.
►Make sure there is no water condensation
build-up.
CAUTION!
Risk of damage to the device if operated in inappropriate ambient conditions!
►The equipment may only be installed in dry indoor areas. Do not install the equip-
ment on or against easily combustible material
►The equipment must be provided with an equipotential bonding wire (Cu, at least
4 mm2)
►The safety regulations set out in the current EN 60728-11 and EN 62368-1 standards
must be complied with
►Fasteners for concrete substrates and masonry: 4 suitable plugs and associated
screws with half-round or cylindrical head, outer thread diameter 4.5 - 5 mm, head
diameter ≥ 9 mm and a screw length ≥ 30 mm
For other types of wall, use the appropriate screws or screw-dowel systems, which
oer the same or better fastening
►Connectors: RF connectors 75 Ω (F series) compliant with EN 61169-24
►Unused subscriber ports should be closed o using 75 Ω resistors (e.g. EMK 03)
►To meet EMC requirements, the only power supply unit allower to be used is the
NCF 18
Risk of damage to property!
If the diameter of the inner cable conductor exceeds 1.2 mm or if there is a burr, the
device sockets may be damaged beyond repair.
Max. 2 mm
excess length
Clamping torque
max. 3.4 Nm
(danger of over-
winding)
Diameter
0.6 - 1.2 mm free of burrs
Mounting Instructions
Intended use
The equipment described is designed solely for the installation of satellite receiver systems.
Any other use or non-observance of these instructions will result in the loss of the warranty and
guarantee.
Scope of Delivery
●EXD 154
●Instructions for use for EXD 154
●NCF 18
3 / 8
Safety Precautions
Current-carrying device
►Do not open or tamper with the unit
►When working on the system, always unplug the power supply unit from the wall
socket.
►Ensure adequate clearance: at least 5 cm to all sides
►Do not install on the ceiling or vertically
►Ensure free circulation of air to dissipate the heat from the unit. Risk of overhea-
ting!
►Admissible ambient temperature: -20 to +40 °C
Note:
►Do not place any liquid-filled items on top of the device
►Do not expose the device to dripping or splashing water
►Ensure that the power supply unit is easily accessible and operable
►Disconnect the unit from the mains by pulling the plug of the power supply unit
out of the mains socket
SAT-IF Distribution Equipment (not for wideband operation!)
Type Kathrein Power Saving Switch Setting
VWS 2551 Amplifier Unrestrictedly usable ON
EBX 2520 Two-way splitter
Unrestrictedly usable if each trunk
is terminated by the Kathrein Power
Saving-capable end multi-switch
ON
EAX 2512 Two-way tap Not Kathrein Power Saving-capable OFF
VWS 2500 Amplifier Order no. 20510098 is Kathrein Power
Saving-capable; older models are not ON / OFF
To prevent the set user band from being used or disturbed by another subscriber, the user band can
be protected by means of a PIN code. The PIN code must be entered in the settings of the receiver/
TV. Each user band is assigned a fixed PIN.
PIN Code Protection
UB
1
UB
2
UB
3
UB
4
UB
5
UB
6
UB
7
UB
8
UB
9
UB
10
UB
11
UB
12
UB
13
UB
14
UB
15
UB
16
151 052 133 124 205 196 187 178 099 232 198 111 190 002 201 140

Produktspezifikationen

Marke: Kathrein
Kategorie: Schalten
Modell: EXD 154

Brauchst du Hilfe?

Wenn Sie Hilfe mit Kathrein EXD 154 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten


Bedienungsanleitung Schalten Kathrein

Kathrein

Kathrein EXR 2908 Bedienungsanleitung

4 August 2024
Kathrein

Kathrein EXD 2532 Bedienungsanleitung

3 August 2024
Kathrein

Kathrein VWS 2900 Bedienungsanleitung

2 August 2024
Kathrein

Kathrein UWS 24 Bedienungsanleitung

1 August 2024
Kathrein

Kathrein EXD 154 Bedienungsanleitung

29 Juli 2024
Kathrein

Kathrein EXD 1532 Bedienungsanleitung

17 Juli 2024
Kathrein

Kathrein EXR 1708 Bedienungsanleitung

6 Juli 2024
Kathrein

Kathrein EXI 3591 Bedienungsanleitung

5 Juli 2024

Bedienungsanleitung Schalten

Neueste Bedienungsanleitung für -Kategorien-

Netgear

Netgear GS110TPP Bedienungsanleitung

15 Oktober 2024
Hager

Hager K7F10M1W Bedienungsanleitung

12 Oktober 2024
Tripp Lite

Tripp Lite B005-DPUA4 Bedienungsanleitung

11 Oktober 2024
Lancom

Lancom CS-8132F Bedienungsanleitung

8 Oktober 2024
Lancom

Lancom YS-7154CF Bedienungsanleitung

8 Oktober 2024
Perel

Perel E305W3-G Bedienungsanleitung

5 Oktober 2024
TP-Link

TP-Link Festa FS328G Bedienungsanleitung

4 Oktober 2024
Totolink

Totolink SW24DM Bedienungsanleitung

4 Oktober 2024
Black Box

Black Box ACX300-R Bedienungsanleitung

4 Oktober 2024
Totolink

Totolink SW1008P Bedienungsanleitung

3 Oktober 2024