JANDY Hi-E2 Bedienungsanleitung

JANDY Heizung Hi-E2

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für JANDY Hi-E2 (40 Seiten) in der Kategorie Heizung. Dieser Bedienungsanleitung war für 11 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/40
H0205000_REVM
WARNING
IF THESE INSTRUCTIONS ARE NOT FOLLOWED EXACTLY,
A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY
DAMAGE, PERSONAL INJURY, OR DEATH.
FOR YOUR SAFETY: This product must be installed and serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in
which the product will be installed where such state or local requirements exists. In the event no such state or local requirement exists, the installer or
maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in this manual
can be followed exactly. Before installing this product, read and follow all warning notices and instructions that accompany this product. Failure to follow
warning notices and instructions may result in property damage, personal injury, or death. Improper installation and/or operation can create carbon
monoxide gas and flue gases which can cause serious injury, property damage, or death. For indoor installations, as an additional measure of safety,
Zodiac Pool Systems, Inc. strongly recommends installation of suitable carbon monoxide detectors in the vicinity of this appliance and in any adjacent
occupied spaces. Improper installation and/or operation will void the warranty.
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Immediately switch off main gas supply.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Jandy Pro Series Hi-E2® and Hi-E2®R
Gas-Fired Pool and Spa Heater
EHE
INSTALLATION AND
OPERATION MANUAL
Page 3
ENGLISH
Jandy® Pro Series, Hi-E2® and Hi-E2R Gas-Fired Heater | Installation & Operation Manual
Table of Contents
Section 1. General Information 4 .......................
1.1 Introduction ......................................................... 4
1.2 Description ......................................................... 4
1.3 Warranty ............................................................. 4
Section 2. Installation Instructions 4 .................
2.1 General Requirements 4 .......................................
2.2 Heater Assembly and Preparation 5 ......................
2.3 Heater Location 5 ..................................................
2.4 Installation Clearances 5 .......................................
2.5 Outdoor Installation 5 ............................................
2.6 Outdoor Shelter Installation (Canada) 6 ................
2.7 Indoor Installation 6 ...............................................
2.7.1 Preparation of Heater For Indoor
Installation 6 ....................................................
2.7.2 Combustion Air Requirements for
One-Pipe Installation 7 ....................................
2.7.3 Two-Pipe Installation (Direct Vent) 7 ...............
2.8 Condensate Disposal 10 .......................................
2.9 Gas Supply and Piping ......................................11
2.9.1 Special Precautions for LP Gas 12 .................
2.10 Electric Wiring 12 ..................................................
2.10.1. Electrical Power 12 ..........................................
2.10.2 Bonding ...................................................... 13
2.10.3 Auxiliary Time Clock Wiring 14 ........................
2.10.4 Remote Operation 14 ......................................
2.11 Water Piping 14 .....................................................
2.11.1 Reversal of Water Connections 14 ..................
2.11.2 Pool/Spa Piping Systems 15 ...........................
2.11.3 Connections at Heater................................ 16
2.11.4 Pressure Relief Valve and
Temperature Relief Valve 16 ...........................
2.11.5 Automatic Chlorinators
(Chemical Feeders) 16 ....................................
2.12 Start-up and Adjustment ................................... 17
2.12.1 Normal Operation 17 .......................................
2.12.2 Start-up ....................................................... 17
2.12.3 Condensate ................................................ 17
2.12.4 Gas Pressure 18 .............................................
2.12.5 Adjustment of Water Pressure Switch 18 .......
2.12.6 Water Temperature Rise............................. 19
Section 3. Operating Instructions 19 .................
3.1 Start-Up Procedure 20 ..........................................
3.2 Temperature Controls 20 .......................................
3.3 Lighting and Shutdown 21 .....................................
3.3.1 Lighting the Heater 21 .....................................
3.3.2 Shutdown ................................................... 21
3.4 Water Chemistry 21 ...............................................
3.4.1 Pools .......................................................... 21
3.4.2 Spas ........................................................... 21
3.5 Spa/Hot Tub Safety Rules 22 ................................
3.6 Swimming Pool Energy Savings Tips 22 ...............
3.7 Seasonal Care 23 ..................................................
3.7.1 Spring and Fall Operation 23 ..........................
3.7.2 Winterizing .................................................. 23
3.8 Periodic Inspection 23 ...........................................
3.8.1 Owner Inspection 23 .......................................
3.8.2 Professional Inspection 24 ..............................
Section 4. Maintenance and Service 24 .............
4.1 General ............................................................. 25
4.2 Induced-Draft Combustion System 25 ..................
4.3 Heater Components and Their Operation 26 ........
4.4 Combustion Air Filter ........................................ 26
4.5 Electrical Trouble Shooting ............................... 27
4.5.1 115V Electrical Power Supply 28 ....................
4.5.2 Control Circuit Trouble Shooting 28 ................
4.6 Venturi Combustion Flow System 30 ....................
4.6.1 Pressure Measurement Ports..................... 30
4.6.2 Venturi System Checkout 30 ...........................
4.6.3 Air Flow Investigation 32 .................................
4.6.4 FuelGasTypeandGasOriceSize .......... 33
4.6.5 High Elevation Operation 33 ...........................
4.7 Combustion Condensate 33 ..................................
4.8 Major Component Service 34 ................................
Section 5. Capacities and Dimensions 34 .........
5.1 General Information 34 ..........................................
Section 6. Replacement Parts 35 .......................
6.1 Ordering Information 35 ........................................
6.2 Parts List 35 ..........................................................
6.3 Exploded View 37 ..................................................


Produktspezifikationen

Marke: JANDY
Kategorie: Heizung
Modell: Hi-E2

Brauchst du Hilfe?

Wenn Sie Hilfe mit JANDY Hi-E2 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Heizung JANDY

Bedienungsanleitung Heizung

Neueste Bedienungsanleitung für -Kategorien-