GE GXPL03H Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr GE GXPL03H (12 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/12
147207 Rev. A 215C1181P001 49-50166-3 (02-11 GE)
GEAppliances.com
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
1.800.952.5039 in U.S.; 1.866.777.7627 in Canada
©2006 General Electric Company
GE Water Filtration Pitcher
USE AND CARE/INSTALLATION INSTRUCTIONS
Filtration Pitcher – GE Model GXPL03H
Do not use where water is microbiologically
unsafe
or with water of unknown quality without adequate
disinfection before or after the filter.
Test Conditions
pH: 6.5–8.5
Water Temperature: 72°–75°F (22°–24°C)
Operating Requirements
Filter Capacity: Each filter is certified for 40 gallons (150 L) or approximately
80 pitchers, which lasts an average family at least two months.
Water Temperature: Max 85°F (30°C), Min 35°F (2°C).
• Wash the pitcher, lid and reservoir with soap and warm water and rinse thoroughly.
DO NOT WASH FILTER CARTRIDGE. Pitcher, reservoir and lid are NOT DISHWASHER-
SAFE.
• All remaining plastic bags after the installation could be a suffocation hazard.
Discard safely and promptly.
• For cold water use only. DO NOT FILTER HOT WATER (max. 85°F/30°C).
• Make certain that use complies with state law, local laws and other regulations.
• After draining the filter pitcher, add more water promptly to keep filter cartridge wet.
If filter cartridge dries out, it may need to soak before being used. If filter cartridge
becomes too dried out, it may need to be replaced.
• Keep pitcher filter refrigerated at all times. After 3–4 days, replace unused water with
fresh water.
• All parts EXCEPT THE FILTER CARTRIDGE should be washed regularly. It is important
to keep food and beverage equipment clean and sanitary.
• Pitcher, reservoir and lid ARE NOT DISHWASHER-SAFE.
Your new GE Water Filtration Pitcher comes complete with a filter. Each filter gives you up to 40 gallons (150 L) or 2 months of great-tasting water.
Filter should be changed after 2 months of use.
The GE Water Filtration Pitcher model GXPL03H has been
Tested and Certified by NSF International under NSF/ANSI
International Standard 42 and Standard 53. See performance
data sheet for specific claims.
WARNING
SPECIFICATIONS
Capacity = 40 gallons (150 L) or 2
months. Testing was performed under
standard laboratory conditions; actual
performance may vary.
* The term “bacteriostatic” indicates
that the system limits the passage or
growth of bacteria that may already
exist in the incoming water. It does not
mean that water leaving the system is
safer to drink than water entering the
system.
SAFETY PRECAUTIONS
• This System has been tested according to NSF/ANSI 42 and 53 for reduction of the substances listed below. The concentration of the indicated substances in water entering
the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.
• Actual performance may vary with local water conditions.
LIMITED ONE-YEAR WARRANTY
• What does this warranty cover?
— Any defect in materials or workmanship in the manufactured product.
• What does this warranty not cover?
— Filter canister and batteries after 30 days from date of purchase.
— Service trips to your home to teach you how to use the product.
— Improper installation, delivery or maintenance.
— Failure of the product if it is abused, misused, altered, used commercially or used for other
than the intended purpose.
— Use of this product where water is microbiologically unsafe or of unknown quality, without
adequate disinfection before or after the system. Systems certified for cyst reduction may
be used on disinfected water that may contain filterable cysts.
— Damage to the product caused by accident, fire, floods or acts of God.
— Incidental or consequential damage caused by possible defects with this appliance, its
installation or repair.
• For how long after the original purchase?
— One (1) year.
• How do I make a warranty claim?
— Return to the retailer from which it was purchased, along with a copy of the “Proof of
Purchase.” A new or reconditioned unit will be provided. This warranty excludes the cost of
shipping the product to your home.
This warranty is extended to the original purchaser and any succeeding owner for products
purchased for home or office use within the USA. In Alaska, the warranty excludes the cost
of shipping or service to your home or office.
Some states do not allow the exclusion or limitation of incidental or consequential damages.
This warranty gives you specific legal rights, and you may also have other rights, which vary
from state to state. To know what your legal rights are, consult your local or state consumer
affairs office or your state’s Attorney General.
Contact us at ge.com, or call toll-free at 800.952.5039 in the U.S., or 866.777.7627 in Canada.
FXPL3D & FXPL3CAD Cartridge
EXCLUSION OF IMPLIED WARRANTIES—Your sole and exclusive remedy is product
exchange as provided in this Limited Warranty. Any implied warranties, including
the implied warranties of merchantability or fitness for a particular purpose, are
limited to one year or the shortest period allowed by law.
Max. Permissible
Influent Challenge Product Water Reduction Minimum Average
Substance Concentration Concentration Requirements Reduction Reduction
Standard 42
Chlorine 2.0 mg/L + 10% >50% 77% 87%
Particulate Class V
at least
>85% 83.7% 92.1%
(
30 to <50 mm)
1,000 particles/mL
Zinc 10 mg/L 10% 5 mg/L 58% 65%+
Bacteriostatic* Unit passes NSF Std 42 for Bacteriostatic effects
Standard 53
Copper (pH 6.5) 3.0 mg/L + 10% 1.3 mg/L 85% 89.2%
Copper (pH 8.5) 3.0 mg/L + 10% 1.3 mg/L 66.1% 82%
Mercury (pH 6.5) 0.006 mg/L + 10% 0.002 mg/L 88.3% 91.6%
Mercury (pH 8.5) 0.006 mg/L + 10% 0.002 mg/L 79% 87%
Cadmium (pH 6.5) 0.03 mg/L 10% 0.005 mg/L 96.5% 98.2%+
Cadmium (pH 8.5) 0.03 mg/L 10% 0.005 mg/L 95.8% 97.2%+
Tested against NSF/ANSI Standard 53 for lead reduction by WQA laboratories
Lead (pH 6.5) 0.15 mg/L 10% 0.010 mg/L 97.2% 98.5%+
Lead (pH 8.5) 0.15 mg/L 10% 0.010 mg/L 95.2% 98.2%+
Tested against NSF/ANSI Standard 53 for lead reduction by WQA
laboratories
Start Up Procedures (cont.)
Install battery.
• Remove battery and monitor assembly from plastic bag inside
the pitcher. Turn the monitor cover over and remove battery
cover by removing the screw and prying the cover off.
• Insert one CR2032, 3 volt battery positive “+” side up under the
retaining clip.
NOTE: Make sure the positive (+) side of the battery is up.
• Replace the battery cover by pressing around the lip to make
sure it is fully installed.
• The blue light will flash five times, indicating that the timer is
working. NOTE: If the blue light does not flash, check battery
orientation.
• Press the monitor cover into place on the handle. It will snap
when it is in the proper position.
Replace lid cover. The lid will snap when it is in the proper
location. Open the sliding lid and fill the reservoir with cold tap
water and set the pitcher aside. Filtered water will begin
to collect in the bottom of the pitcher. Continue to add water until
the filtered water in the pitcher reaches the bottom of
the reservoir. Do not overfill. Keep water below the bottom edge
of the slot (see illustration below). Close the sliding
lid on the pitcher.
After the filtered water has collected in the bottom of the pitcher,
discard the water. Refill the pitcher, allow water to collect in
bottom, then discard the filtered water. Once two full pitchers of
water have been discarded, refill pitcher and allow to collect in
bottom. Pitcher is now ready to use.
NOTE:If small, black particles are present in the filtered drinking
water, the filter cartridge may not have been thoroughly flushed.
These particles are harmless, simply discard the water in pitcher
and fill again.
Keep pitcher filter refrigerated at all times. After 3 to 4 days,
replace unused water with fresh, clean water.
2
Parts Included
Easy-pour
Spout
Reservoir
40-gallon Filter
Cartridge
Lid Cover
Pitcher
Start Up Procedures
1Remove pitcher lid cover.
Unwrap filter cartridge and submerge the cartridge in clean
water. Allow cartridge to soak for 15 minutes to flush out any
loose, small carbon particles, which may be present in your water
from the filter, but are not harmful.
Wash the pitcher, lid and reservoir with soap and warm water
and rinse thoroughly. NOTE: NOT DISHWASHER SAFE. DO NOT
WASH FILTER CARTRIDGE.
Place the reservoir into the pitcher. Make sure the spout and
handle recess on the reservoir are in the correct orientation.
Push filter cartridge firmly into reservoir to create a good seal.
Sliding Lid
Blue Filter
Reminder Light
Monitor Cover
Filter
Reservoir
Battery
Cover
Monitor
Cover
Retaining Clip
Battery Positive
(+) Side Up
Spout
Recess
Sliding
Lid
Fill to the
bottom
edge
of the
sliding lid
track.
Handle
Recess
6
7
8
2
3
4
5
3
IOWA RESIDENTS ONLY.
Store or Seller’s name
Address
City State Zip Code
Telephone
Seller’s signature
Customer’s signature Date
Cartridge Replacement Procedure
Remove the pitcher lid cover and the monitor cover from the
pitcher handle by lifting straight up.
Pull out the filter cartridge and dispose of used cartridge.
Follow steps 1 through 5 in the Start Up Procedures section.
Press and hold the reset button for 5 seconds.
Press the monitor cover back into place on the handle.
Replace lid cover.
Replacement Cartridge Filter
FXPL3D or FXPL3CAD – 3-pack replacement filters – $20–$30
For replacement parts and pricing in the U.S.: 800.626.2002.
In Canada: 866.777.7627.
Filling the Pitcher with Tap Water
When you are adding tap water to the filtration pitcher, you do not
need to remove the lid cover.
Use thumb to press down the
thumb tab on the sliding lid on
the lid cover. Then slide back.
Fill pitcher with cold tap water.
Slide the sliding lid back into
place.
Water will be ready to drink in a
few minutes.
NOTE: Keep pitcher filter refrigerated at all times. After 3 to 4 days,
replace unused water with fresh, clean water.
Battery
Cover
Reset
Button
Indicator Light
The filtration pitcher is equipped with a blue indicator light
on the handle.
• Blinks 3 times – time to change the filter.
• Blinks 9 times – time to change the filter and battery.
The filter needs to be replaced approximately every two months and
the batteries need to be replaced every six months.
Indicator Light
Monitor
Cover
1
2
3
4
5
6
1
2
3
4


Produktspezifikationen

Marke: GE
Kategorie: Nicht kategorisiert
Modell: GXPL03H

Brauchst du Hilfe?

Wenn Sie Hilfe mit GE GXPL03H benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert GE

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-