Fredenstein U1631D Bedienungsanleitung


Lesen Sie kostenlos die đź“– deutsche Bedienungsanleitung fĂĽr Fredenstein U1631D (5 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war fĂĽr 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/5
U1631D
16 Channel
Peak Meter
with DANTE
Operating Manual
Fredenstein U1631D 16 Channel Dante Meter
The Fredenstein U1631D is a 16 channel peak meter calibrated in dBfs (dB of digital full scale).
Each of the 16 bar graphs consists of 31 LEDs. The resolutions is from 0 dB to -10 dB in 1 dB
steps, from -10 dB to -30dB in 2 dB steps, and from -30 dB to -60 dB in 3 dB steps. The “OVER”
LED (0dBfs) is red, from -1 dBfs to -10dBfs LEDs are yellow and below -10 dBfs green. All the
bar graphs are non-multiplexed for flicker-free operation with an extremely high update rate of 10
kHz to avoid any delays in the visualization.
Two standard Ethernet connectors (RJ45) on the back-panel provide the DANTE* connectivity,
automatically switching between 100 M or 1 G depending on your networking equipment.
Installation:
Electrical Safety Warnings:
Do not open the enclosure, hazardous voltages are present inside!
There are no user serviceable parts inside.
If you need to replace the mains fuse, make sure the replacement has the same
rating (2AT 250V, slow blow).
Front View:
Fredenstein U1631D Manual V1.0 Dec 28, 2019 Page 2
Fredenstein U1631D 16 Channel Dante Meter
Operation:
Prerequisites:
To use the U1631D, you must have a computer which has the Dante Controller application for
windows or macOS from Audinate installed. Please visit audinate.com and select Products-> Dante
Controller, a free download. Make sure you are selecting the right version for your operating
system. If you want to use your computer(DAW etc) as a source for the U1631D, you also need to
download the Dante Virtual Sound Card driver from audinate.com, which is not free. The virtual
sound card allows you to either use ASIO or DTS.
Routing:
Connect an Ethernet cable from your switch to the primary RJ45 connector. For more detailed
information, please visit audinate.com. Make sure your computer is on the same network.
Then start the Dante Controller application. The Dante controller will automatically discover the
U1631D and you can route the signals freely. The inputs of the U1631 are labeled M1 to M16 in the
Dante Controller app.
Rear View:
Fredenstein U1631D Manual V1.0 Dec 28, 2019 Page 3


Produktspezifikationen

Marke: Fredenstein
Kategorie: Nicht kategorisiert
Modell: U1631D

Brauchst du Hilfe?

Wenn Sie Hilfe mit Fredenstein U1631D benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Fredenstein

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung fĂĽr -Kategorien-