EMOS M0230 Bedienungsanleitung

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für EMOS M0230 (75 Seiten) in der Kategorie Multimeter. Dieser Bedienungsanleitung war für 8 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/75
2
1
2
4
5
6
1
3
8
7
MAX
INPUTCOM
FUSED
MAX
FUSED
500mA
10A
10SEC
EACH 15MIN
MAX
600V
A
H
Select
OFF
200
10
200m
1.5V
9V
200
2
20
2M
200k
20k
2k
600
200
600
TEMP
BATT
V
V
A
EN61010- 1
CAT III 600V
°C°F
TRUE RMS
9
3
GB | Digital Multimeter
Read this instruction manual thoroughly before you begin using
the M0230. It contains particularly important passages concerning
occupational safety principles when using the device. Such passages
are highlighted. Reading the manual will prevent potential injury by
electric current or damage to the device.
The multimeter was designed in accordance with standard EN
61010-1, applying to electronic measuring instruments belonging
to category CAT III 600 V, pollution degree 2. CAT III is intended for
measuring circuits powered by xed wiring installations, such as
relays, sockets, distribution boxes, feeder lines and short branching
circuits and lighting systems in large buildings.
Do not use the multimeter to measure ranges that fall into the
category IV!
Warning:
Use the M0230 multimeter only in the manner specied below. Other
uses may cause damage to the device or endanger your health.
Comply with the following instructions:
• Before measuring resistance, diodes or current, disconnect the
circuits from the power supply and discharge any high-voltage
capacitors. Use a function appropriate for the given measure-
ment. Before changing the range (or switching functions) dis-
connect the conductors from the circuit that is being measured.
• Make sure the device is undamaged before you begin using the
multimeter. If you nd obvious signs of damage on the body of
the device, do not make any measurements! Check that the
surface of the multimeter does not have scratches and that the
side joints are not coming apart.
• Also check the insulation on the measuring probes. Damaged
insulation may result in injury by electric current. Do not use
damaged measuring probes!
• Do not measure voltages above 600 V! If you intend to measure
current, check the multimeter‘s fuse and turn o the power
supply to the circuit before you connect the multimeter. Before

Produktspezifikationen

Marke: EMOS
Kategorie: Multimeter
Modell: M0230

Brauchst du Hilfe?

Wenn Sie Hilfe mit EMOS M0230 benĂśtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Multimeter EMOS

Bedienungsanleitung Multimeter

Neueste Bedienungsanleitung fĂźr -Kategorien-