EMOS E8236 Bedienungsanleitung

EMOS Wetterstationen E8236

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für EMOS E8236 (48 Seiten) in der Kategorie Wetterstationen. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/48

E8236

GB Wireless weather station

CZ Bezdrátová meteostanice

SK Bezdrôtová meteostanica

PL Bezprzewodowa stacja meteorologiczna

HU Vezeték nélküli meteorológiai állomás

Brezžična meteorološka postaja

RS HR| |BA Bežična meteorološka stanica

DE Funk-Wetterstation

UA Вездротова метеостанція

RO Stație meteo fără r

LT Belaidė meteorologinė stotelė

LV Bezvadu meteoroloģiskā stacija

2606149000_31-E8236 148 × 210 mm

www.emos.eu

GB Wireless weather station

Specications:

radio controlled clock

indoor temperature: -10 °C to +50 °C

outdoor temperature: -40 °C to +60 °C

temperature resolution: 0.1 °C

temperature measurement accuracy: ±1 °C (20 to 24 °C), otherwise ±2 °C

wireless sensor: transmission frequency 433 MHz

radio signal range: up to 35 m in an open area

number of sensors per connection: max. 3

indoor and outdoor relative humidity: 20 % to 95 %

resolution: 1 %

measurement accuracy: ±5 % (30 to 80 %), otherwise ±8 %

bar. pressure measurement range: 800 hPa to 1 100 hPa

power supply:

main unit: 2× 1.5 V AAA batteries (not supplied)

sensor: 2× 1.5 V AA batteries (not supplied)

dimensions and weight without batteries:

main unit: 110 × 110 × 47 mm, 125 g

sensor: 91 × 60 × 28 mm, 39 g

Display Description

2 3

1. Indoor temperature

2. Weather forecast icon

3. MAX/MIN measured values

4. Outdoor temperature

5. Pressure trend

6. Outdoor humidity

7. Signal reception from sensor icon

8. Glaze ice icon

9. Sensor number

10. Alarm icon

11. Current time

12. DCF signal reception icon

13. DST icon

14. Date/pressure

15. Sensor battery at icon

16. Indoor humidity

Back

1. Speaker

2. Weather station control buttons (MODE, UP/CH,

DOWN/CF/WAVE, MEM/HPA, AL ON/OFF, SNZ/LIGHT)

3. Stand

4. Battery compartment

Getting Started

First insert batteries into the main unit, then into the wireless sensor. Do not combine old and new or various kinds of batteries

(alkaline, carbon-zinc and nickel-cadmium); do not use rechargeable batteries!

Follow these steps:

1. Open the cover at the rear of the station and the rear of the sensor.

2. Insert 2 1.5 V batteries type AAA for the weather station and close the cover. Then insert 2 1.5 V batteries type AA into the

sensor. Make sure to observe the correct polarity of the batteries according to the drawing at the bottom of the battery

compartment!

3. Outdoor temperature will be displayed on the weather station within 2 minutes. If outdoor temperature is not displayed,

remove the batteries from the sensor and reinsert them or long-press the TX button under the battery cover of the sensor

to again send signal from the sensor to the weather station.

4. Close the sensor cover and place the sensor outside on a dry, shaded place. We recommend placing the sensor on the north

side of the house. The range of the sensor may decrease substantially in areas with large number of obstacles.

5. The sensor is resistant to dripping water; however, it should not be exposed to sustained rain.

6. Do not place the sensor on metal objects; doing so will reduce the transmission range.

Switching Over to Another Channel and Connecting Additional Sensors

(The following procedure for connecting additional sensors is for a replacement sensor E05018. It does not apply to the sensor included

in the package).

1. Select the desired sensor channel number – 1, 2 or 3 – by pressing the CH button at the rear of the weather station. Then

press and hold the CH button, the icon will start ashing.

2. Remove the cover from the battery compartment and insert batteries (2× 1.5 V AAA).

3. Use the CH button to set the desired sensor channel number – 1, 2, 3 – which will be shown on the front panel display.

Data from the sensor will be loaded within 3 minutes.

4. If the sensor signal is not detected, remove the batteries, reinsert them and repeat the process.

Synchronisation of Lost Temperature Signal

In case the weather station is not showing data from the outdoor sensor, check:

• Distance of the station or sensor from sources of interference such as computer monitors or TV sets. It should be at least

2 meters.

• Whether the weather station or sensor is not in the proximity of metal objects and frames (such as window frames).

• Whether the weather station functionality is not aected by other devices using a similar frequency (wireless headphones,

wireless blinds control, gate control, garage door control etc.), or wireless devices used in the immediate neighbourhood.

• Maximum range of the wireless sensor is 35 m in an open area. The range depends on local conditions and the construction

materials of buildings.

• Transmission is also aected by interferences in the area. If reception fails, try to restore functionality by removing the batteries.

If there is interference to radio or television reception caused by the device’s transmission, this can be removed by one of the

following measures:

• Reorient or relocate the antenna

• Increase the distance between the device and the receiver

• Consult with your dealer or an authorized service

The inuence of ambient radio interference may result in poor data display.

Radio Controlled Clock – DCF77

The radio controlled clock provides the most accurate time on the European continent. The radio signal propagates via radio

waves (77.5 kHz) from a site near Frankfurt on the Main in Germany within a range of 1 500 km. This radio time signal automat-

ically takes into account summer (DST) and winter time, leap years and date changes. In standard conditions (at safe distance

from sources of interference, such as TV sets, computer monitors), the reception of time signal takes several minutes. If the clock

does not detect the signal, follow these steps:

1. Move the weather station to another location and try to detect the DCF signal again.

2. Make sure the distance of the clock from sources of interference, such as computer monitors or television sets, is at least

1.5 to 2 meters when receiving this signal. When receiving DCF signal, do not put the weather station in the proximity of

metal doors, window frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).

3. In reinforced concrete structures (cellars, high-rise buildings etc.), the DCF signal reception is weaker, depending on the

conditions. In extreme cases, place the weather station close to a window toward the transmitter.

The reception of the DCF77 radio signal is aected by the following factors:

• thick walls and insulation, basements and cellars

• inadequate local geographical conditions (these are dicult to assess in advance)

• atmospheric disturbances, thunderstorms

• appliances with no interference elimination

• television sets and computers placed near the DCF receiver

DCF Signal Reception

If the batteries in the weather station are suciently charged, DCF signal reception and time setting will occur automatically.

The weather station will begin automatically searching for DCF signal 3 minutes after the insertion of batteries. The search for

signal takes 7 minutes. The icon will be ashing. If the station successfully detects DCF signal, the correct time and date will

be set and the icon will remain on the screen. If the station fails to detect DCF signal, you can activate the search manually

by pressing and holding the WAVE button. If you wish to cancel the manual search mode, again press and hold the WAVE button.

Produktspezifikationen

Marke:	EMOS
Kategorie:	Wetterstationen
Modell:	E8236
Wecker:	Ja
Gewicht:	232 g
Produktfarbe:	Schwarz
Übertragungstechnik:	Kabellos
Akku-/Batterietyp:	AAA, AA
Energiequelle:	Akku
Eingebautes Display:	Ja
Display-Hintergrundbeleuchtung:	Ja
Akku-/Batteriespannung:	1.5 V
Uhrfunktion:	Ja
Temperaturmesseinheit:	F, °C
Weckerfunktion:	Ja
Anzahl der unterstützten Sensoren (max.):	3
Uhr/Datum display:	Ja
Temperaturmessbereich (innen) (T-T):	-10 - 50 °C
Temperaturmessbereich (aussen) (T-T):	-40 - 60 °C
Min/Max Temperaturspeicher:	Ja
DCF Radiouhr:	Ja
Anzahl der Batterien (Empfänger):	2
Messfunktionen:	Indoor hygrometer, Indoor thermometer, Outdoor hygrometer, Outdoor thermometer
Messfunktionen Trenddisplay:	Barometer, Hygrometer, Thermometer
Wetterstation Extremum Daten:	Barometer, Hygrometer, Thermometer
Außensensoren Range:	35 m
Feuchtigkeitmessbereich (aussen) (H-H):	20 - 95 %
Feuchtigkeitsmessbereich (innen) (H-H):	20 - 95 %