Elektrobock BPT001 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Elektrobock BPT001 (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
Version 11.02
Wireless receiver for control of
electric heating devices
- UNDER SWITCH -
Operating instructions
Control of electric heating systems
Two-way radio communication at 433.92 MHz
The connected electric appliance is switched
according to the required temperature
Suitable transmitters (thermostats) for control are
BPT010 or BPT710
BPT001
BPT00
BPT00
BPT00
BPT001
1
1
1
INSTALLATION
The device can only be installed by a person with adequate qualification!
The installation must be executed in a voltage-free state!
Wiring diagram:
230 V/ 50 Hz
L
N
max.
16 A
L N
FUNCTION BUTTON (R) :
SHORT PRESS (for about 1.5 s)
- for coding.
LONG PRESS (for about 5 s)
- RESET deleting the code from the
memor y (the green and red LEDs
flash simultaneously).
BPT001 is used for switching the heating device in connec-
tion with the BPT010 or BPT710 thermostat. Its great
advantage is direct installation into the wiring box.
1. Switch off the main circuit breaker.
2. Connect the receiver according to the diagram.
3. Switch on the main circuit breaker; the green diode is
flashing on the receiver; the receiver is ready for
further setting.
4. Shortly press the FUNCTION BUTTON for about 1.5 s
(the green and red diode are flashing alternately).
5. Activate the receiver on the thermostat (transmitter)
according to the manual for the given transmitter (BPT010
or BPT710).
6. If the code has been learned correctly, the green and
red diodes flash simultaneously.
LED 2LED 1
empty memory, code not learned
code learned
FLASHING ALTERNATELY = code learning mode
FLASHING SIMULTANEOUSLY = code has been learned
SIMULTANEOUS LONG FLASH= code has been ERASED
relay switched
ERROR (if no signal is received from the transmit-
ter within approx. 6 hours, it switches to the 2-min-
ON / 8-min-OFF mode). LED 2 is only flashing if
the relay is on, i.e. for 2 minutes.
EXPLANATIONS: LIT UNLIT FLASHING
FUNCTION
ACTIVATION PROCEDURE
INDICATION DIODES


Produktspezifikationen

Marke: Elektrobock
Kategorie: Nicht kategorisiert
Modell: BPT001

Brauchst du Hilfe?

Wenn Sie Hilfe mit Elektrobock BPT001 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Elektrobock

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-