Ei Electronics Ei262 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Ei Electronics Ei262 (36 Seiten) in der Kategorie Rauchmelder. Dieser Bedienungsanleitung war für 19 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/36
Model Ei262
Read and retain carefully for as long as the product is being used. Contains vital information on the
operation and installation. This leaflet should be regarded as part of the product.
If you are just installing the unit, . This leaflet is to be this leaflet must be given to the householder
given to any subsequent user.
The RadioLINK Carbon Monoxide Alarm Ei262 will
communicate with all other RadioLINK devices including
Smoke/Heat/Fire Alarms, Relays and other accessories.
RadioLINK
MAINS POWERED
CARBON MONOXIDE ALARM
WITH RECHARGEABLE LITHIUM CELL BACK-UP
1
2
3
4
5
6
7
8
9
10
11
12
13
14
IMPORTANT INFORMATION
What to do when you alarm is activated
CARBON MONOXIDE - THE SILENT KILLER
ALARM POSITIONING
INSTALLATION
4.1 Mounting & Wiring Alarms
4.2 RadioLINK Interconnecting etc.
USING & TESTING YOUR SYSTEM
HOW TO DISTINGUISH BETWEEN CO ALARM & SMOKE ALARM WARNINGS
MAINTENANCE
LIMITATIONS OF CO ALARMS
HOW TO PROTECT YOUR FAMILY
GETTING YOUR CO ALARM SERVICED
FIVE YEAR GUARANTEE
TECHNICAL SPECIFICATIONS
ACCESSORIES
TROUBLESHOOTING
Page
CONTENTS
2
3
4
5
9
13
13
17
20
22
22
23
27
28
28
29
33
34
1. IMPORTANT INFORMATION
WARNING: The Alarm should be permanently wired to the mains by a qualified electrician in
accordance with IEE wiring regulations (BS7671).
Install a Carbon Monoxide (CO) Alarm in every room that contains a fuel burning appliance, and in
rooms where people spend a lot of time e.g. bedrooms, kitchens and sitting rooms.
In rooms with an fuel burning appliance, install (preferably) on the ceiling (300mm from walls and
between 1m to 3m horizontally from appliance). In rooms remote from the appliance install at
breathing level, where the light indicators can be seen.
Regularly check that the green power light is on, so that rechargeable back-up cells will remain fully
charged. The CO Alarm will not work if the mains supply is off and the rechargeable Important:
cells are depleted.
Test the unit weekly by pressing and holding the Test/Hush button. The horn will sound and the radio
frequency (RF) signal will be transmitted. (Green light turns red while RF message is transmitted).
Replace sensor module after 5 years operation (see page 25).
When the CO Alarm detects abnormal levels of CO (above 50ppm CO) the red light starts to flash,
the horn will sound within 90 minutes and the signal will be transmitted. At higher levels RadioLINK
of CO the alarm will turn on sooner (see Table B - page 7).
The CO Alarm will automatically reset once the CO has cleared. Pressing the Test/Hush button will
silence the CO Alarm immediately (below 300ppm CO). If CO is still present the red light and horn
will turn on again after about 4 minutes.
The CO Alarm is no substitute for keeping chimneys and flues clear and in good condition, and all of
your appliances serviced regularly according to the manufacturer’s instructions.
Do not fit alarm until all building work is completed to avoid contamination.
3
?
?
?
?


Produktspezifikationen

Marke: Ei Electronics
Kategorie: Rauchmelder
Modell: Ei262

Brauchst du Hilfe?

Wenn Sie Hilfe mit Ei Electronics Ei262 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Rauchmelder Ei Electronics

Bedienungsanleitung Rauchmelder

Neueste Bedienungsanleitung für -Kategorien-