Ei Electronics Ei184 Bedienungsanleitung

Ei Electronics Rauchmelder Ei184

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Ei Electronics Ei184 (20 Seiten) in der Kategorie Rauchmelder. Dieser Bedienungsanleitung war für 16 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/20

LOW VOLTAGE PANEL SMOKE & HEAT ALARMS

Ei181 Ei184 Ei186

P/N B14090 Rev4

READ THIS FIRST

CHECK OPERATION OF SYSTEM

TEST BUTTONS OPERATE ON ALL ALARMS.

ALL INTERCONNECTED ALARMS OPERATE

WHEN EACH TEST BUTTON IS PRESSED FOR

10 SECONDS.

IF THE UNIT BEEPS EVERY 40 SECONDS FOR

OVER 20 MINUTES THE BATTERY IS PROBABLY

DEPLETED. REMOVE UNIT FROM CEILING (SEE

FIG 1) AND REPLACE BATTERY.

DO NOT ATTEMPT TO OPEN THE ALARM AS IT

IS PERMANENTLY SEALED FOR SAFETY.

IF A NUISANCE ALARM OCCURS PRESS THE

TEST/HUSH BUTTON TO SILENCE THE ALARM

FOR 10 MINUTES.

LOCATING ALARMS

SMOKE ALARMS

Sufficient smoke must enter the Smoke Alarm before it will

respond. The Smoke Alarm needs to be within 7.5 metres

(25 ft) of the fire to respond quickly. It also needs to be in a

position where its alarm can be heard throughout your

home, so it can wake the occupants in time for all to

escape. A single Smoke Alarm will give some protection if it

is properly installed, but most homes will require two or

more to ensure that a reliable early warning is given. For

maximum protection you should put individual Smoke

Alarms in all the rooms where fire is most likely to break out,

(apart from kitchens, bathrooms etc. see Locations to

Avoid).

A Smoke Alarm should be located between the sleeping

area and the most likely sources of fire (living room or

kitchen for example). It should not be more than 7.5 metres

(25 ft) from the door to any room where a fire might start on

the escape route from the house.

Important: These Smoke/Heat Alarms are designed for a

single occupancy in a residential type environment.

A Smoke Alarm should be sited within 3m of bedroom doors

for improved audibility.

HEAT ALARMS

The Heat Alarm gives a fire warning when the temperature

at the unit reaches 58°C. It is ideal for kitchens, garages,

boiler houses and other areas where there are normally

high levels of fumes, smoke or dust i.e. places where

Smoke Alarms cannot be installed without the risk of

excessive nuisance alarms.

A Heat Alarm should only be used in a room adjoining an

escape route, in conjunction with Smoke Alarms on the

escape routes.

All the Heat Alarms and Smoke Alarms should be

interconnected to ensure the early warning will be heard,

particularly by somebody sleeping. A properly designed

early warning fire system ensures the alarm is given before

the escape routes become blocked with smoke. Therefore,

there must be Smoke Alarms along the escape routes as

Heat Alarms would not give sufficient warning. However, a

fire in a closed room (e.g. kitchen) adjoining the escape

route, can eventually cause the corridor to become

smoke-logged due to smoke leaking out from around the

door before adequate warning can be given by detectors in

the corridor. (Smoke leaking out from a room is often cool

and slow moving so it can take a long time to rise to the

ceiling, and travel to a detector which could be some

distance away). A Heat Alarm in the closed room will give

early warning of fire in that room and help overcome this

problem.

Produktspezifikationen

Marke:	Ei Electronics
Kategorie:	Rauchmelder
Modell:	Ei184
Tiefe:	75 mm
Gewicht:	310 g
Produktfarbe:	Weiß
Übertragungstechnik:	Kabelgebunden
Energiequelle:	Akku
Befestigungstyp:	Oberflächenmontiert
Betriebstemperatur:	0 - 40 °C
Relative Luftfeuchtigkeit in Betrieb:	0 - 90 %
Durchmesser:	145 mm
Eingangsspannung:	30 V
Interkonnektabel:	Ja
Testknopf:	Ja
Warnung Dezibel:	85 dB
Detektortyp:	Festtemperatur-Wärmemelder
Fester Temperaturpunkt:	62 °C