Chacon 56041 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Chacon 56041 (1 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 26 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/1
Installation
instructions (Ref. 56041)
Earthed mains socket with two
USB charge
sockets
1. Safety
WARNING!
Danger due to a failure to
observe
the instructions.
These instructions contain important information for
the safe
handling of the device. Potential dangers
are specically highlighted. Failure to observe this
information can lead to death or serious injury.
Read the instructions through carefully.
Observe the safety information in these
instructions.
Store the instructions in an accessible location.
1.1
Intended use
The device is intended for the following use only:
Power supply to electrical consumers with
mains plugs.
Power supply for charging portable electronic
consumers with two USB connection (e.g.
mobile phones,tablets,
MP3 players).
Installation in ø 58 mm accessory box.
Use only when in technically faultless condition and
after correct
mounting with approved socket
faceplate.
Intended use also includes reading and
observing these
instructions.
1.2
Authorised target groups
Mounting, installation and fault diagnostics by
qualied
electricians exclusively.
Requirements:
Knowledge of the basics of electrical
engineering.
Knowledge of the national regulations and
standards.
Knowledge of the applicable health & safety and
accident
prevention provisions.
Knowledge of these instructions.
Operation and disposal by the user.
Requirements:
Knowledge of these instructions.
1.3
General safety information
In the following cases, use of the device is
prohibited:
In case of damage to the device or individual
components.
In case of unauthorised modications or
changes to the device.
For children and persons who are unable to
assess the dangers of handling the device.
In the following cases, the manufacturer accepts
no liability for damage:
With a failure to observe these instructions.
With non-intended use.
With use by unauthorised target groups.
With the use of spare parts, that have
not been
manufactured or approved by
the manufacturer.
If the safety equipment on the device has been
bypassed.
Further safety information is provided in the respective
relevant
sections of these instructions.
2. Product
Figure
: Earthed mains socket with 2
USB charge socket
Technical information
Nominal voltage
220-240 V~ / 50-60 Hz
Nominal current
16 A
USB charge socket
USB 2.0 / USB 3.0
USB type
A
USB charge voltage
5 V DC
USB charge current
max. 2,1 A
Ambient temperature
10 to 25 °C
Storage temperature
-20 °C to 70 °C
Plug-in terminals
for
solid wires
3 x 1,5 mm² or
3 x 2,5 mm²
Protection class
IP 20
The output of the device is galvanically isolated.
The USB charge socket is protected against over-
current and
short-circuits.
The device fulls:
Directive 2011/65/EU (RoHS)
Directive 2014/30/EU (EMC directive)
Directive 2014/35/EU (low voltage directive)
Ordinance (EC) no. 1907/2006 (REACH)
3. Mounting and installation
3.1
Safety information for mounting
All work on the supply network and device must
be performed by qualied electricians.
Observe the applicable laws and regulations of
the country in which the device is operated.
Observe the current state of technology at the
time of installation.
The provisions of these instructions, with the
specications of the electrical system, are to be
observed.
WARNING!
Risk of electric shock.
A failure to observe the ambient conditions
can lead to dangerous situations when
working with current.
The device contains current-carrying parts. Contact
with live
parts can lead to electric shock, burns
or death.
Power off the electrical system before
installation.
Secure the electrical system against being
powered on again.
Check that the device is powered o.
Close housing securely before switching on.
CAUTION!
Danger of damage due to incorrect
mounting.
An incorrect connection can destroy the device.
Only mount the device in a faultless condition.
Protect the device against moisture.
Make sure that cables are not damaged, kinked
or crushed.
Observe the mains voltage (type plate).
Make sure that the mains supply is suitable.
Protect supply line with circuit breakers (F =
max. 16 A).
Use suitable fastening material.
CAUTION!
Danger of damage due to improper
testing of the insulation resistance.
Carrying insulation test whilst the system out an is
switched on can result in the device being destroyed.
A test whilst powered will lead to incorrect results.
Isolate the system from power before testing
the insulation resistance.
3.2
Installation
Make sure the electrical system is powered o.
Make sure the connected load corresponds
with the installation situation.
Vertical installation onat surface.
Make sure the accessory box is in a suitable
location.
Strip approx. 10 mm of insulation o the wires.
Connect the device in accordance with the
circuit diagram.
Insert the device in the accessory box.
Secure the device in place with screws.
Attach frame and cover.
Switch on the electrical system.
Figure :
Circuit diagram
4. Operation
CAUTION!
Danger of damage due to
disregard of
the charging
instructions
Excessive charging voltage can destroy the electronic
consumer.
Charge only electronic USB consumers that are
suitable for
the stipulated charge voltage.
Observe the charging instructions of the USB
consumer.
Using the two USB charge sockets
Mobile electronic consumers with USB plugs can
be charged
and operated with the two USB
charge sockets.
Connect the consumer with the USB charge
socket:
Ensure that the plug is the right way up.
Do not apply force when inserting.
5. Troubleshooting
Faults during operation
Check circuit breaker and supply voltage.
Check connected electrical loads and connection
cables.
If a fault cannot be remedied:
Please contact your specialist dealer.
Disposal 6.
The device contains electrical components and is
subject to the European directive 2012/19/EU for
used electrical and
electronic equipment. The
enclosure is made from recyclable
plastic.
When the device reaches the end of its life, do not
dispose of it with normal household waste.
Contact your town or district council to nd out
about possibilities for the environmentally friendly
reuse (recycling) or appropriate disposal of the
device.
Dispose of the device in accordance with the legal
regulations, via a disposal company or at a
municipal waste disposal centre.
Contact7.
Chacon SA
Avenue Mercator 2
1300 Wavre
Belgium
Telephone: + 32 (0)10 68 71 80
Fax: +32 (0)10 68 71 90
Internet:
https://www.chacon.be/
Mail: info@chacon.be
USB Charge socket
N
L
Phase =
Terre =
Neutre =
Earthed mains socket


Produktspezifikationen

Marke: Chacon
Kategorie: Nicht kategorisiert
Modell: 56041

Brauchst du Hilfe?

Wenn Sie Hilfe mit Chacon 56041 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Chacon

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-