Carson MS-170 Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Carson MS-170 (2 Seiten) in der Kategorie Mikroskop. Dieser Bedienungsanleitung war für 31 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/2
MS-170
BiologicalMicroscope
Intermediate 40x-1600x Biological Microscope
Congratulations on selecting your new Microscope! In order to achieve
optimum performance, please follow instructions for proper use and care.
PRODUCT SPECIFICATION
Binocular Tube: Rotatable 360° Focus: Coaxial with Course and Fine Adjustment
Total Magnification: 40x-1600x* Stage: Double Layer Mechanical
Eyepieces: WF10x, WF16x (115mm x 125mm)
Objectives: 4x, 10x, 40x, Condenser: Abbe NA 1.25 with Iris Diaphragm
100x OIL* Filter: Blue Filter (32mm) with Holder
Illumination: Bright White LED Power Cord: AC110V-240V, 50/60Hz
*With Oil Immersion
MS-170 DIAGRAM
Eyepieces
360º Rotatable
Draw Tube
Turret
Objective Lens
Slide Clip
Condenser
Mechanical Stage
Iris Diaphragm
Filter Holder
Light Intensity
Adjustment
(on left side)
Light Source
Base
Condenser
Height Knob
(on left side)
Neck
Coarse Focus
Knob
Fine Focus
Knob
Power Port
Power
Switch
Stage Knobs
SETTING UP
1. Place microscope on a secure surface.
2. Insert the end of the power cord into the
microscope’s Power Port and plug the opposite
end into any standard outlet.
3. Place Eyepiece in the Draw Tubes.
4. Position slide on the Mechanical Stage and
secure with Slide Clip. Use the Stage Knobs
to move front-back (top knob) and left-right
(lower knob) until area of interest is located in
center of stage.
Note: Wipe both sides of slide (prepared,
wet mount, dry mount, smeared) with a
damp microfiber cloth before using.
5. Turn on Light Source by turning Power Switch
to the on position.
6. Rotate Turret so that the 4x Objective Lens
(always begin with lowest power) is directly
above specimen.
FOCUSING
1. Rotate eyepieces closer or farther apart until you see a singular white circular field.
2. Slowly adjust the Coarse Focus Knob to find image. Then focus with Focus Knob, turning very slowly until the area
of interest is sharp and clear.
3. To achieve best image and maximum contrast, adjust Intensity and/or Iris Diaphragm.
Please note, the Condenser is preset to be 1-3mm from bottom of specimen slide. Although the condenser height can
be adjusted with knob, we recommend leaving it at factory setting. Adjust condensor height only when absolutely
necessary.
Warning: When focusing, be careful that the Objective Lens and Condenser do not touch the specimen. This can
cause damage to the Objective Lens, Condenser and/or specimen.
1.
MAGNIFICATION
Objective Total
Eyepiece Lens Magnification
10x 4x 40x
10x 10x 100x
10x 40x 400x
10x 100x* 1000x*
Objective Total
Eyepiece Lens Magnification
16x 4x 64x
16x 10x 160x
16x 40x 640x
16x 100x* 1600x*
*With Oil Immersion
1. To change magnification, rotate the Turret so that
the desired Objective Lens is directly above
specimen. Refocus as needed.
2. The 100x Objective is only designed for oil
immersion microscopy, wherein the specimen and
Objective Lens are coated with immersion oils (not
included).
COLOR FILTERS
Color filters may be used to enhance contrast on
clear or stained slides. To use the included Blue
Color Filter, rotate the Filter Holder (located
under the Diaphragm) outwards. Place the filter
flat inside the top part of the holder, and then fully
rotate the filter holder back into position.
Iris
Diaphragm
Filter
Holder
Light
Source
CARE & CLEANING
• When moving the microscope, hold by the neck or base of the microscope body. Never hold by the eyepiece, draw
tube, or turret.
• If the focusing or mechanical stage motion becomes stiff and hard to move, the mechanical sliding portions on the
focusing track or stage may need one or two drops of lubricating oil (not included).
• Cleaning:
1. Unplug power cord and use a slightly damp microfiber cloth to clean microscope body.
2. Use a slightly damp microfiber cloth and rub gently to remove dust or debris on eyepiece or objective lens.
Do NOT rub with a dry cloth. This can scratch the eyepiece and/or objective lens.
3. To keep your microscope free from dirt, debris, dust or moisture, cover microscope with dust cover.
Customer Service:
If you experience any difficulties, please contact us and we will be happy to help you.
info@carson.com uksupport@carson.com eusupport@carson.com
For warranty information, visit www.carson.com/warranty
Carson Optical 2070 5th Avenue, Ronkonkoma, NY 11779 | Tel: 631-963-5000
2.
Produktspezifikationen
| Marke: | Carson |
| Kategorie: | Mikroskop |
| Modell: | MS-170 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Carson MS-170 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Mikroskop Carson
30 Juli 2024
29 Juli 2024
23 Juli 2024
22 Juli 2024
13 Juli 2024
9 März 2024
Bedienungsanleitung Mikroskop
- Mikroskop Hama
- Mikroskop Maginon
- Mikroskop Bresser
- Mikroskop National Geographic
- Mikroskop Olympus
- Mikroskop Nikon
- Mikroskop Leica
- Mikroskop Traveler
- Mikroskop Zeiss
- Mikroskop Toolcraft
- Mikroskop DNT
- Mikroskop Celestron
- Mikroskop Levenhuk
- Mikroskop Reflecta
- Mikroskop PCE Instruments
- Mikroskop Veho
- Mikroskop Vivitar
- Mikroskop Boeco
- Mikroskop Swift
- Mikroskop Discovery
- Mikroskop Learning Resources
- Mikroskop Barska
- Mikroskop Ideal Tek
- Mikroskop Dino-Lite
- Mikroskop BeaverLab
- Mikroskop National Optical
Neueste Bedienungsanleitung für -Kategorien-
16 Oktober 2024
18 September 2024
6 September 2024
5 September 2024
4 September 2024
4 September 2024
4 September 2024
4 September 2024
3 September 2024
3 September 2024