BeamZ F900 160.507 Bedienungsanleitung

BeamZ Messer F900 160.507

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für BeamZ F900 160.507 (12 Seiten) in der Kategorie Messer. Dieser Bedienungsanleitung war für 14 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Download PDF

Seite 1/12

Ref. Nr. 160.507

F900

Fazer with Controller

INSTRUCTION MANUAL

GEBRUIKSAANWIJZING

BEDIENUNGSANLEITUNG

V1.1

- 2 -

- 3 -

Warning:

- The fazermachine must be placed at least 100 cm away from inﬂammable materials such as curtains, books,

etc. Make sure that the housing cannot be touched by accident.

- Use only Beamz water-based fluid recommended by your dealer.

- Poor liquid caused permanent damage, bad eﬀect, clogging, spitting of unevaporated liquid etc.

- Never add ﬂammable ﬂuids (oil, gas, perfume) to the fog liquid.

- Always keep enough liquid in the tank.

Use of the device without liquid will cause damage to the pump and heater.

- Do not obstruct the openings on top of the case to guarantee a good ventilation.

- fazer machine. Don’t put any objects on the

- For indoor use only.

- During installation, nobody should stand beneath the mounting area.

- Prior to the ﬁrst use, have the unit checked by a qualiﬁed person.

- The unit contains voltage carrying parts. DO NOT open the fazermachine

- Never plug or unplug the unit with wet hands.

- If the plug and/or mains lead are damaged, they need to be repaired by a qualiﬁed technician.

- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a mains outlet. It

needs to be repaired by a qualiﬁed technician.

- Only connect this unit to an earthed mains outlet of 220- Vac/50Hz . 240

- Always unplug the unit during a thunderstorm or when it is not in use.

- If the unit has not been used for a longer period of time, condensation can occur inside the housing. Please

let the unit reach room temperature prior to use.

- When you unplug the unit from the mains always pull the plug, never the lead.

- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a solid chain, a

steel cable, etc. which has to be fastened separately from the mounting bracket.

- The supplied bracket is the main ﬁxing and must be used to solidly mount the light eﬀect.

- In order to avoid accidents in public premises, the local legal requirements and safety regulations/warnings

must be fulﬁlled.

- Keep out of the reach of children.

Location

Select a location where it is easy to ﬁll the tank. It is also possible to hang the unit by means of the supplied

holder and ﬁxing screws.

Installation and Use

Unpack the fazer machine. Fill the fluid tank by means of a funnel. Plug the unit into a mains outlet. Thus the

heating element is automatically switched on. Depending on the room temperature, it takes about 4 minutes

until the working temperature is reached. Then the thermostat is clicking and the LED on the manual control

lights up. Push the switch once and the fazer machine will produce a nice thick fog. Once the fazer machine has

reached its working temperature (the LED is lit) the fazer machine can produce continuously. After this fog

period of time, the fog generator is cooled so much down that the thermostat switches oﬀ. Wait a while until the

working temperature is reached again. It is recommended to produce haze with small pauses in between so that

the temperature is maintained and th e thermostat doesn’t switch off.

Make sure that there is always enough liquid contained in the tank. Use of the fazer machine without liquid can

permanently damage the unit. Once the fazer machine generates little haze or pump generate another 'rattling'

sound i turn oﬀ the unit direct. Check the fluid level and ﬁll the tank when it is empty, check the hose and ﬁlter

blockages and restore it. Plug in the unit and check if the problem is resolved. If problem persists, switch unit

direct oﬀ to prevent further damage and contact your dealer.

Produktspezifikationen

Marke:	BeamZ
Kategorie:	Messer
Modell:	F900 160.507
Gewicht:	4700 g
Produktfarbe:	Grau
AC Eingangsspannung:	220-240 V
AC Eingangsfrequenz:	50 Hz
Leistung:	900 W
Kabellänge:	3 m
Fernbedienung:	Ja
Fernbedienungstyp:	Kabelgebunden
Kapazität Flüssigkeitstank:	0.9 l
Anwärmdauer:	4 min
Abmessungen Gerät (B x H x T):	430 x 175 x 190 mm
Arbeitende Flüssigkeit:	Wasser
Rauch output volumen:	85 m³/min