American International SBK926 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für American International SBK926 (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
SBK926 Mounting Kit
Subaru
2009-13 FORESTER
2008-11 IMPREZA
2008-14 IMPREZA WRX
VEHICLE APPLICATIONS
©2017 AMERICAN INTERNATIONAL INDUSTRIES, INC. TECH Ver. 03/17 PRINT Ver. 3/17
1. Open the Passenger door and remove the end cover exposing the (1) Phillips screw
securing the right end of the Vent/Trim panel to the right end side of the dash.
2. Remove the (1) Phillips screw securing the right end of the Vent/Trim panel to the
side of the dash, and carefully starting with the Vent end, pry the trim panel forward
working toward the radio. It is not necessary to remove the trim completely, just
unclip to the left side of the radio and rest out of the way.
3. Carefully unclip and remove the Vent/radio trim bezel.
4. Remove the (4) Phillips screws securing the radio to the sub-dash, pull the radio
forward, disconnect all attached harnesses and antenna lead and remove radio.
DASH DISASSEMBLY
1
KIT ASSEMBLY INSTRUCTIONS
1. Insert left and right mounting brackets to rear of kit as shown in Figure A
and secure to rear of kit fascia using (4) small phillips screws included in kit.
2. Insert pocket into lower section of the brackets and snap into rear pocket
support tabs.
3. Insert ISO mountable radio between ISO mount brackets and loosely
attach to sides of radio using screws provided with radio when possible
or screws supplied with kit.
4. Slide radio forward or backward for desired look and tighten screws.
Single ISO Mount Applications
Fig A THERE IS A
SPACE IN BOTH
LEFT AND RIGHT
UPPER BRACKET
TABS FOR
SCREWDRIVER
TO PASS
THROUGH.
2
Double DIN Mount Applications
Fig B
1. Insert IMB-926 L&R into rear of kit & attach using 4 screws supplied w/kit
(See Fig B for bracket tab removal).
2. Insert ISO mountable radio between ISO mount brackets and loosely attach
to sides of radio using screws provided with radio when possible or hardware
included with kit.
3. Slide radio component forward or backward for desired look and tighten screws.
4. Attach a rear support bracket to the rear of the new radio and adjust as necessary
to support the weight of the radio.
THERE IS A
SPACE IN BOTH
LEFT AND RIGHT
UPPER BRACKET
TABS FOR
SCREWDRIVER
TO PASS
THROUGH.
REMOVE SHADED MOUNTING
TABS ON BOTH LEFT AND
RIGHT SIDES OF KIT


Produktspezifikationen

Marke: American International
Kategorie: Nicht kategorisiert
Modell: SBK926

Brauchst du Hilfe?

Wenn Sie Hilfe mit American International SBK926 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert American International

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-