American International FMK549 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für American International FMK549 (2 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 31 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/2
003 FMK549
Installation Kit
Tools Required
Flat Blade
Screwdriver
Parts
Supplied:
Mounting
Bracket
Receiver
Trimplate
Ford
Revision 06/09/99
DIN Assembly
1. Using a utility knife, cut out the shaft supports in
the receiver mounting bracket to create the DIN
opening as shown in Figure 1.
2. Remove DIN sleeve from receiver.
Slide DIN sleeve into receiver mounting bracket and
secure by bending securing tabs (Figure 2).
3. Slide receiver fully into sleeve.
4. Secure rear support bracket to rear of receiver
as shown using hardware supplied with receiver.
5. Install receiver assembly in dash of vehicle
following instructions in the Mastersheet for
your vehicle.
Page 1 of 2
Receiver Mounting Bracket
DIN Sleeve
IMPORTANT
Before starting, compare items on your invoice with items
received. If any parts are missing, first carefully check through
packaging material. If an item is missing, please call:
Rear Support
Bracket
(for shaft receiver only)
Rear Support Bracket
FIGURE 1 Shaft Supports
Utility
Knife
FIGURE 2
*003FMK549*
®
Copyright 1999 Crutchfield Corporation
Bend tabs after sleeve
is inside mounting bracket.
Crutchfield at 1-888-955-6000
Installation Kit
Tools Required
003 FMK549
Deep
Socket
Ford
1. Choose the correct spacers (supplied with your
order) from the shaft spacer tree which will allow
receiver nosepiece to extend 1/8” to 1/4” beyond face
of receiver mounting bracket (see Inset).
2. Secure receiver, trimplate, and faceplate receiverto
mounting bracket using shaftnuts as shown.
3. Secure rear support bracket to rear of receiver using
hardware supplied with receiver.
4. Install receiver assembly in dash of vehicle following
instructions in the Mastersheet for your vehicle.
Faceplate
Receiver Mounting Bracket
Shaft Assembly Page 2 of 2
INSET
1/8” - 1/4”
Spacer
Trimplate
Spacers (supplied with your order)
Rear Support Bracket
Shaftnuts
Control Knobs
(size depends upon receiver)
®
Copyright 1999 Crutchfield Corporation


Produktspezifikationen

Marke: American International
Kategorie: Nicht kategorisiert
Modell: FMK549

Brauchst du Hilfe?

Wenn Sie Hilfe mit American International FMK549 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert American International

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-