Aerohive AP170 Bedienungsanleitung
Aerohive
Zugangspunkt
AP170
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Aerohive AP170 (12 Seiten) in der Kategorie Zugangspunkt. Dieser Bedienungsanleitung war für 25 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/12
P/N 330052-03, Rev. A 1
AP170 INSTALLATION GUIDE
This guide explains how to mount an Aerohive AP170 Outdoor Access Point to a pole or flat
surface in virtually any outdoor setting, and connect it to Aerohive HiveManager Network
Management over the network. To register, get the latest product documentation, see compliance
information, and download software updates, visit www.aerohive.com/support.
KIT CONTENTS, REQUIRED ACCESSORIES, AND TOOLS
The AP170 kit includes the items shown in Figure 1.
Figure 1 AP170 kit contents
To install your AP170, you will need the following accessories (ordered separately) and tools:
• (2) 2.4 GHz antennas (AH-ACC-170-ANT-2G)
• (2) 5 GHz antennas (AH-ACC-170-ANT-5G)
• A switch that provides PoE power, or a PoE provisioning device
• (1) shielded cat5 Ethernet cable rated for outdoor use; length not to exceed 328 feet (100 m)
• Crosshead screwdriver for 1/4” (6 mm) x 3/8” (10 mm) screws
• Drive sockets (nut drivers) for 3/8” (10 mm) nuts
• Flat blade screwdriver to tighten hose clamp
S AFETY INSTRUCTIONS AND S HITE AZARD WARNINGS
Read and follow these safety instructions and hazard warnings before installing an AP170 outdoors. Keep these
instructions for future reference.
• To comply with RF (radio frequency) exposure limits, do not place the AP170 within 8" (20 cm) of people.
• You can install the AP170 in wet, windy locations. Therefore, make sure to install the Ethernet cable housing for
a complete waterproof connection.
• To protect the AP170 from lightning, do not place it at the highest point of a building or structure.
• To protect your network from lightning, place an Ethernet protector (SKU AH-ACC-1G-ETH-PROT) inline between
the AP170 and the rest of the network. Refer to the installation instructions that ship with the Ethernet
protector.
Plane Bracket (1)
AP170
Base
Bracket (1)
(4) Sleeve-Bolt Assembly
Sleeve, 5/8” (16 mm),
Bolt 1 15/16” (5 cm),
Hex nut 3/8” (10 mm),
Washer 5/8” (16 mm)
(4) Round Head Screw 1/4” (6 mm)
Lock Washer, Flat Washer
(4) Hex Head Bolt, 3/8”x1/2”
(10 mm x 13 mm)
Lock Washer, Flat Washer 1/2” (13 mm)
Hose Strap (1)
Ground Cable (1)
Ethernet
Housing (1)
Aerohive Networks
2
DEVICE, POWER, EAND NVIRONMENTAL SPECIFICATIONS
Understanding the range of specifications for the AP170 is necessary for optimal deployment and device operation.
The following specifications describe the hardware components, PoE (Power over Ethernet) electrical requirements,
and the environmental ranges in which the device can operate.
Device and Enclosure Specifications
• AP170 dimensions (without antennas): 9 5/8” long x 7 7/8” wide x 3" high (22.4 cm x 20 cm x 7.6 cm)
• AP170 weight: 4.85 lb. (2.199 kg) with antennas, 6.05 lb (2.744 kg) with antennas and brackets
• Antennas: 4 N-type female connectors for external antennas
• Ethernet connector: autosensing 10/100/1000 Base-T Mbps; compliant with the IEEE 802.3at standard for PoE
• Mounting options:
• Horizontal or vertical pole mount; pole must be 1" to 3.5" (2.5 cm to 8.9 cm) in diameter
• Wall or flat surface mount
Power Specifications
• PoE nominal input voltages: 48 V, 30 watts
Environmental Specifications
• Operating temperature: -40 to 131 degrees F (-40 to 55 degrees C)
• Storage temperature: -40 to 176 degrees F (-40 to 80 degrees C)
• Relative humidity: Maximum 100%
• Wind survivability: > 165 mph (266 kph)
• Environmental compliance: IP68
To install the AP170, you must be a qualified installation professional, licensed or certified in accordance
with local regulations.
Use only attachments and accessories specified by Aerohive.
During operation, the surfaces of the AP170 can become hot. Use caution when handling it.
Make sure that the AP170 is connected to a suitably installed ground conductor. Contact the appropriate
electrical inspection authority if you are uncertain that suitable grounding is available.
Do not locate the AP170 enclosure near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. During installation, exercise extreme care not to come
into contact with these circuits, which can cause serious injury or death. For proper installation and
grounding of the product, refer to national and local electrical codes: NFPA (National Fire Protection
Association) 70, National Electrical Code Article 810 (U.S.); Canadian Electrical Code, Part I, CSA 22.1 and
Section 54 (Canada); and if local or national electrical codes are not available, refer to IEC (International
Electrotechnical Commission) 364, Part 1 through 7 (other countries).
Do not connect or disconnect antennas or cables from the AP170 during periods of lightning activity.
3
Aerohive Networks
M OUNTING THE AP170
When you mount the AP170 you can adjust the orientation to vertical for optimum radio transmission. For example,
you can mount the AP170 on a non-penetrating roof stand or to a Winegard bracket, often used for mounting
satellite dishes. The mounting bracket accommodates poles with a 1" to 3.5" (2.5 cm to 8.9 cm) diameter.
To provide unobstructed RF coverage, mount the AP170 in a relatively open area. At a minimum, mount it on a pole,
mast, of flat surface so that the antennas have at least a three-foot clearance from any nearby obstructions.
After checking that you have all the materials and tools necessary, and familiarizing yourself with the safety and
site hazard warnings, you are ready to mount the unit. You can mount the AP170 on a vertical or horizontal pole, or
attach it to a flat surface. These options are described below. The device and mounting accessories required for
mounting the AP170 are shown in Figure 2.
Figure 2 AP170 mounted on a vertical pole with major devices and accessories called out
PoE Connections
In most cases, you can connect an Ethernet cable directly from your AP170 to a PoE-enabled switch, or to a PoE
injector inside the building (see Figure 2). If you are not using a PoE-enabled switch, you must connect to an
intermediary PoE injector, then to your switch (see Figure 5 on page 8). In cases where your AP170 is located a
significant distance from the building, you can install an outdoor waterproof PoE injector, available separately (SKU
AH-ACC-OINJ-30W).
Note: For best performance, deploy AP170 devices at least 100 feet (30.5 m) apart from each other.
The AP170 mounted
on a grounded vertical pole.
A shielded Ethernet cable
provides both the network
connection and power
through PoE.
The AP170 ground
wire is connected to
the grounded pole.
AP170
(AH-AP-170-N-XX)
Shielded Ethernet Cable
N-Type Outdoor Antennas (4)
AH-ACC-170-ANT-KIT
AH-ACC-170-ANT-2G (2)
AH-ACC-170-ANT-5G (2)
5 GHz 2.4 GHz
Ground wire connected
to grounded pole
5 GHz
2.4 GHz
Produktspezifikationen
| Marke: | Aerohive |
| Kategorie: | Zugangspunkt |
| Modell: | AP170 |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Aerohive AP170 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Zugangspunkt Aerohive
16 August 2024
13 August 2024
10 August 2024
7 August 2024
28 Mai 2024
2 Dezember 2023
8 Juli 2023
Bedienungsanleitung Zugangspunkt
- Zugangspunkt Asus
- Zugangspunkt HP
- Zugangspunkt Macally
- Zugangspunkt ZyXEL
- Zugangspunkt Bosch
- Zugangspunkt Buffalo
- Zugangspunkt Allnet
- Zugangspunkt Devolo
- Zugangspunkt Eminent
- Zugangspunkt Linksys
- Zugangspunkt Netgear
- Zugangspunkt Renkforce
- Zugangspunkt Fortinet
- Zugangspunkt Netis
- Zugangspunkt Aruba
- Zugangspunkt Lindy
- Zugangspunkt Dell
- Zugangspunkt Mercusys
- Zugangspunkt Honeywell
- Zugangspunkt TRENDnet
- Zugangspunkt AVM
- Zugangspunkt Zebra
- Zugangspunkt TP-Link
- Zugangspunkt Black Box
- Zugangspunkt Techly
- Zugangspunkt Hercules
- Zugangspunkt Huawei
- Zugangspunkt Edimax
- Zugangspunkt DrayTek
- Zugangspunkt Totolink
- Zugangspunkt D-Link
- Zugangspunkt Digitus
- Zugangspunkt DataVideo
- Zugangspunkt Lancom
- Zugangspunkt LevelOne
- Zugangspunkt Cisco
- Zugangspunkt Grandstream
- Zugangspunkt Tenda
- Zugangspunkt Ubiquiti Networks
- Zugangspunkt Intellinet
- Zugangspunkt Bintec-elmeg
- Zugangspunkt Planet
- Zugangspunkt EnGenius
- Zugangspunkt Mikrotik
- Zugangspunkt Moog
- Zugangspunkt Homematic IP
- Zugangspunkt EQ3
- Zugangspunkt Comtrend
- Zugangspunkt INCA
- Zugangspunkt Media-tech
- Zugangspunkt Mercku
- Zugangspunkt Mojo
- Zugangspunkt Sitecom
- Zugangspunkt SMC
- Zugangspunkt Steren
- Zugangspunkt AMX
- Zugangspunkt Vimar
- Zugangspunkt Cudy
- Zugangspunkt Moxa
- Zugangspunkt StarTech.com
- Zugangspunkt AirLive
- Zugangspunkt Kingston
- Zugangspunkt LigoWave
- Zugangspunkt Dahua Technology
- Zugangspunkt Speco Technologies
- Zugangspunkt Atlantis Land
- Zugangspunkt Cradlepoint
- Zugangspunkt SilverNet
- Zugangspunkt Advantech
- Zugangspunkt Juniper
- Zugangspunkt Insteon
- Zugangspunkt Crestron
- Zugangspunkt 3Com
- Zugangspunkt WatchGuard
- Zugangspunkt V7
- Zugangspunkt Syscom
- Zugangspunkt Silex
- Zugangspunkt NUVO
- Zugangspunkt Mach Power
- Zugangspunkt IP-COM
- Zugangspunkt ICC
- Zugangspunkt Amer
- Zugangspunkt Allied Telesis
- Zugangspunkt Hawking Technologies
- Zugangspunkt Cambium Networks
- Zugangspunkt Brocade
- Zugangspunkt Extreme Networks
- Zugangspunkt Bountiful
- Zugangspunkt Meru
- Zugangspunkt Amped Wireless
- Zugangspunkt Ruckus Wireless
- Zugangspunkt Premiertek
- Zugangspunkt FlyingVoice
- Zugangspunkt Luxul
Neueste Bedienungsanleitung für -Kategorien-
13 Oktober 2024
11 Oktober 2024
8 Oktober 2024
4 Oktober 2024
4 Oktober 2024
1 Oktober 2024
1 Oktober 2024
29 September 2024
28 September 2024
24 September 2024