Weston 07-3103-W Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Weston 07-3103-W (16 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/16
REV 121813
! NEVER REACH INTO the Tenderizer/Jerky Slicer. Doing so could cause
serious injury. ALWAYS USE THE PROVIDED TONGS.
! KEEP FINGERS CLEAR OF THE BLADES AT ALL TIMES. Failure to do so may
result in personal injury. The Tenderizer/Jerky Slicer is very sharp.
! DO NOT press or push meat into the Chute with your ngers or any other object.
Doing so may cause personal injury and/or damage to the unit.
! NEVER use ngers to scrape food away from the Tenderizer/Jerky Slicer while in
operation. SEVERE INJURY MAY RESULT.
! DO NOT Tongs push the or other utensils into the Blades.
! Remove all bones or hard items in the meat before tenderizing/cubing/slicing.
Damage to the unit may occur if bones or hard objects are pushed through.
-2-
WARNING!
Refer to them often and use them to instruct others.
1. CAUTION SHARP BLADES!
Wear Kevlar, cut-resistant gloves (Sold
Separately) when handling the Blades.
2. NEVER REACH INTO the Meat
Tenderizer/Jerky Slicer. Doing so
could cause serious injury. ALWAYS
USE THE PROVIDED TONGS.
3. KEEP FINGERS CLEAR OF THE
BLADES AT ALL TIMES. Failure to
do so may result in personal injury. The
Cutting Blades/Blade Assembly is very
sharp. Wear Kevlar, cut-resistant gloves
(Sold Separately) when handling the
Blades.
4. DO NOT press or push meat into
the Chute with your ngers or any other
object. Doing so may cause personal
injury and/or damage to the unit.
5. NEVER use ngers to scrape food
away from the Meat Tenderizer/Jerky
Slicer while in operation. SEVERE
INJURY MAY RESULT.
6. DO NOT Tongs push the or other
utensils into the Blades.
7. NEVER LEAVE THE Meat
Tenderizer / Jerky Slicer
UNATTENDED. Close supervision is
necessary when any appliance is used
near children. This appliance is NOT to be
used by children.
8. NEVER use any accessories or parts
from other manufacturers. Doing so will
VOID YOUR WARRANTY.
9. Thoroughly clean all parts that will
come into contact with food before
using the Meat Tenderizer/Jerky
Slicer. Wash all parts by hand and dry
thoroughly. Wear Kevlar, cut-resistant
gloves (Sold Separately) when handling
the Blades.
10. DO NOT attempt to tenderize or slice
meat with bones or other hard items.
Damage to the machine will occur.
11. TIE BACK loose hair and clothing,
and roll up long sleeves before operating
the Meat Tenderizer / Jerky Slicer.
REMOVE ties, rings, watches, bracelets,
or other jewelry before operating.
12. DO NOT use the Meat Tenderizer/
Jerky Slicer while under the inuence of
drugs, medications or alcohol.
READ AND FULLY UNDERSTAND ALL INSTRUCTIONS
AND WARNINGS PRIOR TO USING THIS PRODUCT.
YOUR SAFETY IS MOST IMPORTANT! FAILURE TO
COMPLY WITH PROCEDURES AND SAFEGUARDS MAY
RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE.
REMEMBER: YOUR PERSONAL SAFETY IS YOUR
RESPONSIBILITY!
1. Thoroughly wash all parts in soapy water. Rinse with
clean water. Dry all parts immediately. NOTE: DO NOT
immerse the in sudsy water where Blade Assembly
they cannot be seen. To prevent injury, keep the Blade
Assembly visible at all times. CAUTION: The Blades
are very sharp!
2. Coat all metal parts with a food grade silicone spray.
HELPFUL HINT: A long, skinny brush is helpful when
cleaning the Blade Racks.
WARNING!
Protective/cut-resistant
Kevlar Gloves are
recommended whenever
handling the
Blade assembly!
-3-
1. Insert the into the Blade Assembly
lower housing, guiding the drive shaft into
the journals. Make sure the gears and the
blades of the Blade Assembly are properly
meshed together and resting in the journals
(Figure A). The NOTE: Tenderizer Blade
is a 2-piece set. The is Jerky Slicer Blade
a single piece. Sold Separately
2. Position the top housing onto the lower
housing and line up the screw holes.
3. Secure the top housing to the lower
housing using the 2 housing thumbscrews.
(Figure B).
4. Insert the left comb and right comb into
the top housing (Figure B).
NOTE: The left comb is marked with an “L”
on the upper portion of the comb. The top
housing is marked with an “L comb” and “R
comb” to aid in comb installation.
5. Install handle onto the Blade Drive
Shaft Handle. Secure the to Drive Shaft
with the (Figure C).Handle Thumbscrew
Figure A
Blade
Assembly
Drive Shaft
Lower
Housing
Top
Housing
Journals
Journals
Figure B
Housing
Thumbscrews (2)
Figure C
Handle
Handle
Thumbscrew
Drive Shaft
Gears
NOTE: Periodically the gears on the
Blades need to be tightened. Use the
allen wrench to tighten the screw on the
gears.
Gears
Jerky blades and
Cuber/Tenderizer Blades
sold separately


Produktspezifikationen

Marke: Weston
Kategorie: Nicht kategorisiert
Modell: 07-3103-W

Brauchst du Hilfe?

Wenn Sie Hilfe mit Weston 07-3103-W benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert Weston

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-