TRIUS Trap Master Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für TRIUS Trap Master (12 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/12
Instruction Manual
Trius®a subsidiary of Lyman Products Corp 475 Smith Street, Middletown, CT 06457
800-22-LYMAN or 860-632-2020 www.triustraps.com
Trius 1 Step Page 2
Trius Birdshooter Page 5
92S Trius Trap Page 7
Trius Trap Master Page 9
Congratulations
You have just purchased a unique design and easy to use target trap.
Please read all directions before assembling and using your new trap.
Trius®Traps – 1 Step www.triustraps.com2
ASSEMBLY INSTRUCTIONS:
Tools Needed: 2 adjustable wrenches or 9/16
socket/open end or box end wrenches.
Your Trius 1 Step is preassembled as much as possible
before shipping. The trap has been tested with the main
spring that has been sent with it. By following the
instructions, the trap should go together quickly and
easily. Do not tighten nuts and bolts before all are in
place. When tightening the lock nuts, remember lock nuts
seem tight before really snug.
Put rear support with pedal, trap base and stabilizer together as shown in Illus. A. Please note that trap
base goes in between the rear support and stabilizer.
Put bolt #1 from bottom through rear support and trap base
as shown. Tighten nut finger tight.
Put bolt #2 from bottom through rear support, add 2 wash-
ers, then through the stabilizer. Tighten nut finger tight.
Put bolt #3 from bottom through trap base, add 1 washer,
then through stabilizer. Tighten nut finger tight.
Put bolt #4 from bottom through rear support, trap base and
stabilizer. Tighten nut finger tight.
You are now ready to tighten all bolts and nuts.
Now place arm assembly onto trap base and secure with
lock nut and elevation knob.
ATTACHING MAIN SPRING:
(Illus. B.) Raise pedal, extend arm forward, attach main spring to spring hook, then onto eyebolt assembly.
Put eyebolt through rear bracket, add washer and adjusting knob. Important: Put spring through spring hook
as shown. Do not push on pedal until chain is adjusted properly!
TENSION ADJUSTMENT:
Tighten tension knob just enough to have
eyebolt take up full thread of knob. This
should throw a fine target and be just right
for teaching new shooters. For faster more
difficult targets, increase tension by tighten-
ing knob. Doubles usually require higher
tension. A regulation trap target flight is
between 8 and 12 feet high at a point 10
yards from the trap, and the horizontal dis-
tance is between 48 and 52 yards.
A
B
TRIUS 1-STEP
Trius®Traps – 1 Step www.triustraps.com3
IMPORTANT
ADJUSTING HEIGHT AND RELEASE CHAIN:
Pedal should be at bottom of stroke when trigger releases arm.
TO ADJUST - Remove chain at pedal.
Secure frame at desired angle. (middle holes most popular). (Illus. C)
FLAT: bottom hole, difficult shot, short air time for targets
MEDIUM: middle holes, most popular, best for beginners
HIGH: top hole, most difficult shot
Arm should be extended in the release position.
With pedal at bottom of stroke – resting between rear stabilizer, pull chain snug until release trigger is at
rear of slot (Illus. D) with minimum tension on chain/spring. Place chain onto pedal bolt.
Tighten wing nut so threads of bolt are flush with wing nut hole. (Illus. E)
Chain should be loose on pedal bolt. When adjusted properly, pedal should release trigger at bottom of
stroke.
IF NOT RELEASING TARGETS, SHORTEN CHAIN ON PEDAL BOLT.
IF RELEASING TARGETS TOO SOON, LENGTHEN CHAIN ON PEDAL BOLT. Safe operation of your trap
is as important as safe gun handling. DO NOT STEP ON PEDAL UNTIL PATH OF ARM AND TARGET(S)
ARE CLEAR.
CDE
OPERATION OF TRAP: Become familiar with trap before throwing targets and shooting. The trap’s front legs
should be pushed into the ground to help secure the trap for more consistent throws.
DIRECTIONAL ADJUSTMENT:
To change the direction that a traget will fly, change its position on the arm. For a left target, move the tar-
get fully up the arm against the high angle clip. If a center target is desired, move it down the arm slightly.
For a right target, move it further down the arm.


Produktspezifikationen

Marke: TRIUS
Kategorie: Nicht kategorisiert
Modell: Trap Master

Brauchst du Hilfe?

Wenn Sie Hilfe mit TRIUS Trap Master benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert TRIUS

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-