Thermocet Color Bedienungsanleitung
Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Thermocet Color (32 Seiten) in der Kategorie Härten. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet
Seite 1/32
Page 1
OPERATING AND INSTALLATION INSTRUCTIONS
HI-FIRE COLLECTION
BASE UNIT
GREAT BRITTAN-GB IRELAND-IE
Page 2
TABLE OF CONTENTS
1. General Page 3
1.1 Contents of the packaging
2. Safety device Page 4
2.1 Safety
3. Remote control Page 5
3.1 General
3.2 Manual transmitter
3.3 Screen setup
3.4 Time setup
3.5 Setting the desired temperature
3.6 Setting the Timer
3.7 Changing the signal codes
3.8 Controls (AB)
3.9 Possible error messages
3.10 Setting the flame size/ Extinguishing the fire
3.11 Switching the unit off
3.12 Replacing the batteries
4. Manual control Page 8
5. Initial start-up Page 9
5.1 Daily maintenance
5.2 Important tips
6. Installation instructions Page 10
7. Concentric flue system Page 11
7.1 Components of the concentric flue system
7.2 Construct concentric flue system
7.3 Installation instructions regarding existing flues.
7.4 Parts.
7.5 Installation
7.6 Cleaning and maintenance
8. Instructions for the Mertik Maxitrol GV60 and the Remote Control: Page 16
9. Maintenance check-list Page 19
10. Maintenance Page 20
11. Installing the unit Page 21
11.1 C omponents of the round and flat shaped combustion chamber
11.2 Connection to the gas pipes
11.3 Installing the ceramic wood blocks
12. Options for connecting the concentric flue system Page 22
12.1 Direct exterior wall duct
12.2 Indirect exterior wall duct
12.3 Roof termination without slope
12.4 Roof termination with 45º slope
12.5 Roof termination with 90º slope
12.6 Connection to existing flue pipe
12.7 Installing the restriction plate (O) and (P)
13. Technical details Page 23
13.1 Gas-technical specifications
14. Problems and possible solutions Page 24
Illustrations Page 24 –30
ALL RIGHTS RESERVED.
(0/07012008)
Page 3
We hope you really enjoy the warmth of your new gas fire Read these instructions carefully before
installing and using the gas fire. Keep these instructions in a safe place. Always provide the following
information if the gas fire breaks down: model and serial number, which can be found on the unit. Your
purchase invoice is your proof of warranty.
1. General
The entire unit is delivered to you with your choice of mantle and/or accessories. See the installation instructions
for the relevant mantle and/or accessories that are packaged separately from the unit. Check the unit immediately
after delivery to confirm that it has not been damaged during transport. If it is damaged in any way, please
inform your supplier immediately and provide as many details as possible. Your fire has been finished with
special paint that can withstand extremely high temperatures. Allow the fire to burn at the highest setting and
ventilate the room thoroughly during the first hours of use. As the paint is cured, this will cause a non-hazardous smell and/
or some smoke to be emitted. Any deposit on the heat-resistant glass should be removed immediately using a
fireplace cleaner suitable for heat-resistant glass.
Attention
The unit must be installed, connected and checked by a qualified fitter based on national, regional, and local
standards and regulations. The fitter must inspect the unit for tightness in relation to gas and combustion
products and correct operation of the different components and functions. The flue tube system and the outlets in
the outer wall or roof face must also meet the requirements of the applicable regulations. The unit falls in the
closed unit category, in a set-up location without a fan and with a chimney loss that is greater than 17 % (non-
condensing).
Warning
Gas fires become hot when in use. Therefore care should be taken, for example, by keeping children and those
requiring help away from the immediate vicinity of burning fires. Gas fires must not be placed on or against
flammable materials (curtains, etc.).
1.1 Package contents:
1 x Base unit
1 x Wood mixset
1 x Operating and installation instructions
1 x Remote control
1 x Restriction plate and Restriction plate ø 65
1 x Radiation plate
1 x 9 volt battery
4 x AA 1.5V batteries
1 x 45º Bend Ø100/150
Produktspezifikationen
| Marke: | Thermocet |
| Kategorie: | Härten |
| Modell: | Color |
Brauchst du Hilfe?
Wenn Sie Hilfe mit Thermocet Color benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten
Bedienungsanleitung Härten Thermocet
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
27 August 2024
Bedienungsanleitung Härten
- Härten Quigg
- Härten Perel
- Härten OneConcept
- Härten Qlima
- Härten Toolland
- Härten Dimplex
- Härten El Fuego
- Härten Faber
- Härten Livin Flame
- Härten Manor House
- Härten Xaralyn
- Härten Dovre
- Härten Blumfeldt
- Härten Hwam
- Härten Napoleon
- Härten DRU
- Härten Edilkamin
- Härten Element4
- Härten Franco Belge
- Härten Global Fires
- Härten Godin
- Härten Haas-Sohn
- Härten Hergom
- Härten Icon Fires
- Härten Italiana Camini
- Härten JAcobus
- Härten Jydepejsen
- Härten K-Stove
- Härten Kago
- Härten Kalfire
- Härten Landmann
- Härten M-design
- Härten Mondena
- Härten Norsk Kleber
- Härten Olsberg
- Härten Ruby Fires
- Härten Saey
- Härten Spartherm
- Härten Stuv
- Härten Thermorossi
- Härten Wanders
- Härten Well Straler
- Härten Barbas
- Härten Barbecook
- Härten BlackLine
- Härten Altech
- Härten Bellfires
- Härten Brula
- Härten Bocal
- Härten Austroflamm
- Härten Brunner
- Härten Big Fire
- Härten Boley
Neueste Bedienungsanleitung für -Kategorien-
5 Oktober 2024
26 September 2024
23 September 2024
23 September 2024
22 September 2024
20 September 2024
17 September 2024
17 September 2024
16 September 2024
10 September 2024