SPL Phonitor 3 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für SPL Phonitor 3 (24 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 9 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/24
More information: www.spl.audio
Manual
Phonitor 3
Headphone ampli er and monitoring controller
with 120V technology
EN
DE
Phonitor 3 – Manual
2
Getting started
Read the safety instructions starting on page 11.
Make sure that the mains voltage of the Phonitor 3 corresponds to the voltage of your
region and that the fuse has the correct value for the selected voltage
(see specications on page 8.)
The power switch on the back of the Phonitor 3 must be in the o position.
(O = O / On = I).
Connect the supplied power cord to the power connector of the Phonitor 3 and to
a power outlet.
Be sure to connect the device to a main socket outlet with a protective grounding connection!
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
The devices that are to be connected to the Phonitor 3 must be be switched o.
Connect the outputs of your analog sources to the analog inputs of the Phonitor 3.
Please use appropriate audio cables (XLR).
Audio cables not included in the scope of delivery.
Connect audio cables between the Phonitor 3 and following ampliers or active monitors
(XLR).
Audio cables not included in the scope of delivery.
Connect headphones to the headphone outputs of the Phonitor 3.
Warning: Never connect a mono jack to the stereo headphone jack and make sure that the plug is fully inserted,
otherwise a short circuit might damage the ampliers.
Power on
Switch on the power switch on the rear panel of the Phonitor 3 (On = I).
The VU meters light up.
Power o
Switch o the power switch on the rear panel of the Phonitor 3 (O = O).
The VU meters no longer light up.
Phonitor 3 – Manual
3
Source selection
Use the Source switch to select an analog input source.
Phonitor Matrix settings
With the Matrix switch you can activate the Phonitor Matrix
– with the Center function (All) or without (Cr/A). In the O
position, the Phonitor Matrix is deactivated.
The Phonitor Matrix creates a speaker-like listening experience on headphones, by mixing
the le and right signals, each delayed (interaural time dierence) and attenuated (inter-
aural level dierence), to the corresponding opposite side.
Crossfeed
With the Crossfeed switch you can adjust the interaural level
dierence. The level dierence is comparable to the influence
of dierent room sizes and their reflection and absorption
characteristics. The interaural level dierence is frequency-cor-
rected because the sound is reflected and absorbed by the
head in a non-linear fashion.
Angle
With the Angle switch you adjust the interaural time dierence
which is related to the placement of the speakers. The inter-
aural time dierence is frequency-corrected because the sound
is reflected and absorbed by the head in a non-linear fashion.
EN
DE


Produktspezifikationen

Marke: SPL
Kategorie: Nicht kategorisiert
Modell: Phonitor 3

Brauchst du Hilfe?

Wenn Sie Hilfe mit SPL Phonitor 3 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert SPL

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-