SKS Com/Pad Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für SKS Com/Pad (4 Seiten) in der Kategorie Nicht kategorisiert. Dieser Bedienungsanleitung war für 37 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/4
GERMANY
5
6
6
2
1
1
T6
3
T6
max. 0,15Nm
4
Wärmequelle/Heat source
MANUAL PAD 11756¬ COM/ ¬ ALLROAD ROAD MOUNTAIN
1. Prepare the COMPIT for the COM/PAD
All COMPIT versions (except COMPIT/ANYWHERE)
1. Loosen and remove the levelling screws on both sides
2. Remove the docking station
4. Insert the sealing ring again. Attach the connection plate with the cable and
4. secure it with screws. Do not exceed the 0.15 Nm tightening torque of the
screws.
5. Insert the docking station between the retaining clamps.
6. Insert the levelling screws and tighten them slightly. Adjust the angle of the
docking station. Tighten the levelling screws.
3-4. Loosen and remove the screws (T6). Remove and discard the dummy cover.
2. Connect the COMPIT to the e-bike
For e-bikes with a 12 V-36 V lighting system or power supply
Route the COMPIT connection cable to the motor, ensuring that the cable is
routedcleanlyalongthecableroutingspecictothebicyclemodel.
Connect the COMPIT connection cable to the cable of the lighting system with
waterproof terminals at a suitable point. Alternatively, solder connections can also
be used. Motor (connection cable is not supplied)
GERMANY
9V-36V 9V-36V
9V-36V 9V-36V
9V-36V 9V-36V
9V-36V 9V-36V
T6
max. 0,15Nm
MANUAL PAD 11756¬ COM/ ¬ ALLROAD ROAD MOUNTAIN
BOSCH Gen. 2,3 und 4
Active Line/Performance Line/CX
Front light connection
Yamaha PB-X
Front light connection 12 V
BOSCH Gen. 4
Light connection or 12 V aux.
BAFANG M620
7015-BS-2 12V / 12W
Fazua
JST VSLE 03R connector / 12 V
Shimano / screw terminals
Light connection 12 V
Brose S
Front light connection 12 V
Panasonic
Light connection max. 36 V
3. Attach the COM/PAD
Place the COM/PAD on the COMPIT and turn it (about 45°) either to the right or left
above the docking station until you hear it click into place.
OPTIONAL!
Screw in the anti-theft lock screw as far as it will go.
GERMANY
ON OFF
USB C-PD OFF USB C-PD ON
ON/OFF
Touch 2 sec.
ON
Touch 2 sec.
MANUAL PAD 11756¬ COM/ ¬ ALLROAD ROAD MOUNTAIN
4. Activate the COM/PAD
Switch on the e-bike
5. Charge the mobile device wirelessly
1 Switch on the COM/PAD. LED indicator lights up blue
2 Attach the mobile device and lock it by turning it
3MobiledeviceischargedandLEDindicatorashesblue.


Produktspezifikationen

Marke: SKS
Kategorie: Nicht kategorisiert
Modell: Com/Pad

Brauchst du Hilfe?

Wenn Sie Hilfe mit SKS Com/Pad benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Nicht kategorisiert SKS

Bedienungsanleitung Nicht kategorisiert

Neueste Bedienungsanleitung für -Kategorien-