Ricatech RTT33 Bedienungsanleitung


Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für Ricatech RTT33 (13 Seiten) in der Kategorie Plattenspieler. Dieser Bedienungsanleitung war für 12 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/13
IMPORTANT SAFEGUARDS FOR AUDIO PRODUCTS
PLEASE READ CAREFULLY THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE
APPLICABLE TO YOUR EQUIPMENT.
1. All the safety and operating instructions should be read before the Read Instructions -
appliance is operated.
2. The safety and operating instructions should be retained for future Retain Instructions -
reference.
3. All warnings on the appliance and in the operating instructions should Heed Warnings - be
adhered to.
4. All operating and use instructions should be Follow Instructions -
followed.
5. The appliance should not be used Water and Moisture -
near water-for example, near a bathtub,washbowl,kitchen
sink,laundry tub, in a wet basement, or near a swimming
pooland the like.
6. Carts and Stands - The appliance should be used only with a
cart or stan that is recommendedby the manufacturer.
6A.An appliance and cart combination should be moved with care. Quick stops, excessive force, and
uneven surfaces may cause the appliance and cart combination to overturn.
7. Wall or Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as
recommended by the manufacturer.
8. Ventilation - The appliance should be situated so that its location or position does not
interfere with-its proper ventilation.For example, the appliance should not be situated on a bed,
sofa, rug,or similar surface that may block the ventilation penings; or, placed in a built -in
installation, such as a bookcase or cabinet that may impede the flow of air through the
ventilation openings.
9. Heat - The appliance should be situated away from heat sources such as radiators, heat
registers, stoves,or other appliances (including amplifiers) that produce heat.
10.Power Sources - The appliance should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
11.Grounding or Polarization - Precautions should be taken so that the grounding or
polarization means of an appliance is not impeded.
12.Power - Cord Protection - Power-supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them, paying particular attention to cords
at plugs, and the point where they exit from the appliance.
13.Cleaning - The appliance should be cleaned only as recommended by the manufacturer.
14.This product is designed for use with the antenna attached and should not be connected to any
other external antennas.
15.Non-use Periods - The power cord of the appliance should be unplugged from the outlet when
left unused for a long period of time.
16.Object and Liquid Entry - Care should be taken so objects do not fall and liquids are not
spilled into the enclosure through openings
17.Damage Requiring Service - The appliance should be serviced by qualified service personnel
when:
The power-supply cord of the plug has been damaged;or A.
Objects have fallen, or liquid has been spilled into the appliance;or B.
The appliance has been exposed to rain;or C.
The appliance does not appear to operate normally or exhibits a marked change D.
inperformance; or
E.The appliance has been dropped, or the enclosure damaged.
18.Servicing - The user should not attempt to service the appliance beyond that described in the
operating instructions. All other servicing should be referred to qualified service personnel.
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting flash with
arrowhead symbol, within an
equilateral triangle, is intended
to alert user to the presence of
uninsulated "dangerous voltage"
within the product's enclosure
that may be of sufficient
magnitude to constitute risk of
electric shock to persons.
CAUTION: TO REDUCE THE RISK
OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO
USER SERVICEABLE PARTS –
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK DO
NOT OPEN
The exclamation point within an
equilateral triangle is intended to
alert user to the presence of
important operating and
maintenance (servicing)
instruction in the literature
accompanying the appliance.
SPECIFICATION
Power Source : DC 12V 1.2A via AC Adaptor (included)
Speaker : 28 x 40mm 8ohm 2W x 2
Three Speed : 33 1/3, 45, 78 rpm
*DESIGN AND SPECIFICATION SUBJECT TO CHANGE WITHOUT NOTICE.
CONTROL LOCATORS
POWER SOURCE
Unwind the power adaptor (Located in a white box inside the packaging foam). First connect the small end of
the adaptor to the back of the turntable, then the other end to an AC power outlet.
UNPACKING THE TURNTABLE
1. Remove packing materials from unit.(Note: Save all packing materials.)
2. Carefully remove unit from its styro-foam and take it out of the plastic bag.
3. Although records can be played with the lid attached and opened, it is recommended
this is removed.
4. Remove the white protective needle cover by gently pulling towards front of unit.
TURNTABLE OPERATION
1. Turn the unit on by rotating the ON-OFF VOLUME SWITCH located on the front panel to the ON position.
2.
Release TONE ARM from the ARM LOCK and place it on the ARM REST.
Important: The ARM LOCK is taller than the turntable and needs to be folded down to allow larger
records to be played.
3 Set the SPEED CONTROL SWITCH to desire speed (33 1/3,45 or 78 rpm). Place the record on the
turntable.
4. Lift the TONE ARM by hand to the record and slowly lower it to the desired starting point. The turntable
will start to turn automatically. At the end of the record, the turntable will still turn. You must return the
TONE ARM to the ARM REST manually.
5. -adjust the ON-OFF VOLUME SWITCH to the desired level. Re
: After use and before closing the cover, always place the TONE ARM back on the ARM LOCK NOTE
after this has been pushed upwards again.
ACCESSORY: Adaptor for 45 rpm record
To play the 45 rpm record, place the ADAPTOR on the SPINDLE.
1. Place the 45 RPM adaptor over the spindle.
2. Gently place your 45 RPM record onto the turntable.
3. Follow the steps under turntable operation to play your record.
NEEDLE INSTALLATION
REMOVING NEEDLE:
1. Gently pull down the tip of the cartridge.
2. Pull cartridge forward.
3. Pull out and remove.
INSTALLING CARTRIDGE:
After following ―Remove instructions‖ above, follow steps 1 to 4.
1. Position red cartridge with sapphire stylus facing down.
2. Line up the tab on the back of the needle with the tone arm (as shown in picture 1 below).
3. Insert the cartridge with its front end at a downward angle (as shown in picture 2 below).
4. Lift front end of needle upward until it snaps into place.
ADDITIONAL INFORMATION:
• The red cartridge has a very small sapphire stylus that is barely visible.Take note the replacement needle
you are receiving is the same as the needle already on the tonearm.
• This needle is safe for 33 1/3, 45 & 78 speed records.
• Replacing the needle depends on how often you use your turntable.
• This sapphire stylus will provide an average of 1000 hours playing time.
LINE OUT OUTPUTS
1. Connect the auxiliary cables(not supplied) to the LINE OUT JACK and to the auxiliary inputs on the
desired component.
2. Plug Auxiliary cable into the LINE OUT JACK on the back of your unit.
3. Plug the other end of the Auxililary cable into the input jack on your desired external component.
4. Check the volume level of your external component.
5. See operators manual for correct operation of the external component.
SUBWOOFER OUTPUT JACK
The subwoofer output jack enables you to attach a subwoofer (not supplied) which will enhance bass
response. Please contact your retailer for suitable subwoofer models.
TROUBLESHOOTING GUIDE
THERE IS NO POWER
- The AC adaptor is not connected to either a power outlet or unit.
- The unit is not turned ON : Rotate the ON-OFF SWITCH from the OFF position.
TURNTABLE WILL NOT WORK
- The white protective needle cover was not removed.
- Adjust the VOLUME CONTROL knob.
- The volume is not turned up.


Produktspezifikationen

Marke: Ricatech
Kategorie: Plattenspieler
Modell: RTT33

Brauchst du Hilfe?

Wenn Sie Hilfe mit Ricatech RTT33 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Plattenspieler Ricatech

Bedienungsanleitung Plattenspieler

Neueste Bedienungsanleitung für -Kategorien-