POLARIS PB4-60 Bedienungsanleitung

POLARIS pomp PB4-60

Lesen Sie kostenlos die 📖 deutsche Bedienungsanleitung für POLARIS PB4-60 (40 Seiten) in der Kategorie pomp. Dieser Bedienungsanleitung war für 7 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/40
FOR YOUR SAFETY - This product must be installed and serviced by a contractor who is licensed and qualiîš¿ed
in pool equipment by the jurisdiction in which the product will be installed, where such state or local requirements
exist. In the event no such state or local requirement exists, the maintainer must be a professional with sufîš¿cient
experience in pool equipment installation and maintenance, so that all of the instructions in this manual can be
followed exactly. Improper installation and/or operation can create dangerous electrical hazards, which can cause
high voltages to run through the electrical system. Before installing this product, read and follow all warning
notices and instructions that accompany this product. Failure to follow warning notices and instructions may result
in property damage, personal injury, or death. Improper installation and/or operation will void the warranty.
If these instructions are not followed exactly, a îš¿re or explosion may result, causing property damage, personal
injury, or death.
ATTENTION INSTALLER: This manual contains important information about the installation,
operation and safe use of this product. This information should be given to the owner/operator of
this equipment.
WARNING
H0344400 REVD
Pressure Cleaner
Booster Pump
Installation and
Operation Manual
For Polaris PB4-60 Booster Pumps with Serial Numbers beginning with "PB"
and a manufacturing date on or after Dec 1, 2011.
ENGLISH | FRANÇAIS
Page 2 ENGLISH Polaris® PB4-60 Booster Pump | Installation and Operation Manual
Table of Contents
Section 1. IMPORTANT SAFETY INSTRUC-
TIONS 3 .............................................
1.1 Safety Instructions ............................................ 3
1.2 Pool Pump Suction Entrapment
Prevention Guidelines ....................................... 5
Section 2. General Description 6 ......................
2.1 Introduction ....................................................... 6
2.2 Description ........................................................ 6
2.3 Preparation ....................................................... 6
Section 3. Installation 6 .....................................
3.1 Electrical Installation ......................................... 6
3.1.1 Voltage Checks 6 .....................................
3.1.2 Bonding and Grounding 6 .........................
3.2 Electrical ........................................................... 6
3.2.1 Electrical Wiring 7 .....................................
3.3 Plumbing ........................................................... 7
3.3.1 Requirements ........................................ 7
3.3.2 Pipe Sizing 8 .............................................
3.3.3 Pump Location 8 .......................................
3.3.4 Install the Pump 9 .....................................
3.3.5 Installation Recommendations 9 ..............
3.3.6 Check the Water Flow 9 ...........................
3.3.7 Conduct Pressure Test .......................... 10
Section 4. Operation 10 .......................................
4.1 Start-up ............................................................. 10
Section 5. Maintenance .................................. 11
5.1 Winterizing the Pump ........................................ 11
Section 6. Troubleshooting and Repair 12 ........
6.1 Troubleshooting ................................................ 12
6.2 Service Technician Maintenance ...................... 13
6.2.1 Blocked Impeller 13 ....................................
6.2.2 Impeller Removal 13 ...................................
6.2.3 Impeller Replacement 14 ............................
6.2.4 Mechanical Seal Replacement 14 ..............
6.2.5 Motor Replacement 15 ..............................
Section 7. Product Speciîš¿cations and Techni-
cal Data 16 ..........................................
7.1 Replacement Parts List ..................................... 16
7.2 Polaris PB4-60 Booster Pump Exploded View . 16
7.3 Pump Dimensions ............................................. 17
7.4 Visual Identiîš¿cation of the New Polaris PB4-60
Booster Pump ................................................... 18
DATE OF INSTALLATION
INSTALLER INFORMATION
INITIAL PRESSURE GAUGE READING (WITH CLEAN FILTER)
PUMP MODEL HORSEPOWER
NOTES:
EQUIPMENT INFORMATION RECORD
Page 3
ENGLISH
Polaris® PB4-60 Booster Pump | Installation and Operation Manual
Section 1. IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Safety Instructions
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
To reduce the risk of injury, do not permit children to use this product.
WARNING
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide, or full
ow) valve position with the pump running.
WARNING
Zodiac® pumps are powered by a high voltage electric motor and must be installed by a licensed or certied
electrician or a qualiîš¿ed swimming pool service technician.
WARNING
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a branch circuit that is
protected by a ground-fault circuit-interrupter (GFCI). Contact a qualiîš¿ed electrician if you cannot verify that the
circuit is protected by a GFCI. Make sure such a GFCI should be provided by the installer and should be tested on
a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button.
Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts
power to the pump without the test button being pushed, a ground current is owing, indicating the possibility
of electrical shock. Do not use the pump. Disconnect the pump and have the problem corrected by a qualiîš¿ed
service representative before using.
Due to the potential risk of îš¿re, electric shock, or injuries to persons, Zodiac Pumps must be installed in
accordance with the National Electrical Code® (NEC®), all local electrical and safety codes, and the Occupational
Safety and Health Act (OSHA®). Copies of the NEC may be ordered from the National Fire Protection Association ®
(NFPA®) online at www.nfpa.org or call 617-770-3000, or contact your local government inspection agency.
WARNING
Incorrectly installed equipment may fail, causing severe injury or property damage.
WARNING
• Do not connect the system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
• Trapped air in system can cause the lter lid to be blown off, which can result in death, serious personal injury,
or property damage. Be sure all air is out of the system before operating.
WARNING


Produktspezifikationen

Marke: POLARIS
Kategorie: pomp
Modell: PB4-60

Brauchst du Hilfe?

Wenn Sie Hilfe mit POLARIS PB4-60 benötigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung pomp POLARIS

Bedienungsanleitung pomp

Neueste Bedienungsanleitung für -Kategorien-