Niles KP7 Bedienungsanleitung


Lesen Sie kostenlos die šŸ“– deutsche Bedienungsanleitung fĆ¼r Niles KP7 (7 Seiten) in der Kategorie Regler. Dieser Bedienungsanleitung war fĆ¼r 10 Personen hilfreich und wurde von 2 Benutzern mit durchschnittlich 4.5 Sternen bewertet

Seite 1/7
Thank you for including the KP7, 7 button keypad, as part of
the user interface strategy for your customer. The KP7 has been
designed to provide years of trouble free operation when wired
and installed properly. The KP7 has been designed for installation
in low humidity environments and should never be installed
outdoors or in high humidity areas.
Included in the box
t 1ea KP7 keypad
tī€ī€10ea Alternate key caps
tī€ī€ī€ī€ī€2ea Mounting screws
tī€ī€ī€ī€ī€1ea Quick Install Guide (this document)
Introduction
To install the KP7 you will need a standard 1 gang box rated
for 20 cu. in. or more.
Speciļ¬cations
Dimensions 4.12ā€ x 1.75ā€ x 1.24ā€
104.65 mmm x 44.45 mm
x 31.5 mm
Buttons 5 individually capped
2 shared for rocker capping
LED 5 individually controlled white
2 shared control white
Network 10/100/1000
Connections
LAN/PoE RJ-45
Power Requirements
PoE IEEE 802.3at,
13 W maximum draw
(@ 48V / 270 mA max.)
KP7 ā€“ Keypad
Quick Install Guide
English
Ā© 2015 Core Brands, LLC. All rights reserved.ī€‚
Core Brands,ī€‚LLC,ī€‚aī€‚Nortek company. P/N 9901364 Rev. B 02/2015
FCC and IC Information:
This Class B digital apparatus complies with Part 15 of the FCC rules and with Canadian ICES-003.
Operation is subject to the following two conditions: (1) This device may not cause interference and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
Cet appareil numƩrique de classe B est conforme aux normes canadiennes ICES-003. Son fonctionnement
est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer dā€™interfĆ©rence et (2) cet appareil
doit accepter toute interfƩrence, notamment les interfƩrences qui peuvent affecter son fonctionnement.
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Warning: Changes or modiļ¬cations to this unit not expressly approved by the party responsible
for compliance could void the userā€™s authority to operate the equipment.
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Install in accordance with the manufacturerā€™s instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus
(including ampliļ¬ers) that produce heat.
9. Only use attachments/accessories speciļ¬ed by the manufacturer.
10. Refer all servicing to qualiļ¬ ed service personnel. Servicing is required when the apparatus has been
damaged in any way such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
1The KP7 mounts in a 1 gang (US) box. It is suggested that it be placed
near light switches to reduce wall clutter. The KP7 trims with a standard
decorator-style opening wall plate (not included).
The KP7 requires a mounting depth of at least 1 Ā¾ā€ (4.5cm) and it is recommended that
a 20cu in or larger switch box or a 1 gang low voltage bracket be used. The KP7 will gang
with other low voltage devices utilizing a standard decorator-style trim plate.
The KP7 requires connection to a PoE, Power over Ethernet, switch or to an Ethernet cable
connected to a PoE injector. The KP7 cannot be locally powered.
KP7 ā€“ Overview
Planning the installation
Bezel
retention screws
Bezel
Front Back
Buttons
6 & 7
Buttons
1 - 5
KP7
MAC ID
Network Switch
PoE Injector
KP7
PoE Network Switch
Favorite 1
Favorite 2
Favorite 3
Off
Favorite 4
V
V
LAN/PoE Input
PoE requirements
fromspeciļ¬cations
Power
Requirements
PoE IEEE 802.3af,
13 W maximum draw
(@44V /350mA max)


Produktspezifikationen

Marke: Niles
Kategorie: Regler
Modell: KP7

Brauchst du Hilfe?

Wenn Sie Hilfe mit Niles KP7 benƶtigen, stellen Sie unten eine Frage und andere Benutzer werden Ihnen antworten




Bedienungsanleitung Regler Niles

Bedienungsanleitung Regler

Neueste Bedienungsanleitung fĆ¼r -Kategorien-